Uniden UH041/ - Manual - manualsarea.com

Page 2 - INCLUDED IN YOUR PACKAGE:; Please check which model you have - UH041 or UH041P.; OPTIONAL ACCESSORIES

CONTROL & INDICATORS 1 Antenna 2 PTT (Push-To-Talk) Button 3 Channel/scan up Key 4 Channel/scan down Key 5 Duplex/Transmit Hi/Lo 6 Speaker 7 Power On/Off/Select Key 8 Monitor Key 9 Volume up Key 10 Volume down Key 11 Battery Compartment Door 1 INCLUDED IN YOUR PACKAGE: Please check which model y...

Page 3 - GETTING STARTED; BATTERY INSTALLATION

Your radio uses 4 AAA ALKALINE or optional NiMH battery pack (UH041P includes NiMH battery pack) batteries for power. UH041/UHO41P GETTING STARTED To avoid damage to the unit do not mix old and new batteries. To install the batteries:1. Make sure your radio is off.2. Remove the battery compartment d...

Page 4 - LOW BATTERY ALERT; To attach the belt clip:; BELT CLIP; Do not charge alkaline or non

If the Battery level becomes low, the battery indicator icon on the LCD begins flashing.. LOW BATTERY ALERT When the batteries in the unit are low, the unit will go into a Battery Low Mode. The Transmit Mode is disabled. Replace the alkaline batteries immediately or if you are using the NiMH Battery...

Page 5 - OPERATION; VOLUME; ROGER BEEP; To turn

OPERATION 4 volume channel/ scan dup mon VOL hi/lo VOLUME Press volume or to increase or decrease the volume level. icon appears on display while volume is being adjusted. There are 8 Volume levels. Level 0 (No Audio) to Level 7 (Maximum Volume). 'VOL' POWER ON/OFF Press and hold to turn the Radio o...

Page 6 - icon is displayed

SELECTING CHANNEL Press channel or to select the desired channel. TO TRANSMIT AND RECEIVE The uses the 40 UHF-CB Channels. For your reference a list of the available channels and corresponding frequencies is printed on page 10. UH041/UHO41P 1. Before you transmit, listen for activity on the selected...

Page 7 - MONITOR

6 AUTOMATIC SQUELCH FEATURE The is equipped with an Automatic Squelch system which shuts off weak transmissions and unwanted noise. UH041/UHO41P TRANSMIT Hi/Lo SELECT ! ! ! Press and hold for 2 seconds when the unit is in Transmit Lo and it will switch to Transmit Hi. 'HI' icon will appear on displa...

Page 8 - If Channel; is pressed when the channel is

7 TO OPERATE IN DUPLEX MODE Duplex mode is only available from CH01 – CH08. Duplex mode is activated on a per channel basis and transmitting frequency on Duplex channels is CH31 – CH38. E.g., If the Repeater channel for your area is CH01, then while in Duplex mode the Transmit channel will become CH...

Page 9 - Channels 5 and 35 are used for emergency

REPLY DELAY While scanning, the stops at a busy channel and receives a transmission. When the received signal is over, the unit will wait for 2 seconds for the return of the signal, otherwise, the radio resumes scanning. POWER SAVE Your has a unique circuit designed to dramatically extend the life o...

Page 10 - VOX; still receive transmissions.

VOX KEYLOCK ON/OFF VOX 'oF' TX VOX VOX is the automatic transmitting function by inputting voice into the optional headset mic without pressing the button. Press momentarily while in CTCSS mode to enter sensitivity mode. The current selected setting will flash on the display. Press Channel or to adj...

Page 11 - UHF CHANNELS & FREQUENCIES

UHF CHANNELS & FREQUENCIES 10 476.425 476.450 476.475 476.500 476.525 476.550 476.575 476.600 476.625 476.650 476.675 476.700 476.725 476.750 476.775 476.800 476.825 476.850 476.875 476.900 Simplex Mode Transmit / Receive Frequency (MHz) NOTE: Channel 05 and 35 are Emergency Channels and channel...

Page 12 - Limited One Year Warranty; WARRANTY

UNIDEN UHF CB RADIO UH041/UH041P Limited One Year Warranty Note: Please keep your sales docket as it provides evidence of warranty. Warrantor: Elements of Warranty: Warranty Duration: Parts Covered: Procedure for obtaining performance or warranty: UNIDEN AUSTRALIA PTY LIMITED Uniden Australia Pty Li...

Uniden UH041/ - Manual

Table of Contents:

Summary

Other Uniden Models