Uniden UDWC25 - Manual - manualsarea.com

Page 2 - Important Safety Instructions!; Warnings to Parents and Other Users

Important Safety Instructions! This manual contains important information about this product’s operation. If you are installing this product for others, you must leave this manual or a copy with the end user. When using your equipment, always follow basic safety precautions to reduce the risk of fir...

Page 3 - Contents; SAVE THESE INSTRUCTIONS!

Contents Important Safety Instructions! ..................... 2 Warnings to Parents and Other Users .......................2 For best results: ....................3 Getting Started ................... 4 Connecting the Power..............4Getting to Know the Camera .4 What the lights mean .........5 ...

Page 4 - Getting Started; Connecting the Power; Power status; Getting to Know the Camera; Front view

4 Getting Started Connecting the Power Attach the antenna to the rear of the camera. Connect one end of the AC adapter to the camera’s power input pigtail and the other end to a 120 volt AC (standard indoor) power outlet. (If necessary, connect the extension cord to the camera’s pigtail and connect ...

Page 5 - What the lights mean; Light State; Using the Camera Stand; Switch the bracket

5 What the lights mean Light State What it means Power status On The camera is on. Off The camera is off. Link status Flashing The camera is in pairing mode. Orange The camera is connected to the receiver. Off The camera is in standby. Using the Camera Stand You can mount the camera with the stand o...

Page 6 - Mount the stand

6 Carefully slide the bracket off of the camera and sun shield.Rotate the bracket 180° and slide it back onto the camera.If necessary, adjust the camera angle, then tighten the bolts. Mount the stand Hold the base of the camera stand where you want to mount it, and mark the location of the screw hol...

Page 7 - Attach the camera; Adjusting the Sun Shield

7 Attach the camera Attach the camera bracket to the mounting screw. Tighten it a few turns, then turn the camera to face the direction you want.Tighten the camera brace up against the bracket to secure it into place.Unlock the mounting post by turning the wingnut to the left a few turns.Set the mou...

Page 8 - Pairing Cameras; pairing button to put the camera into pairing; No Signal

8 Pairing Cameras Before you can use the camera, you’ll to “introducing” or pair it to the receiver so they can communicate. You might also perform the pairing procedure if you are having trouble with a camera. Make sure the camera is powered on.On the receiver, select the channel you want to pair t...

Page 9 - Additional Information; Product Specifications; Radio Frequency Transceiver

9 Additional Information Product Specifications Radio Frequency Transceiver RF Frequency 2402 Mhz ~ 2483.5 Mhz Modulation GFSK Spread spectrum Frequency Hopping Anti Interference Clean Channel Dynamic Select Data rate 2 Mbps Channel bandwidth 2 MHz Transmitting range 200 meters/600 feet in an open a...

Page 10 - Recycling and Disposal Information; FCC Compliance Information; Part 15 Compliance Statement

10 Recycling and Disposal Information Do not dispose of electronic devices or any of their components (especially batteries and LCD displays) in your municipal trash collection.Consult your local waste management authority or a recycling organization like Earth911.com to find an electronics recyclin...

Page 11 - RF Exposure Information; IC Compliance Information; Radio Equipment Notice; CE Compliance Information

11 RF Exposure Information The antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm (7.9”) from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter. IC Compliance Information Radio Equipment Notice...

Uniden UDWC25 - Manual

Table of Contents:

Summary

Other Uniden Models