Uniden FP105 - Manual - manualsarea.com

Page 2 - exclamation; Introduction; dialing

When using your telephone equipment, these basic safety precautions should always befollowed to reduce the risk of fire, electrical shock, and injury to persons: 1) 2) 3) 4) 5) 3) 7) 8)9) Read and understand all instructions. Follow all warnings and instructions marked on the product.Do not use the ...

Page 3 - Serial Number; Date; of purchase

33 memory Caller ID .................................................................. 21Caller id on call waiting (CIDCW) .............................................. 2 ,New call notification .................................................................. 21 New call review ......................

Page 4 - Telephone

Base Unit Handset Curly Cord Telephone line cord and adaptor 2 x Wall mounting Memory storage screws and plugs card AC Adaptor Back-up Battery FP105 Operating guide Wall mounting bracket l Registration card l Quick start guide ! To get the most from your purchase, please read this Operating Guide th...

Page 6 - telephone and the other end into the wall outlet.

1. a. Install the battery. Use a Phillips screwdriver to remove the two screws on the batterycompartment cover. b. Remove the battery compartment cover. C. Snap the battery's contacts firmly to the battery connector, then placethe battery inside the compartment. d. Replace the cover and secure with ...

Page 7 - TOTAL CALLS 00; BACK UP BATTERY

4. Plug the AC Adaptor into a standard 230-240VAC wall outlet and switch it.Plug the AC Adaptor lead into the power socket at the back of the phone. Use only the AC adaptor supplied with this phone.Place the power cord and line cord so that they do not create a trip hazard or where they could become...

Page 10 - flash

➤ EDITING A STORED ONE-TOUCH SPEED DIAL MEMORY 1. 2.3.4.5.6.7. a. Press the store button then the speed dial memory (1-12) vou want to edit Move the cursor to the number you would like to edite by using >>Press delete then key-in the desired number using the keypad Press store (Display shows N...

Page 11 - Follow

➤ block CID Each time you make a call, your telephone number is automatically forwarded to the party you are calling (unless your number is a silent number). In certain cases you may wish to prevent your number being sent, follow these, steps. 1. 2.3. Pick up the handset or press the speaker button....

Page 12 - ID SUMMARY; call

To make use of these features, you must first subscribe to Telstra’s Caller ID Service, There is usually a fee for this service, and may not be available in all areas. ➤ 33 MEMORY CALLER ID When you use this telephone with the Caller ID service,you will see the number of the calling party (unless th...

Page 15 - CODE I CLEAR SPEED DIAL I NO CHANGES; Problem

➤ LCD CONTRAST 1. Press and hold the store button for approximately 2 seconds until the display showsLCD CONTRAST. 2. Press the >> or << buttons to adjust the display contrast to the desired viewing level. 3. Press the store button to set and move to the next menu option or cancel to sav...

Uniden FP105 - Manual

Table of Contents:

Summary

Other Uniden Models