Page 2 - INTRODUCTION; Congratulations on the purchase of your Uniden FP102 Telephone.
2 INTRODUCTION Congratulations on the purchase of your Uniden FP102 Telephone. The FP102 has been designed and engineered to exacting standards for reliability, long life and outstanding performance. To obtain the full benefit from your new telephone, please read this OperatingGuide thoroughly. For ...
Page 4 - CONTENTS; Troubleshooting
4 CONTENTS CONTENTS Receiving a Telephone Call . . . . . . . . . . . . . . . . . . . . . . . .18Accessing Call Waiting (New Zealand Model only) . . . . . . .18Accessing Call Waiting (Australian Model only) . . . . . . . . . .19Mute . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
Page 5 - IMPORTANT INFORMATION; Follow all warnings and instructions marked on the product.; IMPORT
5 IMPORTANT INFORMATION When using your telephone equipment, basic safety precautions should always befollowed to reduce the risk of fire, electrical shock, and injury to persons,including the following: 1. Read and understand all instructions. 2. Follow all warnings and instructions marked on the p...
Page 6 - CARING FOR YOUR TELEPHONE; Clean your telephone using a soft damp cloth.; CAUTION; PLEASE READ BEFORE USE AND
6 9. Unplug this product and refer servicing to qualified service personnel under the following conditions:A. If liquid has been spilled into the product.B. If the product has been exposed to rain or water.C. If the product does not operate normally when following the operating instructions. Adjust ...
Page 9 - FEATURES
9 FEATURES FEATURES • Pre-Programmed Feature Buttons Instant access to some of Telecom’s / Telstra’s most popular network service features* have been factory programmed into this telephone for your convenience.* Some of these services will require subscription. • 15 One Touch Speed Dial Buttons Your...
Page 10 - Bright red LED provides visual indication of an incoming call.; FEA
10 • Last Number Redial If the number you are dialing is engaged, simply end the call. Then pickup the handset and press the redial button. The telephone will automatically redial the last number called. • Hearing Aid Compatible Inductive transducer coil handsets provide hearing aid compatibility. •...
Page 11 - AUSTRALIAN MODELS
11 FUNCTIONS FUNCTIONS 6 3 7 2 1 4 5 AUSTRALIAN MODELS 1. Button 2. Button 3. Button 4. Button 5. Button 6. One Touch Speed Dial Buttons7. Memory Storage Card 6 3 7 2 1 4 5 NOTE: If required the Memory Storage Card can be turned over to give 20 One Touch memory buttons, as shown below NEW ZEALAND MO...
Page 12 - call
12 FUNCTIONS FUNCTIONS 8 13 9 10 15 16 17 18 19 20 21 23 8. Button 9. Button 10. Button 11. Button 12. Handset Retainer Tab13. Button 14. Telephone Number Card 15. Numeric Keypad16. call LED 14 22 17. status LED 18. Button 19. Button 20. Not used21. tone Slide Switch 22. speaker Volume Slide Switch ...
Page 13 - INSTALLATION; HANDSET CORD CONNECTION
• Never install telephone wiring during a lightning storm. • Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected. • Use caution when installing or modifying telephone lines. CAUTION 13 INSTALLATION INST ALLA TION HANDSET CORD CONNECTION Plug one end o...
Page 14 - WALL MOUNTING
INST ALLA TION INSTALLATION WALL MOUNTING You can mount your phone directly on a wall. Before mounting your phone,consider the following:• Select a location away from electrical cables, pipes or other items behind the mounting location that could cause a hazard when inserting screws into the wall. •...
Page 15 - USING; MEMORY STORAGE CARD
MEMORY DIAL NUMBERS 20 one touch speed dial numbers can be stored into the memory of your telephone. STORING ONE-TOUCH SPEED DIAL MEMORIES 1. To program One-Touch Memories ( ~ ). a. Pickup the Handset or press the button. b. Press the button. c. Enter telephone number that you want to program.d. Pre...
Page 16 - PAUSE; button counts as one digit. Pressing; DIALING STORED NUMBERS; button. The telephone will dial; CHAIN DIALING
USING YOUR FP102 USING YOUR FP102 16 PAUSE During the memory storage procedure you may enter a 4 second delay betweennumbers (for accessing a switchboard, or long distance service) by pressing the button on the Handset at the point in the number sequence you wish to pause. The button counts as one d...
Page 17 - ADJUSTING THE SPEAKERPHONE VOLUME CONTROL; During a SpeakerPhone conversation, adjust the; volume of your; speaker; slide control until you hear the desired volume.; ADJUSTING THE RINGER VOLUME CONTROL; slide control to the desired position.
ADJUSTING THE SPEAKERPHONE VOLUME CONTROL During a SpeakerPhone conversation, adjust the speaker volume of your telephone by moving the speaker slide control until you hear the desired volume. NOTE: When the telephone is switched to Speakerphone Mode, the status LED turns green. 17 USING YOUR FP102 ...
Page 18 - LED indicators
18 USING YOUR FP102 USING YOUR FP102 LED indicators 1. call LED indicator: Red light which flashes when the telephone is ringing. This is sometimes referred to as a ‘Visual Ringing Indicator’. 2. status LED indicator: a. Solid red light when ‘In Use’.b. Solid green light when in Speakerphone mode.c....
Page 20 - Call Minder
20 USING YOUR FP102 USING YOUR FP102 USING THE PRE-PROGRAMMED FEATURE BUTTONS (New Zealand Model only) Instant access to some of Telecom’s most popular network service features havebeen factory programmed into this telephone for your convenience. Call Minder Telecom’s Call Minder Message Centre is a...
Page 21 - Example
21 USING YOUR FP102 USING YOUR FP102 Pick up the handset or press the button. Listen for the dial tone then press the button. The telephone will automatically dial the access code ‘161’ and will enable ‘immediate call diversion’ to the number you have assigned the divert to. Wait forthe ‘confirmatio...
Page 22 - Call Back; button and then the
Pick up the handset or press the button, then press the button and dial the number you wish to call. Call Back When the party you are calling is engaged or doesn’t answer, hang up.Pick up the handset or press the button and then the button. The telephone will automatically dial the access code ‘*51’...
Page 23 - Block CID
USING YOUR FP102 USING YOUR FP102 USING THE PRE-PROGRAMMED FEATURE BUTTONS (Australian Model Only) Instant access to some of Telstra’s most popular network service features havebeen factory programmed into this telephone for your convenience. Block CID Each time you make a call, your telephone numbe...
Page 24 - Divert Off; Message Bank
USING YOUR FP102 USING YOUR FP102 Divert Off To cancel ‘Call Forward No Answer’ to another number.Pick up the handset or press the button. Press the button and then hang up. The telephone will automatically dial the access code‘#61#’ and will cancel the diversion. Call Return Telstra’s ‘Call Return’...
Page 25 - If you live outside the Sydney area, you will need to re-program the; Brisbane
25 If you live outside the Sydney area, you will need to re-program the button as follows; Brisbane : Pick up the handset, then press Melbourne : Pick up the handset, then press Adelaide : Pick up the handset, then press Perth : Pick up the handset, then press Telstra is a registered trademark of Te...
Page 27 - TROUBLESHOOTING
TROUBLESHOOTING Problem Can’t make or receive calls. Can’t hear the telephone ringing. Speakerphone Volume too low. One Touch Speed Dial Numbers are not working correctly.Handset does not hang up in the wall mountposition. Suggestion • Make sure you use only the line cord supplied with this telephon...
Page 28 - Specifications for New Zealand Model; Specifications for Australian Model; Compliance; SPECIFICATIONS
28 Specifications for New Zealand Model Compliance PTC200 Size: 150mm(W) x 225mm(D) x 70mm(H) Weight: Approx. 536g Specifications, Features and availability of Optional Accessories shown are typicaland subject to change without notice. NOTE: FOR USE OF THIS DEVICE IN NEW ZEALAND 1. The grant of a Te...
Page 29 - One-Year Limited Warranty
WARRANTY W ARRANTY One-Year Limited Warranty Important: Evidence of original purchase is required for warranty service. WARRANTOR: Uniden Australia Pty Limited ACN 001 865 498 Uniden New Zealand Limited ELEMENTS OF WARRANTY : Uniden warrants to the original retail owner for the duration of this warr...
Page 30 - THANK YOU; FOR
UNIDEN © 1998 Uniden Australia Pty Limited © 1998 Uniden New Zealand Limited THANK YOU FOR PURCHASING A UNIDEN PHONE! FP102-OM.qxd 7/12/98 09:28 Page 30
