Uniden 880 - Manual

7 17 18 19 20 21 22 17. Antenna socket: Connects antenna to the unit. 18. PA SP : Connects optional external 8-ohm, 4-watt speaker for use as a public address system. To prevent acoustic feedback, separate the microphone from the speaker when operating the PA at high output levels. 19. EXT. SP : Con...

9 or other convenient point. Then connect the black power cord to the vehicle chassis or negative (-) battery terminal. install 6-pin to 4-pin aDapter The Bearcat 880 is pre-configured for Uniden’s new 6-pin wireless, noise- cancelling technology, available in 2012. Your Bearcat 880 comes with an ad...

10 5. Turn RF Gain to set RF gain sensitivity. 6. Press MIC Gain to toggle microphone sensitivity between High and Low. (LED on = High; LED off = Low) 7. Set Backlight color (see page 12). 8. Set LCD Contrast (see page 13). 9. Set Brightness (see page 13). all Channel sCan When All Channel Scan is o...

11 Set Weather Scan Mode Weather Scan mode allows the radio to move to the next weather channel if no signal is detected after 3 seconds. Set Weather Scan mode to ON or OFF through the menus.1. Press MENU/OK to activate the menus. COLOR displays. 2. Turn the Channel Selector knob to cycle through th...

12 Scan Channels in Memory 1. From All Channel Scan mode (see page 10), press MEM/SCAN until MEM SCAN displays; the radio scans memory channels only. 2. Press MEM/SCAN again to return to MEMORY mode or the last channel scanned. Listen to Channels in Memory 1. Press MEM/SCAN until MEM displays. 2. Tu...

15 EXIT Menu Exit the menus from the main menu levels (COLOR, CONT, BRIGHT, WXSCAN, and DIAG). From this level, turn Channel Selector until EXIT displays. Press MENU/OK . The radio returns to the last operating mode and channel. other FeatUres S/RF/CAL/SWR Meter You can check your incoming and outgo...

16 4. Be sure all screws and mounting hardware are tight. maintenanCe The Bearcat 880 is designed to give you years of trouble-free service. There are no user-serviceable parts inside. Except for the fuse in the DC power cord, no maintenance is required. To replace a blown fuse: 1. Press ends of the...

17 Problem Suggestion Using MEM/SCAN does not access channels in memory Verify that there are channels saved into memory. Unit does not work as well as previously. Turn the power off then back on. The channels will reset. Battery power check returned FAILLO or FAILHI . Make sure your power wires hav...

19 PUBLIC ADDRESS Output Power at 10% Distortion: 4 watts Specifications shown are typical and subject to change without notice. tWo-year eXtenDeD Warranty Important: Evidence of original purchase is required for warranty service. Warrantor: UNIDEN AMERICA CORPORATION (“Uniden”) elements oF Warranty...

20 proCeDUre For oBtaining perFormanCe oF Warranty: If, after following the instructions in the owner’s manual you are certain that the Product is defective, pack the Product carefully (preferably in its original packaging). The Product should include all parts and accessories originally packaged wi...