Ultra Start MCS-100 - Manual

Ultra Start MCS-100

Ultra Start MCS-100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
Page: / 8

Table of Contents:

  • Page 2 – SECTION 1: SYSTEM LAYOUT; Diagram #1: Tilt Switch or External Sensor Connection; Red; Optional Tilt Switch; Green; Optional Shock Sensor; Brown
  • Page 3 – of the Starter wire.; Orange; us; Positive Controlled Parking Lights; Parking; Negative Controlled Parking Lights; White
  • Page 4 – SECTION 3: SYSTEM OPERATION; switch is turned on.; SECTION 4: PROGRAMMABLE FEATURES
  • Page 5 – Shock Sensor Disable; Note: Module will accept three different transmitters.; One Time Soft Chirp
  • Page 6 – Emergency Disarm; cancelled automatically.
  • Page 7 – Siren Output Tone Selection; Shock Sensitivity Level Selection; Each tone is
  • Page 8 – Turn the ignition key to the on position.; SECTION 5: TRANSMITTER BATTERY REPLACEMENT INSTRUCTIONS; Remove the screw from the back of the transmitter.; Turn Ignition
Loading the manual

Installation Manual







!

!

"

#$ %

MCS-100 Remote Control Motorcycle Alarm

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - SECTION 1: SYSTEM LAYOUT; Diagram #1: Tilt Switch or External Sensor Connection; Red; Optional Tilt Switch; Green; Optional Shock Sensor; Brown

MCS-100 2 Version A SECTION 1: SYSTEM LAYOUT SECTION 2: SYSTEM CONNECTION Diagram #1: Tilt Switch or External Sensor Connection You can connect any external trigger devices. Make sure negative trigger output of external device is connected to Negative Trigger Input Wire (Green #4). Diagram #2: LED C...

Page 3 - of the Starter wire.; Orange; us; Positive Controlled Parking Lights; Parking; Negative Controlled Parking Lights; White

MCS-100 3 Version A 2. Use 30/40 Amp SPDT relay to connect as shown. Connect the Starter Interrupt output (Orange) wire to pin 86 of the relay. Connect pin 30 of the relay to the Motor side of the Starter wire. Connect pin 87a of the relay to the switch side of the Starter wire. 3. Locate the Igniti...

Page 4 - SECTION 3: SYSTEM OPERATION; switch is turned on.; SECTION 4: PROGRAMMABLE FEATURES

MCS-100 4 Version A SECTION 3: SYSTEM OPERATION The MCS-100 is very sophisticated, but the operation is simple. Your two button RF transmitter is easy to use for arm, disarm, personal protection, and programming the system for many custom functions. 3.1 Remote System Arm (On) Press and release RF tr...

Other Ultra Start Models

All Ultra Start Other