Ultra Start 3250M - Manual

Ultra Start 3250M – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

Page 2 – DIAGNOSTICS; Ac; RED; Jumpers; Note: The default setting is Second Ignition.; Starter; Jumper Selectable; Power
Page 3 – PI; IE
Page 6 – Your Basic Installation is Now Complete!!; Step 3- Auto Tach Lear n
Page 8 – See setting 4 for door unlock and disarm output durations.; PROGRAM MODE 1 - USER SETTINGS
Page 10 – Times if programmed for Safety Start; Transmitter Operation; Lift; Slide; PROGRAM MODE 4 - TACH SETTINGS; One time; Step 1 - Enter Program Mode; times; times; Step 5 - Release Program - Exit Program Mode then remote start to test.
Page 12 – Negative Type Door Locks

Loading the manual

Advanced 2-Way

Remote Vehicle Starter

AUTOMATIC AND MANUAL

TRANSMISSION MODELS

INSTALLATION GUIDE

FCC/ID Notice

This device complies with Part 15 of the FCC rules. Operation is subject to the
following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by the part
responsible for compliance void the user’s authority to operate this devise.

TECH SUPPORT

Western Canada 1 800 279-0636
United States: 1 866 698-5872
Eastern Canada Bilingual: 1 800 268-0683
E-Mail Tech Support: [email protected]
Check Our Web Site: www.ultrastarters.com

WWW.ULTRASTARTERS.COM

See website for a full size printable version of this manual.

3250

3250M

3250

3250M

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - DIAGNOSTICS; Ac; RED; Jumpers; Note: The default setting is Second Ignition.; Starter; Jumper Selectable; Power

3250 Wiring Diagram Page 3 Pre-Installation Page 4 ComponentsPre Installation CheckInstallation Procedure Wire Connectors Page 5 6 Pin Connector14 Pin Connector4 Pin Red Connector2 Pin White Connector Jumper Selection Installation Page 6 Basic Installation - Quick startAuto Tach Learn Programming Pa...

Page 3 - PI; IE

Page 6 - Your Basic Installation is Now Complete!!; Step 3- Auto Tach Lear n

Program mode allows you to adjust the settings and options of your system. Your system has been intelligently designed by installers with years of experience. The system’s default settings do not require any program changes in most cases. However, this system does incorporate a highly advanced progr...