Ultra Start 26XX Series - Manual
Ultra Start 26XX Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Table of Contents; INSTALLATION MANUAL; REMOTE VEHICLE STARTER/ALARM; Quick Learn
- Page 4 – Recommended Installation Procedures; Under Hood Connections -; BE CAREFUL; Mounting The Control Module -; Never; Installing the External Long Range Antenna -; BLUE; Security
- Page 5 – Wiring Diagra m
- Page 6 – Side View; Blue; Pink; Jumper Selections - Back View; Jumper Access; 0amp relayed output; . To change the output of the wire access the jumpers by; nd Starter; If the jumper is in position #2 the output on the white wire will be; nd Accessory; If the jumper is in position #3 the output on the white wire will be; nd Ignition
- Page 7 – Description; Selectable output for 2nd Ign, acc or starter.; Function; Programmable output. See Menu 3; White; Continued on next page.; Pin Power Connector
- Page 8 – 4 Pin Connector; Continued From Previous Page; Pin Connector Red
- Page 9 – Step 1 - Connect All Of the Following Wires; 2volts during start position only.
- Page 10 – OFF
- Page 11 – Manual Transmission “M” Models; all; The starter wire travels form the key switch through the; Type 3 - Connect Switch; Install a relay to connect the two wires at the switch when the; Type 4 - Disconnect Switch; Install a relay to disconnect one of the wires at the clutch
- Page 12 – Auto Tach Learn; Your Basic Install Is Complete!; park lights are flashing a diagnostic code. See diagnostic chart.
- Page 13 – Impor tant Tach Notes; Quick lear n Tach; BRAKE; Press and hold the brake pedal.
- Page 14 – Entering Program Mode; Press and release; Program Menus
- Page 15 – Quick View Progr amming; System Reset; ON; System is now reset to factory defaults; does not
- Page 16 – Menu 1- User Settings
- Page 17 – continued from previous page; Setting 5 Active/Passive Locks; No auto-lock with passive arming; Flashes/Chirps Doors Lock when passive arming; to proceed to the next step.
- Page 18 – Menu 2 - Additional Settings
- Page 19 – Menu 3- Starter Settings
- Page 20 – Menu 4- Tach Settings; Setting 1 Auto Tach Learn.; will chirp twice to confirm that a tach signal has been learned.
- Page 21 – Transmitter Programming
- Page 22 – Negative Type Door Locks 250ma; When installing relays always use a fused power source.
- Page 23 – DIAGNOSTICS; Wire / Reverse Polarity Type Door Locks
- Page 24 – DIAGNOSTIC MEMORY; Maximum four events, four chirps
Covers All 25xx and 26xx Series Remote Starter/ Alarms
-The system must be placed into Service Mode before any service work is started on the
vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The
manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
- The Hood Pin Safety Switch Must Always be Installed!
REMOTE STARTERS
ü
CAR ALARMS
INSTALL GUIDE
Technical Suppor t 866-698-5872 ext 0
Suppor t@ultrastar ters.com
WWW.ULTRASTARTERS.COM
Version.02
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Table of Contents INSTALLATION MANUAL REMOTE VEHICLE STARTER/ALARM Page 2 Pre-Installation Page 3 ComponentsFeature ListPre-Installation Installation Procedures Page 4 Wiring Diagrams Page 5-7 Wire Description Page 8-9 6 Pin Connector14 Pin ConnectorAuxiliary OutputsOptional ConnectorsJumper Positio...
Recommended Installation Procedures Under Hood Connections - Route the hood pin and tach wire through the firewall into the engine compartment. If possible route the wires through a factory rubbergrommet. If drilling a hole through the firewall, BE CAREFUL . Always check for obstructions on both sid...
REMOTE VEHICLE STARTER/ALARM INSTALLATION MANUAL Page 5 Wiring Diagra m 1 3 5 2 4 6 2 1 4 3 6 5 7 8 10 10 10 9 12 12 11 11 14 13 13 4 PIN BLUE 30 AMP STARTER DISABLE RELAY- NORMALLY CONNECTED Blue Green Red Red Yellow White /Green White /Blue Red Starter Heater Main Power Ignition 1 Selectable Main ...
