Ultra Start 1350 - Manual
Ultra Start 1350 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Jumper Selectable; RED; IE; TABLE OF CONTENTS; DIAGNOSTICS; Jumpers
- Page 4 – INSTALLATION TIPS; Under Hood Connections -
- Page 6 – QUICK START INSTALL; Your Basic Installation is Now Complete!!; PROGRAMMING; User Settings - Page 8
- Page 8 – See setting 4 for door unlock and disarm output durations.; Yellow Wire on 14-Pin; Setting 7- Safety Start Mode
- Page 10 – OPERATIONS; Replace with quality23A 12volt Alkaline battery.; One time; times; times
- Page 12 – Negative Type Door Locks; RELAY DIAGRAMS
WWW.ULTRASTARTERS.COM
1350
1350
1350m
1350m
INSTALLATION GUIDE
Advanced Remote Vehicle
Starting System
AUTOMATIC AND MANUAL
TRANSMISSION MODELS
FCC/ID Notice
ATTENTION
This device complies with Part 15 of the FCC rules. Operation is
subject to the following conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modifications not expressly approved by
the part responsible for compliance void the user’s authority to
operate this devise.
!
-The system must be placed into Service Mode before any service work is started on
the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.
The manufacturer accepts no liability or responsibility for accidental starting of the
vehicle.
- CARBON MONOXIDE - Never Start In A Enclosed Building (Garage, Carport etc...)
- The Hood Pin Safety Switch Must Always Be Installed!
- Never Install Automatic Transmission Remote Starters On Manual Transmission
Vehicles!
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installation Guide Installation Guide 1350 Wiring Diagram Page 3 Pre-Installation Page 4 Components Pre Installation Check Installation Procedures Wire Connectors Page 5 6 Pin Connector11 Pin Connector5 Pin Connector4 Pin ConnectorJumper Positions Installation Page 6 Basic Installation - Quick start...
Installation Guide Installation Guide Recommended Pre-Installation Procedures - Control module - Remote transmitter(s) - Antenna with built in Program Button and LED’s - 6 pin main harness with dual 30amp power inputs. - 11 pin harness - 5 pin harness - 3 pin keyless entry harness - Hood pin safety ...
Installation Guide Installation Guide QUICK START INSTALL Yellow Starter Output Connect To The Vehicles Starter Wire. Green Heater Output Connect To The Vehicles Accessory Wire. Red 12 power Input Connect To Constant 12 Volt Power Source - High Current. Red 12 power Input Connect To Constant 12 Volt...
