Tyco P700WLS - Manual - manualsarea.com

Page 3 - Installation Manual; P700WLS ioProx Receiver; Table of Contents; Inventory 1

Installation Manual P700WLS ioProx Receiver DN1628-0806 Table of Contents System Overview ....................................................................................................... 1 Inventory 1 Technical Specifications ......................................................................

Page 5 - System Overview; Inventory; enclosure fastening screws

Installation Manual P700WLS ioProx Receiver DN1628-0806 1 System Overview The P700WLS ioProx receiver unit is designed to interface with an access control panel card reader port using the Wiegand protocol or the Kantech eXtended Secure Format (XSF). The ioProx receiver can read from a distance of up...

Page 6 - Technical Specifications

Installation Manual P700WLS ioProx Receiver DN1628-0806 2 Technical Specifications P700WLS ioProx Receiver P72WLS/P74WLS Transmitters Power: 12-24 VDC Power: CR2032 3V lithium battery, included (3 year average lifetime) Current: 50mA (stand-by) 100mA (peak) Operating temperature: 0°C to 70°C (32°F t...

Page 7 - Installing the P700WLS ioProx Receiver; Global Coverage; twisted pairs, unshielded cables

Installation Manual P700WLS ioProx Receiver DN1628-0806 3 Installing the P700WLS ioProx Receiver Global Coverage When global coverage of a large area is required, there should be a sufficient number of receivers to give overlapping coverage of receiving patterns. Use the SW terminals if the receiver...

Page 8 - Connect 22 to 14 AWG wires to the blue terminal block.; Figure 1 Terminal Block Location

Installation Manual P700WLS ioProx Receiver DN1628-0806 4 Data Path Selector Settings The receiver unit provides for field selectable pins JP2 located near the center of the board (Figure 1) Receiver Terminal Block Location The receiver terminal block is removable. (Refer Figure 1) It can be mounted...

Page 9 - Format; Button 1

Installation Manual P700WLS ioProx Receiver DN1628-0806 5 S1 Receiver Configuration Placing the DIP switches in the ON or OFF position determines which specific button on the multi-button transmitter will activate the receiver and Wiegand format to be transmitted to the control panel. (See Table 1 b...

Page 11 - PCB LED Indicators; All; LEDs are located on the PC board, inside the box.; Figure 3 LEDs Location; Flashes when the transmitter code is valid.; LED Location

Installation Manual P700WLS ioProx Receiver DN1628-0806 7 Testing the Receivers PCB LED Indicators All LEDs are located on the PC board, inside the box. Figure 3 LEDs Location Y4: Flashes if the transmitter encryption code does not match the receiver configuration, and will not operate the receiver....

Page 12 - Receiver Relay; Receiver Mounting Location; Figure 4 Wall and Ceiling Mounted Receivers

Installation Manual P700WLS ioProx Receiver DN1628-0806 8 Receiver Relay The receiver relay activates for one second when a valid button on the transmitter triggers the receiver. The relay on the receiver can be used for testing purposes by adding an audible or visual device to confirm the receiver ...

Page 13 - Testing the Transmitters; Operating Instructions; Release and press the button again to send; Troubleshooting; Replacing the Transmitter Battery; Flat edge tool or screwdriver; DO NOT install the battery backwards. It will damage the device.

Installation Manual P700WLS ioProx Receiver DN1628-0806 9 Testing the Transmitters Operating Instructions The following instructions can be used for both models (2 or 4 buttons) 1. On the key tag transmitter, press for one (1) second the button you programmed earlier to activate the receiver. A red ...

Tyco P700WLS - Manual

Table of Contents:

Summary

Other Tyco Models