Tyco 9800 - Manual

Tyco 9800

Tyco 9800 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
Page: / 11

Table of Contents:

  • Page 2 – Do not use earlier versions of Frostex; Also make sure you; Table des matières; N’employez pas les versions; Wire cutters; ENGLISH
  • Page 4 – Collect the necessary information.
  • Page 6 – The end seal can only be used once, so do not install it until step 2D.; Heating Cable Construction; Clear plastic; Prepare the heating cable.; Cleanly cut off one end of the heating cable.; Remove the plastic wrap.; in
  • Page 7 – The clear plastic wrap does not need to be removed.; Complete the connection.; Install the cover by tightening the screws completely.
  • Page 8 – Prepare to install the heating cable.; The ground-fault unit and plug must be kept dry.; Install the heating cable.; • Provide extra heat at valves and spigots by wrapping each; end seal is well above the ground level and; End seal
  • Page 10 – Periodic Inspections; Each month; Troubleshooting; Problem: The signal light does not light up.
  • Page 11 – Limited Warranty
Loading the manual

Installation Instructions and User Guide
for the Frostex Pipe Freeze Protection System
Using the 9800 FlexFit Plug Kit

Directives d’installation et Guide de l’Utilisateur
du Système Frostex de Protection Anti-gel des
Tuyaux Utilisé avec le Kit Frostex 9800 FlexFit

Keep pipes from freezing
Protection anti-gel des tuyaux

60J9 Residential
and Mobile Home
Pipe Heating Cable

®

F M

APPROVED

R

LISTED

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Do not use earlier versions of Frostex; Also make sure you; Table des matières; N’employez pas les versions; Wire cutters; ENGLISH

Contents Five Important Safety Warnings 1 General Instructions 2 Installation Instructions 2 Periodic Inspections 8 Troubleshooting 8 Limited Warranty 9 Before You Begin Make sure your 9800 FlexFit Plug Kit is complete. It should contain: 1 9800 FlexFit plug1 Push-on end seal2 Orange warning labels ...

Page 4 - Collect the necessary information.

General Instructions • Observe the safety warnings on page 1. Follow the installation steps (pages 2–7) in the exact order given. • To ensure the plug is properly connected, do not assemble at temperatures below 0°F (–18°C). • The Frostex system can be left plugged in all year, but you will save ene...

Page 6 - The end seal can only be used once, so do not install it until step 2D.; Heating Cable Construction; Clear plastic; Prepare the heating cable.; Cleanly cut off one end of the heating cable.; Remove the plastic wrap.; in

4 Step 2.Install the end seal. Note: The end seal can only be used once, so do not install it until step 2D. Heating Cable Construction Clear plastic wrap Black core (bus wires inside) Braid Blue jacket 2A. Prepare the heating cable. Cleanly cut off one end of the heating cable. 2C. Remove the plast...

Other Tyco Models

All Tyco Other