Page 3 - Table of Contents
User Manual – Interactive Digital Signage SW601176 Rev D - Page 3 of 34 Table of Contents Chapter 1 - Introduction ........................................................................... 4 Chapter 2 – Unpacking .............................................................................. 5 Chap...
Page 4 - Chapter 1 - Introduction; Product Description
User Manual – Interactive Digital Signage SW601176 Rev D - Page 4 of 34 Chapter 1 - Introduction Product Description Your new Interactive Digital Signage TouchMonitor combines Elo TouchSystems’ reliable performance with the latest developments in touch technology and display design. This combination...
Page 5 - Chapter 2 – Unpacking; Unpacking the Touchmonitor
User Manual – Interactive Digital Signage SW601176 Rev D - Page 5 of 34 Chapter 2 – Unpacking Unpacking the Touchmonitor To unpack the touchmonitor, follow these steps: 1. The carton should be oriented in the manner according to its labeling. The hinged plastic locks should be at the ‘bottom’. 2. Op...
Page 6 - Unpacking The Digital Signage Computer Module
User Manual – Interactive Digital Signage SW601176 Rev D - Page 6 of 34 Note: For your health and safety, it is strongly recommended that at least two people handle, lift, or move these touchmonitors. Handles are provided on the unit’s back for easier handling. Check that the following items are pre...
Page 7 - Chapter 3 - Touchmonitor Installation; Connector Panel & Interfaces
User Manual – Interactive Digital Signage SW601176 Rev D - Page 7 of 34 Chapter 3 - Touchmonitor Installation Connector Panel & Interfaces Remove the cable cover on the bottom rear (when viewed in landscape orientation) to access the touchmonitor’s connector panel.
Page 8 - Touchmonitor Connections
User Manual – Interactive Digital Signage SW601176 Rev D - Page 8 of 34 3200L 4200L / 4600L / 5500L Touchmonitor Connections 1. Connect the HDMI and/or VGA video cables between the monitor’s HDMI/VGA input connectors and your HDMI/VGA video source, respectively. Tighten the VGA cable’s screws for be...
Page 11 - Chapter 4; Computer Module Installation; Installation
User Manual – Interactive Digital Signage SW601176 Rev D - Page 11 of 34 Chapter 4 Computer Module Installation Installation Note: Disconnect AC power from the touchmonitor before installing the Computer Module. Installing the Computer Module while AC power is connected to the touchmonitor will dama...
Page 14 - XP Operating Systems
User Manual – Interactive Digital Signage SW601176 Rev D - Page 14 of 34 Operating System Setup Windows ® 7, Windows ® XP Operating Systems The initial setup of the operating system takes approximately 5 minutes. Additional time might be needed for different touchcomputer hardware & operating sy...
Page 17 - Operating System Setup – No OS
User Manual – Interactive Digital Signage SW601176 Rev D - Page 17 of 34 Installing the Touch Technology Software Drivers for Elo Computer Modules with Windows XP Visit the Elo TouchSystems website www.elotouch.com for: • The latest touch driver versions • Additional touch driver information • Detai...
Page 18 - Chapter 5 – Mounting
User Manual – Interactive Digital Signage SW601176 Rev D - Page 18 of 34 Chapter 5 – Mounting Note: For your health and safety, it is strongly recommended that at least two people handle, lift, or move these touchmonitors. Two handles are provided on the unit’s back for easier handling. Note: When l...
Page 19 - Rear VESA Mount
User Manual – Interactive Digital Signage SW601176 Rev D - Page 19 of 34 5500L: Rear VESA Mount For the 32” model: A four-hole, 400x200mm mounting pattern is provided on the rear of the monitor. The VESA FDMI-compliant mounting is coded: VESA MIS-F, 400X200, Y, 6, 90 For the 42”, 46”, and 55” models...
Page 20 - Optional Stand
User Manual – Interactive Digital Signage SW601176 Rev D - Page 20 of 34 Optional Stand To install the optional stand: Lay the monitor face-down on a table with the bottom edge flush to the edge of the table. Mount the two “feet” from the optional stand using all of the provided screws. 3200L 4200L ...
Page 21 - Chapter 6 – Operation; Power; APR Touch Technology
User Manual – Interactive Digital Signage SW601176 Rev D - Page 21 of 34 Chapter 6 – Operation Power To turn the touchmonitor on or off, press the touchmonitor power button once. To power on the Computer Module, press the touchmonitor power button once. To power off the Computer Module and touchmoni...
Page 23 - IntelliTouch Touch Technology
User Manual – Interactive Digital Signage SW601176 Rev D - Page 23 of 34 IntelliTouch Touch Technology The IntelliTouch touchscreen can be re-calibrated to your displayed video image, if needed, through the Calibration function in the Elo driver control panel. Optical Touch Technology When connected...
Page 27 - OSD and Power Lockouts
User Manual – Interactive Digital Signage SW601176 Rev D - Page 27 of 34 OSD and Power Lockouts Press and hold the “Menu” and “Up” buttons for two seconds to enable/disable the OSD Locking feature. When the OSD Locking is enabled, pressing any of the Menu, Up, Down, or Select keys will have no effec...
Page 28 - Chapter 7 – Technical Support; Solutions to Common Problems; Technical Assistance
User Manual – Interactive Digital Signage SW601176 Rev D - Page 28 of 34 Chapter 7 – Technical Support If you are experiencing trouble with your touchmonitor, refer to the following suggestions. If the problem persists, please contact your local dealer or contact Elo TouchSystems Customer Service. S...
Page 29 - Chapter 8; Safety & Maintenance; Safety
User Manual – Interactive Digital Signage SW601176 Rev D - Page 29 of 34 Chapter 8 Safety & Maintenance Safety To avoid risk of electric shock, follow all safety notices and do not disassemble the touchmonitor or Computer Module. They are not user-serviceable. The slots located on the sides and ...
Page 30 - Mercury Warning
User Manual – Interactive Digital Signage SW601176 Rev D - Page 30 of 34 Mercury Warning The 3200L, 4200L, and 4600L products contain fluorescent lamps that contain mercury, which must be recycled or disposed of in accordance with local, state, or federal laws. Waste Electrical & Electronic Equi...
Page 31 - Regulatory Information
User Manual – Interactive Digital Signage SW601176 Rev D - Page 31 of 34 Chapter 9 - Regulatory Information I. Electrical Safety Information: Compliance is required with respect to the voltage, frequency, and current requirements indicated on the manufacturer’s label. Connection to a different power...
Page 33 - Warranty Information
User Manual – Interactive Digital Signage SW601176 Rev D - Page 33 of 34 Chapter 10 – Warranty Information Except as otherwise stated herein, or in an order acknowledgment delivered to Buyer, Seller warrants to Buyer that the Product shall be free of defects in materials and workmanship. The warrant...
