TRUE GDM-26 - Manual
TRUE GDM-26 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS
- Page 3 – ELSTAT SEQUENCE OF OPERATION; then cycle between these two modes.
- Page 4 – Probe Location 1; Probe
- Page 7 – FREQUENTLY ASKED QUESTIONS; Half reset clears any of the learning memory.; turn the lights on, however it will stay in stand by mode.; /05&5IFSFJTOPBCJMJUZUPTFUMJHIUTPOBMMUIFUJNF; $BOMJHIUTCFTFUUPTUBZPOBUBMMUJNFT
- Page 9 – (Please note this does not cover any and all situations)
ELSTAT TRAINING BOOKLET
GDM SERIES COOLER EQUIPPED WITH EMS (ELSTAT ) CONTROL
GDM-26
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TABLE OF CONTENTS · ELSTAT SEQUENCE OF OPERATION · ELSTAT COMPONENTS · FRONT VIEW OF ELSTAT · REAR VIEW OF CONTROLLER · FREQUENTLY ASKED QUESTIONS (FAQ) · NORMAL OPERATING CODES · FAULT CODES/ TROUBLESHOOTING · TROUBLESHOOTING GUIDE · PARAMETERS 2
ELSTAT SEQUENCE OF OPERATION Once the cabinet is plugged in, the ELSTAT control will flash "888" and then go through a parameter check. Once completed, the control will do a "soft start". Lights come on first, approximately 30 seconds later the compressor will start. Approximately 30...
&BTU5FSSB-BOFt0h'BMMPO.0tQItUPMMGSFFtTFSWJDF!USVFNGHDPN GDM-10 through GDM-37 Probe is in return air mounted by the evaporator fan motor. Probe Location 1 GDM-45 to GDM-72 Probe is in the discharge air stream Off of the Evaporator Coil (%.4&3*&4$00-&3&26*11&%8*5)&.4 &...
