TRAXXAS 6522 - Manual
TRAXXAS 6522 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Covers Part Number(s):
6522, 6536, 6542
Nitro 4-Tec 3.3 RPM Sensor
Installation
Required:
RPM Sensor 6522
RPM Sensor Mount 6536
Flywheel with Magnet 6542
Tools Needed:
2.5mm Hex Driver
2mm Hex Driver
5.5mm Hex Wrench
8mm Hex Wrench
Pliers
Note:
Your model may have telemetry-ready
parts installed from the factory. Please
inspect the model before installation.
Required for Telemetry Operation:
TQi Radio system with #6510 Docking
Base
#6518 Traxxas Link Receiver
iPhone 3G/3GS/4/4S or 2
nd
, 3
rd
,or 4
th
generation iPod Touch
Traxxas Link Application (available free
at the Apple App Store
Installation Steps:
1. Remove the fuel lines from the carburetor and
the exhaust pipe. Remove the throttle linkage
from the carburetor.
2. Remove the EZ-Start connector from the
chassis by removing the 2mm button-head cap
screw (BCS) that secures it.
(A)
3. Remove the 5.5mm nut that secures the
exhaust pipe to the chassis.
4. Turn the vehicle over and remove the four
2.5mm
(B)
screws and two 2mm countersunk
screws
(C)
that secure the engine mount to the
chassis.
5. Remove the engine and engine mount from the
chassis.
6. Remove the exhaust pipe from the engine using
a 2.5mm hex driver.
7. Remove the EZ-Start assembly from the engine
using a 2mm hex driver.
8. On the left side of the engine, remove the two
2.5mm cap screws securing the engine to the
engine mount.
(D)
9. Package #6536 includes three RPM sensor
mounts. The mount for the Nitro 4-Tec is
labeled “C”. Install the RPM sensor mount on
top of the mounting tab and secure with the new
engine mount screws that are included.
#6536
#6522
#6542
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
