TRAXXAS 2401 - Manual

TRAXXAS 2401

TRAXXAS 2401 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
Page: / 29

Table of Contents:

  • Page 2 – RADIO SYSTEM INSTRUCTIONS:; IMPORTANT; HARDWARE DESCRIPTION:
  • Page 4 – OUTPUT SHAFT
  • Page 7 – DRIVE SHAFT ASSEMBLY:; Locate the differential output yokes, and two 3x12 yoke pins.
  • Page 8 – Repeat the last two steps
  • Page 9 – SLIPPER CLUTCH INSTALLATION:
  • Page 10 – The rear camber links are 65mm overall length.; Shoulder screw
  • Page 11 – REAR SUSPENSION ARMS:; The Bandit rear suspension arms are shorter than the Rustler arms.; Right; Screw pin
  • Page 12 – Slide a 3x6mm washer over each of the 3x12mm ball screws.; DRIVE SHAFT COMPLETION:; Washer
  • Page 13 – BAG C FRONT SUSPENSION:
  • Page 15 – The front camber links are 75mm overall length.; BAG D SHOCK ASSEMBLY:; Limiter
  • Page 18 – BAG E STEERING ASSEMBLY:; Shoulder bolt
  • Page 19 – Locate the upper chassis plate and two 5x8x0.5mm teflon washers.; Reverse
  • Page 21 – Screw the posts into the chassis as shown.
  • Page 23 – TRANSMISSION INSTALLATION:; OUTPUT
Loading the manual

ASSEMBLY MANUAL

MODEL 3701

MODEL 2401

REV 030128

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - RADIO SYSTEM INSTRUCTIONS:; IMPORTANT; HARDWARE DESCRIPTION:

2 INTRODUCTION: Thank you for purchasing a Traxxas product. The Rustler and Banditdeliver pro-level racing technology and performance. The transmission is a quiet and efficient 3-gear design complete with ball bearings. The planetary gear differential provides proven durability and low-maintenance o...

Page 4 - OUTPUT SHAFT

4 STEP A-1 This drawing is provided to help you identify the parts of the planetarydifferential by name. STEP A-2 Locate the main differential gear and one of the sun gears. Apply siliconegrease to the base of the output shaft of the sun gear. Insert the sun gearthrough the center of the main differ...

Page 7 - DRIVE SHAFT ASSEMBLY:; Locate the differential output yokes, and two 3x12 yoke pins.

7 DRIVE SHAFT ASSEMBLY: STEP A-18 Locate the differential output yokes, and two 3x12 yoke pins. STEP A-20 Secure both yokes with a 3x12 yoke pin. The shaft of the yoke pin must enterthrough the hole in the output shaft. Thread the yoke pin into the outputyoke until the yoke pin is flush with the out...

Other TRAXXAS Models

All TRAXXAS Other