Trane TCONT800AS11AA - Manual
Trane TCONT800AS11AA – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TCONT800AS11AA TOUCH SCREEN PROGRAMMABLE COMFORT CONTROL; Installing Wallplate; CAUTION; IMPORTANT
- Page 3 – system with single transformer
- Page 4 – Powering the Comfort Control; The comfort control can be powered with 24 Vac.; Mounting the Comfort Control; Setting Calendar and Time; Locate and remove the tab labeled
- Page 5 – Using the Comfort Control; OPERATION; System and Fan Settings; SYSTEM Settings
- Page 6 – INSTALLER SETUP; Follow these steps to enter the Installer Setup:
- Page 11 – SYSTEM CHECKOUT; Installer System Test; ADVANCED FEATURES; Outdoor or Indoor Temperature Sensor
- Page 12 – Symptom
® U.S. Registered Trademark • US Pat. #6,595,430 and Other Patents Pending
Copyright © 2005 American Standard Inc. • All Rights Reserved •
INSTALLATION INSTRUCTIONS
69-1787-1
TCONT800AS11AA Touch Screen
Programmable Comfort Control
18-HD25D18-1
APPLICATION
The TCONT800AS11AA Programmable Comfort Control provides electronic control of 24 Vac heating and cooling
systems. See Table 1 for a general description.
RECYCLE NOTICE
If this control is replacing a control that contains
mercury in a sealed tube, do not place your old
control in the trash. Dispose of properly.
Contact your local waste management authority
for instructions regarding recycling and the
proper disposal of the old control.
INSTALLATION
When Installing this Product...
1.
Read these instructions carefully. Failure to follow
the instructions can damage the product or cause
a hazardous condition.
2.
Installer must be a trained, experienced service
technician.
3.
After completing installation, use these instructions
to check out the product operation.
Selecting Location
Install the comfort control about 5 ft. (1.5m) above the
floor in an area with good air circulation at average
temperature. See Fig. 1.
Fig. 1. Selecting comfort control location.
Do not install the comfort control where it can be
affected by:
— Drafts or dead spots behind doors and in corners.
— Hot or cold air from ducts.
— Radiant heat from sun or appliances.
— Concealed pipes and chimneys.
— Unheated (uncooled) areas such as an outside wall
behind the comfort control.
Table 1. TCONT800AS11AA Comfort Control Description.
Power Method
Changeover
System Selection
Fan Selection
Comments
24 Vac common wire
Automatic or
manual
selectable
Heat-Off-Cool-Auto
On-Auto-Circ
System and Fan selection vary
based on system type
5 FEET
[1.5 METERS]
YES
NO
NO
NO
M19925
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
TCONT800AS11AA TOUCH SCREEN PROGRAMMABLE COMFORT CONTROL 69-1787-1 2 Pub. No. 18-HD25D18-1 Installing Wallplate CAUTION Electrical Hazard.Can cause electrical shock or equipment damage. Disconnect power before wiring. The comfort control can be mounted horizontally on the wall or on a 4 in. x 2 in. ...
TCONT800AS11AA TOUCH SCREEN PROGRAMMABLE COMFORT CONTROL 3 69-1787-1 Pub. No. 18-HD25D18-1 Fig. 5. Typical hookup of single-stage heat and cool system with single transformer (1H/1C). Fig. 6. Typical hookup of single-stage heat and cool system with two transformers (1H/1C). Fig. 7. Typical hookup of...
TCONT800AS11AA TOUCH SCREEN PROGRAMMABLE COMFORT CONTROL 69-1787-1 4 Pub. No. 18-HD25D18-1 Powering the Comfort Control The comfort control can be powered with 24 Vac. 24 Vac Common Power (Recommended) Wire the common side of the transformer to the B screw of the comfort control wallplate. When inst...
