Tote Vision LCD-1700VRZ - Manual

Page 2 - Table of Content

Table of Content Operating Instructions Safety Precautions _________________________________ 2 Care and Maintenance ______________________________ 3 CHAPTER 1 Introduction _______________________________________ 4 Factory-Preset Modes _______________________________ 5 Specification LCD-1700VRZ Speci...

Page 5 - CHAPTER 1; Introduction; BEFORE INSTALLING YOUR MONITOR

4 CHAPTER 1 Introduction BEFORE INSTALLING YOUR MONITOR Read this manual cover to cover. PAY ATTENTION to all WARNING and CAUTIONS DO NOT use computer components not recommend by the manufacture Do not attempt to service the monitor your self. If a problem occurs, contact the manufacture's authorize...

Page 7 - Specifications

6 Specifications l LCD-1700VRZ 17” LCD 1U Rack Display Monito r Overall Dimension(HxWxD): 483 x 515 x 43 mm Effective Display area(H/V): 337.92 x 270.34 mm Display colors: 16M colors Scan Frequencies: Horizontal 31.47K to 80KHz Vertical 60Hz to 75Hz Number of Pixels: 1280x1024 pixels Pixel pitch: 0....

Page 9 - Chapter 2; RODUCT; I N S T A L L I N G T H E M O N I T O R

8 Chapter 2 P RODUCT P ACKAGE Open the shipping carton and check the contents. If any items are missing or damaged, contact your dealer immediately. The package should include the following items l Analog Color TFT LCD Monitor l Accessory Box: 1. VGA cable x 1 2. AC to DC adapter x 1 3. Power Cord x...

Page 10 - The control key description

9 C O N T R O L F U N C T I O N S The Monitor control functions are located on the right corner of the front view side. They are shown in the figure below and described in the following paragraphs. The control key description 1. : Power Switch 2. - : Decrement 3. + : Increment or source select 4. ∇ ...

Page 11 - DESCRIPTION

10 DESCRIPTION 1. : Power switch Use the power switch to turn ON or OFF power. We recommend turning your system power on first, then the LCD monitor. 2. - & + : decrement or increment the value The two keys are decrement or increment the value or enter into the sub-menu. Note: The + key can chan...

Page 12 - CHAPTER 3; D J U S T I N G T H E M O N I T O R; Auto Adjustment

11 CHAPTER 3 A D J U S T I N G T H E M O N I T O R VGA OSD main screen 1. Each time, when pressing the menu key, the screen will show as above. You can see the 3 mark that means the selected item. Then you can change the setting through + or -.key. 2. Pressing the Sel key to move the arrow down or u...

Page 16 - Chapter 4; VIDEO ADJUSTMENT; Brightness

15 Chapter 4 VIDEO ADJUSTMENT Video OSD Screen NTSC 15.7 K 60.2 VER XGA-KDC45-5100 1. Each time, when pressing the menu key, the screen will show as above. You can see the 3 mark, that means the selected item Then you can change the setting through + or -.key. 2. Pressing Sel key to move the arrow d...

Page 18 - Appendix

17 Appendix Troubleshooting Procedures This LCD Monitor was pre-adjusted in the factory with standard VGA timing. Due to output timing differences among various VGA cards, you may initially experience an unstable or unclear display when a new display mode or new VGA card is selected. This LCD Monito...

Tote Vision LCD-1700VRZ - Manual

Table of Contents:

Summary

Other Tote Vision Models