Toshiba 750 - Manual
Toshiba 750 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Toshiba TRR
- Page 3 – To disassemble the FDD, follow the steps below.; Remove six M2x6 silver screws.
- Page 4 – To assemble the FDD, follow the steps below.
- Page 5 – Slide the cover all the way to the right.
- Page 6 – Mount the cover onto the HDD.; To install the HDD pack, follow the steps below.
- Page 8 – Turn the computer upside down.
- Page 9 – Open the camera port cover on the
- Page 10 – To remove the speakers, follow the steps below.; Lift up the system board to disconnect
- Page 11 – To remove the fan, follow the steps below.
- Page 12 – Seat the PC card slot cover.; Connect two secondary battery cables
- Page 13 – Remove the battery pack.
- Page 14 – Lift out the LCD Module.
- Page 15 – Lift out the FL cable and the FL.; To remove the FL, follow the steps below.; Lift out the FL cable and the FL holder.
4/00, Tecra
Toshiba TRR
Page 12
Tecra 750 Series Disassembly Overview
This section explains how to remove Field
Replaceable Units (FRUs). It may not be neces-
sary to remove all the FRUs in order to replace
one.
The chart is a guide to which FRUs need to be
removed in order to remove others. The section
numbers on the chart refer to the sections in the
Maintenance Manual, Chapter 4.
Always start by removing the battery pack, next,
optional items such as the optional PC card and
optional memory module, then follow the line on
the chart to determine which FRU you must
remove next in order to repair the one you think is
causing the computer to operate improperly.
The information offered in this section is an overview of the Maintenance Manual, Chapter 4, Replacement
Procedures. If you have any questions or concerns regarding the proper procedure please refer to the Mainte-
nance Manual through the Toshiba Service and Support Website before you proceed.
To remove the battery pack, follow the steps
below.
CAUTION: When handling battery packs, be
careful not to short circuit the terminals. Also
do not drop, hit or otherwise apply impact; do
not scratch or break the casing.
1.
Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2.
Turn the computer upside down with the
front facing you and push the battery
lock up to unlock it. A red dot shows
when the lock is in the unlock position.
3.
Pull the battery’s release lever out and
slide it to the left to pop the battery up
slightly.
4.
Grasp the battery pack and lift it out.
1.
Turn off the power to the computer.
Disconnect the AC adapter and all
external cables connected to the
computer.
2.
Make sure the battery release lever is
pulled out, then carefully insert the new
or recharged battery pack.
3.
Place your fingers just above two pins
on the battery pack that fit into the
locking mechanisms in the battery
socket. Push the battery pack down
carefully until it locks into place.
4.
Push the battery lock down to secure it.
The red dot will be covered.
To install the battery pack, follow the steps below.
WARNING: The battery pack is a lithium ion
battery, which can explode if not properly
replaced, used, handled, or disposed of.
Dispose of the battery as required by local
ordinances or regulations. Use only batteries
recommended by Toshiba as replacements.
NOTE: Check the battery terminals visually. If
they are dirty, wipe them clean with a dry
cloth.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Toshiba TRR 4/00, Tecra Page 13 Tecra 750 Series Disassembly Overview, (cont.) To remove the optional PC card, make sure thecomputer is in boot mode, then follow the stepsbelow. 1. Turn off the power to the computer.Disconnect the AC adapter and allexternal cables connected to thecomputer. 2. Remove...
4/00, Tecra Toshiba TRR Page 14 Tecra 750 Series Disassembly Overview, (cont.) To install the Selectable Bay cover, follow thesteps below. 1. To install the cover, first remove theSelectable Bay module then hold thecover by the two finger grips and push itinto place until you hear the latchesclick. ...
Toshiba TRR 4/00, Tecra Page 15 Tecra 750 Series Disassembly Overview, (cont.) To assemble the FDD, follow the steps below. 1. Seat the FDD in the bracket andsecure the bracket with four M2.5x2.8black screws in the order numberedon the case. Tighten screws to a torqueof less than 2.2 kgfcm. 2. Inser...
