Page 2 - Contents
Introduction Welcome to Toshiba .................................................................................................. 3Important Safety Instructions .................................................................................... 3Important information .................................
Page 3 - Introduction; Welcome to Toshiba; Installation
3 Introduction Welcome to Toshiba • Thank you for purchasing this Toshiba LCD Color Television. This manual will help you use the exciting features of your new TV. • Instructions in this manual are based on using the remote control. • You also can use the controls on the TV if they have the same nam...
Page 4 - ) Install the TV in a horizontal, stable; Top view; Side view; ) Precautions for moving the TV
4 5) Never place the TV near a heater or in direct sunlight. The surface of the cabinet or power cord may melt and result in a fi re or an electric shock. 6) Never place the TV in an area exposed to high humidity levels, such as in a bathroom or close to a humidifi er. This may cause a fi re or an elec...
Page 5 - Use; ) Never place hot objects or open flame; ) When the TV will not be used for a long; • The TV is not completely disconnected from
5 10) Precautions for installing on outdoor antenna An outside antenna system should not be located in the vicinity of overhead power lines, or other electric light or power circuits.If the antenna falls down or drops, it may cause an injury or an electric shock. Use 1) Never place hot objects or op...
Page 6 - You may suffer an electric shock.; Service
6 6) Never pull on the power cord when removing the plug from the wall outlet. Always hold the plug fi rmly when removing it. If the power cord is yanked, the cord may become damaged and a fi re or an electric shock may occur. 7) Never cut, break, modify, twist, bunch up or bent the cord or apply exce...
Page 7 - Cleaning; Important information; Exemptions
7 Cleaning 1) Remove the power plug before cleaning. Never use solvents such as benzine or thinner to clean the TV.• These solvents may distort the cabinet or damage its finish. • If rubber or vinyl products remain in contact with the TV for a long time, a stain may result. If the cabinet becomes dir...
Page 8 - Connecting an antenna; Media Recorder; Exploring your new TV; Installing the remote control batteries; Getting started; Effective range
8 Connecting an antenna Optimum reception of color requires a good signal and will generally mean that an outdoor antenna must be used.The exact type and positioning of the antenna will depend upon your particular area.Your Toshiba dealer or service personnel can best advise you on which antenna to ...
Page 9 - TV top, front and side panel controls; OK; I i; TV top view; Right side view
9 Getting started TV top, front and side panel controls • You can operate your TV using the buttons on the side panel or the remote control. The back and side of the panel provide the terminal connections to connect other equipment to your TV ( - “Connecting your TV” pages 26-30). • For the use of e...
Page 10 - SET UP; — Analog; TV back panel connections; TV back view
10 Getting started 11 O MONITOR (output terminals) — Standard video and standard audio outputs ( - page 26). 12 o (3) (Video 3 input terminals) — High- definition component video and standard (analog) stereo audio inputs ( - page 26). 13 o PC/HDMI1 (AUDIO) (input terminals) — PC audio input terminals...
Page 11 - Learning about the remote control; Location of controls; MENU; U u
11 Getting started Learning about the remote control Location of controls To return to the previous program ( - page 13) Teletext on/Superimpose Teletext/off ( - pages 24, 25) Picture mode selection ( - page 18) Picture still ( - page 17) Stereo/bilingual selection ( - page 20) MENU ( - page 12) • C...
Page 12 - Turning the TV on; Switching on the TV; Learning about the menu system; Displaying the menu chart
12 Getting started Turning the TV on Switching on the TV Connect the power cord to a wall outlet, the ! power indicator lights in red (standby mode). 1 Press J on the remote control or ! on the TV right side panel, the ! power indicator lights in green. Note: If you watch black and white programs wh...
Page 13 - Watching TV programs; Selecting the menu language; Changing the program position; Switching between two program positions; Number; Displaying the on-screen information
13 Getting started • To return to the previous menu, press M . • The U / u function as the Program position P B / P b when there is no menu display on the screen. • The I / i function as the Volume 2 +/ 2 – when there is no menu display on the screen. • In the PC input mode, PC Setting appears in th...
Page 14 - Programming channels automatically; Manual tuning
14 Getting started Manually setting channels in the channel memory 1 From the SET UP menu, press u or U to select Manual tuning . 2 Press Q to display the Manual tuning menu. Press u or U to select the program position you want to arrange. 5 4 3 2 1 MENU Back Watch TV EXIT 6 OK Manual tuning P r o g...
Page 15 - Sorting program position
15 F. Auto Fine Tuning Press u or U to turn the Auto Fine Tuning option on “ 9 ” or off “ 0 ”. The Auto Fine Tuning function automatically corrects slight fluctuations when receiving signals. Manual Fine Tuning While the Auto Fine Tuning turn off “ 0 ”, press u or U so that the better picture and sou...
Page 16 - Using the TV’s features; Picture adjustment; Selecting the picture size
16 Using the TV’s features Picture adjustment Selecting the picture size 1 Press O until the picture size list appears on the screen, then press u or U to select the appropriate picture size (or press O repeatedly to select required picture size directly). Super Live 1 4:3 Cinema 1 Cinema 2 Super Li...
Page 17 - Using the picture still; SET; Resetting the picture position; Picture position
17 Using the TV’s features PC Use this setting for PC via HDMI. When receiving 1080p, 1080i or 720p signal format of HDMI input, this picture size is available. Notes: • In the antenna input signal mode, the picture size selections are Wide , Super Live 2 , Cinema 2 , 4:3 , Super Live 1 , Cinema 1 ,...
Page 18 - Selecting the picture mode; Adjusting the basic picture quality; Tint; Activating the black stretch
18 Using the TV’s features Selecting the picture mode You can select the picture quality instantly among three preset modes and one user-set mode.• Press N to select the desired picture quality. D y n a m i c Mode Picture quality q Dynamic bright and dynamic picture q Standard standard picture q Mil...
Page 19 - Adjusting the color management; • If you select color management; Resetting the base color adjustment; In the PC input mode (; Selecting the color temperature
19 Using the TV’s features Adjusting the color management You can adjust the picture color quality by selecting from 6 base color adjustments : Red , Green , Blue , Yellow , Magenta or Cyan . 1 From the PICTURE menu, press u or U to select 3D Color management . 2 Press I or i , then press I or i to ...
Page 20 - Selecting the stereo programs; Selecting the bilingual programs; II; Adjusting the sound quality; Effective signal and setup conditions:; Sound adjustment; Auto mode; Mono mode; Auto; Selecting the dual 1 or dual 2 mode; Mono
20 Using the TV’s features Selecting the stereo programs 1 When a stereo program is received, d Stereo appears. 2 Press s to select the stereo/monaural mode. d Stereo and e Mono appear cyclically on the screen. S t e r e o Selecting the bilingual programs 1 When a bilingual program is received, j Du...
Page 21 - Using the SRS WOW; Using the stable sound; Using the bass boost
21 Using the TV’s features Selection I Pressing i Bass weaker stronger Treble weaker stronger Balance decreases the right channel decreases the left channel Using the SRS WOW ® surround sound SRS WOW ® is a special combination of SRS Labs audio technologies that creates a thrilling surround sound ex...
Page 22 - Using the auto format; Activating blue screen; Other features settings; Selecting the timer menu
22 Using the TV’s features Using the auto format When the TV receives a true HDMI signal picture and the auto format is On, it will automatically be displayed in HDMI signal format, irrespective of the TV’s previous setting. 1 Press M , then press I or i to display the FUNCTION menu. FUNCTION MENU B...
Page 23 - PC VGA mode; MONITOR; Setting the manual setting menu
23 Using the TV’s features Selecting the video input source to view 1 Press o or press Q on the remote control until the video input mode list appears on the screen, then press u , U or o to select appropriate input source (or press o on the TV right side panel to select required input source direct...
Page 24 - Teletext; Setting up the teletext mode; To select a language for teletext:; To select teletext mode:; When you are watching the teletext program,; Teletext general information; If you press; Using Auto mode; Red
24 Teletext This TV has a multi-page teletext memory, which takes a few moments to load and it offers two ways of viewing Teletext Auto and LIST which are explained below. Setting up the teletext mode To select a language for teletext: The language 1-4 option enables the display of different languag...
Page 25 - Using LIST mode; Teletext buttons on the remote control; to return to a
25 Using the TV’s features Using LIST mode 1 Press E to access teletext. Red Green Yellow Blue 1 0 0 T E X T M 0 0 1 4 : 5 8 : 5 5 1 0 0 2 0 0 3 0 0 4 0 0 The four choices at the bottom of the screen are now number – 100 , 200 , 300 and 400 , which have been programmed into the TV’s memory. 2 To vie...
Page 26 - Connecting your TV; Side connections; TV right side view; Back connections; Connection example
26 Connecting your TV Side connections You can connect a wide variety of auxiliary equipment via the terminals located on the right side of the panel o (2) . Please always refer to the owner’s manual of the equipment to be connected for full details. Connection example TV right side view Video Games...
Page 27 - Analog; Connecting an HDMI or a DVI device; Connecting an HDMI device; HDMI device; Connecting a DVI device; DVI device; Standard analog audio cables
27 Connecting your TV Connecting an HDMI or a DVI device • When turning on your electronic components, turn on the TV first, and then the HDMI or DVI device. • When turning off your electronic components, turn off the HDMI or DVI device first, and then the TV. • This TV may not be compatible with feat...
Page 28 - Selecting the PC/HDMI1 audio mode; Setting the HDMI1 audio mode; When the sound is not audible:
28 Connecting your TV Selecting the PC/HDMI1 audio mode You can select PC audio ( - page 29) or HDMI1 audio when using this function. 1 Press M , then press I or i to display the SET UP menu. AV c o n n e c t i o n M a n u a l t u n i n g OK OK Au t o t u n i n g OK L a n g u a g e SET UP English OK...
Page 29 - Connecting a computer; The following signals can be displayed:; • There is no need to use an adapter for; Signal names for mini D-sub 15 pin connector; Pin assignment for RGB/PC terminal; Signal name
29 Connecting your TV Connecting a computer To connect a PC to the RGB/PC terminal on the TV: An analog RGB (15 pin) computer cable can be connected. TV back view Computer Audio cable for PC-to-TV connection Conversion adapter (if necessary) RGB PC cable Mini D-sub 15 pin TV back view Connect a PC c...
Page 30 - Using the PC setting; Adjusting the picture size/position
30 Connecting your TV To connect a PC to the HDMI terminal on the TV: When connecting a PC to the HDMI terminal on the TV, use an HDMI-to DVI adapter cable and analog audio cables.If connecting a PC with an HDMI terminal, use an HDMI cable (type A connector). Separate analog cables are not necessary...
Page 31 - Adjusting the clock phase of the picture
31 Connecting your TV Adjusting the clock phase of the picture If the clock phase, which synchronize the PC signal and LCD display, is not optimized, the picture will blur. This function enables you to adjust clock phase and display a clear picture. 1 From the PC Setting menu, press u or U to select...
Page 32 - Troubleshooting; Symptom and solution; PICTURE; Reference section
32 Troubleshooting Before calling a service technician, please check the following table for a possible cause of the symptom and some solutions. Symptom and solution TV will not turn on • Make sure the power cord is plugged in, then press ! or 1 . • The remote control batteries may be dead. Replace ...
Page 33 - Broadcast system; Broadcast transmission systems of each country or region; Oceania
33 Reference section Broadcast system Broadcast transmission systems of each country or region Asia M.E. Country or region Color Sound Bahrain, Kuwait, Israel, Oman, Qatar, United Arab Emirates, Yemen, etc. Indonesia, Malaysia, Singapore, Thailand, etc. PAL B/G China PAL D/K China Hong Kong PAL I Ir...
Page 34 - Specifications; LCD color television
34 Reference section Specifications LCD color television Model 32A3500A, 32A3500E, 32A3500T37A3500A, 37A3500E, 37A3500T42A3500A, 42A3500E, 42A3500T Power source 32/37/42A3500A: 220V-240V AC, 50Hz32/37/42A3500E: 220V-240V AC, 50/60Hz32/37/42A3500T: 110V-240V AC, 50/60Hz Power consumption 32A3500A/E/T:...
