Toro 53749 - Manual
Toro 53749 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Installation Procedure
CAUTION: When assembling the Drip Zone Valve
Kit components, use just 1
1
⁄
2
to 2 turns of Teflon
tape on male threads. Never use pipe dope.
To achieve a leak-free thread connection, turn the
male fitting until it is finger tight, then add one or
two more turns. Over-tightening can cause splitting
and failure of the female threads.
Important:
Ensure the Y-Filter, Jar Top Valve and
Pressure Regulator are installed in the correct flow
orientation. Flow direction arrows are provided on each
component. Refer to
Figure 1
and
Figure 2
.
1.
Using the Close Nipple, install the Ball Valve to the Jar
Top Valve inlet.
2.
Remove the Bonnet Ring from the Y-Filter by turning
it counterclockwise. Remove the Bonnet and Filter
Screen. See
Figure 1
.
3.
Install the Y-Filter inlet to the Jar Top Valve outlet.
4.
Install the Pressure Regulator inlet to the Y-Filter outlet.
5.
Reassemble the Y-Filter components.
Note:
Hand tighten the Bonnet Ring only – do not
over-tighten.
Important:
Refer to the provided Toro Jar Top Valve,
Anti-Siphon (AVB) installation instructions for additional
important installation and operating information.
6.
To determine the recommended minimum/maximum
number of drip emitters per Jar Top valve, refer to the
table below.
For technical assistance, call 1-800-367-8676.
Kit Components
• 3/4" (FPT X FPT) Ball Valve
• 3/4" (MPT X MPT) F Series Y-Filter, 150 Mesh
• 3/4" (FPT X FPT) Toro Jar Top Valve, Anti-Siphon (AVB)
• 3/4" NPT Close Nipple
• 3/4" (FPT X FPT) Pressure Regulator, 25 PSI at 0.25–8 GPM
Drip Zone Valve Kit
Model 53749
Installation Instructions
Specifications
• Inlet/Outlet Pipe Connection: 3/4" Female NPT
• Maximum Supply Pressure: 150 PSI
• Downstream Pressure Regulation: 25 PSI
• Flow Rate @ 25 PSI: 0.25–8 GPM
• Filtration: 150 Count Stainless Mesh Screen
• Irrigation Control Valve:
• Automatic, Anti-Siphon, Toro Jar Top Model
• Manual Bleed and Flow Control
• 24 V a.c., 60 Hz Solenoid
Bonnet Ring
Bonnet
Filter Screen
Jar Top Valve
Y-Filter
Ball Valve
From Water
Supply
To Emitters
Pressure
Regulator
Close Nipple
Body
Note: Valve must be
installed at least 6"
above the highest
emitter it controls.
Figure 2
Figure 1
© 2005 The Toro Company, Consumer Division • An ISO 9000-certified Company
Form Number 373-0347 Rev. B
P.O. Box 489, Riverside CA, 92502 • www.toro.com
RELEASED Version ©Toro 2005-2005
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
