Toro 140 2059 - Installation Manual
Toro 140 2059 – Installation Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Preparing the Machine; Procedure; Procedure
- Page 3 – Removing the Lift Lever
- Page 4 – Installing the Foot Pedal
- Page 7 – Completing the Setup
Form No. 3436-785 Rev B
Deck Footlift Assist Kit
TimeCutter
®
Riding Mower
Model No. 140-2059
Installation Instructions
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Remove the MyRide guard.
3
No parts required
–
Remove the lift lever.
Lift pedal
1
Foot peg
1
Foot-lift plate
1
Carriage bolt (5/16 x 1-1/4 inches)
2
Locknut (5/16 inch)
2
Thrust washer
2
Spacer (3/8 inch)
1
Spacer (5/16 inch)
2
Link
1
Carriage bolt (3/8 x 1 inch)
1
Locknut (5/16 inch)
2
Shoulder bolt (3/8 x 7/8 inch)
2
Locknut (3/8 inch)
3
Hex-head bolt (3/8 x 1 inch)
1
Washer
1
Nylon washer
1
4
Anti-seize packet
1
Install the foot pedal.
5
No parts required
–
Complete the setup.
© 2020—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3436-785*
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Toro 140 2059
Summary
1 Preparing the Machine No Parts Required Procedure 1. Park the machine on a level surface. 2. Disengage the blade-control switch (PTO), movethe motion-control levers to the N EUTRAL -L OCK position, and engage the parking brake. 3. Shut off the engine, remove the key, and waitfor all moving parts t...
3 Removing the Lift Lever No Parts Required Procedure Remove the hex-head bolt (5/16 x 1 inch) and flangenut (5/16 inch) securing the lift lever ( Figure 2 ). Retain the lift lever for later installation. You candiscard the hex-head bolt (5/16 x 1 inch) and flangenut (5/16 inch). g343672 Figure 2 1....
4 Installing the Foot Pedal Parts needed for this procedure: 1 Lift pedal 1 Foot peg 1 Foot-lift plate 2 Carriage bolt (5/16 x 1-1/4 inches) 2 Locknut (5/16 inch) 2 Thrust washer 1 Spacer (3/8 inch) 2 Spacer (5/16 inch) 1 Link 1 Carriage bolt (3/8 x 1 inch) 2 Locknut (5/16 inch) 2 Shoulder bolt (3/8...
