Toro 127 6666 - User Manual
Toro 127 6666 – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Figure 2; Safety Alert Symbol; WARNING
- Page 3 – Installation Instructions; Figure 3; and; For All Models Except 96 Inch:; Figure 4
- Page 4 – Figure 5; Repeat steps; Figure 6; Tighten all hardware.
Form No. 4505-695 Rev A
Jack Mount Kit
Kit No. 135-1768
Installation Instructions
For Diesel Models Serial No. 402,082,300 And Higher
For All 96 Inch Gas Models
Loose Parts
Use the chart below to verify that all parts have been shipped.
Item
No.
Part No.
Description
Qty
Item
No.
Part No.
Description
Qty
1
135-1767
Mount-Jack W/Decal
1
3
109–6658
Nut-Nyloc 3/8-16 Flg
3
2
109-6795
Bolt-Carriage 3/8-16 x 5
3
4
135-3919-01 Spacer-Mount, Jack
1
Other Required Parts
This mount is only approved for use with Jack Kit P/N 127-6666.
1
2
4
3
g364902
Figure 1
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*4505-695*
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Toro 127 6666
Summary
Safety Alert Symbol This Safety Alert Symbol ( Figure 2 ) is used both in this instruction sheet and on the machine to identifyimportant safety messages which must be followed toavoid accidents This symbol means: ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! g000502 Figure 2 Safety Alert Symbol ...
Installation Instructions 1. Stop the engine, wait for all moving parts to stop,and remove key. Engage parking brake. 2. Align the vertical edges of the jack mount withthe frame tube and gusset as shown in Figure 3 . g248503 Figure 3 1. Jack mount 5. Frame 2. Vertical edge 6. 3/8-16 x 5 inch bolt 3....
g248706 Figure 5 1. Top hole C. Repeat steps 2 and 3 . Install the remaining bolt and nut in the hole drilledin step Figure 5 . • For 96 Inch Models: Slide the mount rearward until the jack mount is wedgedagainst the right top frame gusset and sidegusset. Install the remaining bolt and nut. g384558 ...
