Telex PST-170 - Manual - manualsarea.com

Page 2 - PST-170 SPECIFICATIONS; EDR enabled 77 dB; CHANNEL ASSIGNMENT

-1- PST-170 SPECIFICATIONS Number of Channels · · · · · · · · · · · · · 17 User Selectable Channels Power Output · · · · · · · · · · · · · 80,000 uV/M at 3 meters, maximum Antenna · · · · · · · · · · · · · · · · · · · Permanently attached trailing wire Modulation · · · · · · · · · · · · · · · · · · ...

Page 3 - BATTERIES; Do not attempt to recharge alkaline batteries as this; BELT CLIP; Side View

BATTERIES The PST-170 Transmitter uses two AA batteries. Positionthem in the battery compartment as illustrated. You can ex-pect 8 hours of operation from alkaline batteries and 4 hourson nickel-cadmium batteries. Charge Pins are provided onthe bottom of the unit that fit Telex drop in chargers. CAU...

Page 4 - Transmitter Channel; The PST-170 Transmitter may be set to any one of 17 channels.; Antenna

Transmitter Channel The PST-170 Transmitter may be set to any one of 17 channels. Two Transmitters cannot operate on the same channel un-less separated by 300 feet (91 m) or more (which is the aver-age maximum operating range). If two transmitters areoperating on the same channel inside this perimet...

Page 5 - Frequency/Channel Considerations; SET; Top View

The second jack is the microphone input. This jack is locatedon the top panel “step” of the transmitter. The microphone issupplied with the transmitter but other types can be used as well. Frequency/Channel Considerations As with any radio device, interference can occur at any time.The frequencies o...

Page 6 - Channel Display A through Q, low battery indicator and input level; LCD Display

Placement of the Transmitter and Microphone Place the transmitter on the users belt or in their pocket,preferably with the antenna facing the receiver. Do not coilthe antenna and put it in a pocket. This will severely reducethe operating range. Place the microphone about 10 to 12 inches below the mo...

Page 7 - Channel Selection and Input Adjustment

Channel Selection and Input Adjustment 1. Turn the receiver on and plug a microphone into the mic jack.A channel letter will show in the display. 2. Press the set button once and the Channel indicator will flash. 3. Press the button and the Channel will cycle up. Match the channel to the receivers b...

Page 8 - Change Lock Out; The padlock symbol will appear and the set button is disabled.

Enhanced Dynamic Range (E.D.R.) Operation The Telex PST-170 Transmitter is equipped with E.D.R., En-hanced Dynamic Range (companded) audio. This modegreatly improves the Audio Signal to Noise Ratio when usedwith the Telex Model SR-400 receiver. The E.D.R. mode mustbe selected on both the transmitter...

Page 10 - FCC INFORMATION; Changes or modification made by the user could void; ACCESSORIES; Description

FCC INFORMATION The Telex Model PST-170 is authorized under FCC RulesPart 15. Licensing of Telex equipment is the user’s responsi-bility and licensablilty depends upon the user’s classification,and frequency selected. CAUTION: Changes or modification made by the user could void the user’s authority ...

Page 11 - WARRANTY INFORMATION; LIMITED WARRANTY (VALID UNITED STATES AND CANADA ONLY); Products purchased from unauthorized dealers are not warranted.

WARRANTY INFORMATION FILL OUT AND RETAIN THIS PORTION FOR YOUR RECORDS Model(s) _________________________ Serial No(s).:_____________________Date of Purchase __________________________________________________Purchased From __________________________________________________Address ___________________...

Telex PST-170 - Manual

Table of Contents:

Summary

Other Telex Models