Telex ICW-3 - Manual
Telex ICW-3 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 3 – SPECIFICATIONS; Overall; Internal Panel Microphone:; Electret: 15 mv @ 1 kHz, typical into 1000 ohms source impednace; Options; UNPACKING & INSPECTION; the items listed next to Figure 1.; RECOMMENDED ITEMS
- Page 4 – INSTALLATION
- Page 5 – VOX CIRCUIT ADJUSTMENT; middle of their adjustment range.
- Page 6 – OPERATION; Operator Side
INSTALLATION & OPERATION
INSTRUCTIONS
ICW-3 WINDOW INTERCOM
9350-7686-000 Rev. G 11/2002
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
SPECIFICATIONS Overall Power Requirement: 12 to 15 VDC, 150 mA nominal System Frequency Response: 200 to 4.5 kHz ±3 dBEnvironmental: -20 to 55°C, 0 to 90% Humidity, non-condensing Outputs External Speaker: 2 W: 100 dB SPL @ 1 foot @ 1 kHz, C weighting Internal Speaker: 2 W: 100 dB SPL @ 1 foot @ 1 k...
INSTALLATION 1. Remove the two screws (one on each side) holding the mounting plate to the operator assembly. (See Figure 3) 2. Measure and identify the location where the intercom is to be mounted. 3. Attach the mounting template to the window (customer assembly side) being sure to center the appro...
Figure 3 - Customer and operator assemblies. Figure 4 - Mounting template. Figure 5 - Customer side mounted. Figure 6 - Connecting customer and operator assemblies prior to final mounting. VOX CIRCUIT ADJUSTMENT 1. Locate the two VOX pots: VOX1 and VOX2. They are located on the operator assembly sid...
