Telex ANR TM 500 - Manual

Telex ANR TM 500

Telex ANR TM 500 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
Page: / 12

Table of Contents:

  • Page 3 – Gen eral De scrip tion; Fitting and Com fort:
  • Page 4 – HEADSET OPERATION; Connect the headset as shown in Figure 2.
  • Page 5 – The boom microphone requires a bias voltage of 8-16 VDC through 470; Figure 4: Microphone Gain Adjustment
  • Page 6 – BATTERY MODULE BATTERY INSTALLATION; Replace the battery door.; OPTIONAL AIRCRAFT POWER SUPPLY MODULE; Figure 5: Battery Installation
  • Page 7 – Specifications; monaural mode; Microphone and Amplifier:; Frequency Response: 300 to 5 kHz
  • Page 8 – OR DERING IN FOR MA TION; Prod uct
  • Page 10 – CUSTOMER SERVICE; For information or technical assistance, call or write to Telex at:
  • Page 11 – Notes
Loading the manual

Telex

®

Op er ating In struc tions

Air man ANR

™

500

Head set

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - Gen eral De scrip tion; Fitting and Com fort:

Gen eral De scrip tion The Telex Airman ANR™500 Active Noise Reduction headset combines designfeatures of a lightweight headset with the advanced techniques of electronic noisereduction. The result is a comfortable light-weight headset that provides goodelectronic reduction of low frequency ambient ...

Page 4 - HEADSET OPERATION; Connect the headset as shown in Figure 2.

HEADSET OPERATION 1. Connect the headset as shown in Figure 2. 2. Rotate the entire boom to wear the microphone on either the right or left sideof the head. 3. With the Airman ANR  500 headband resting securely on the top of the head, check that the ear cups are centered over the ears. Proper perfo...

Page 5 - The boom microphone requires a bias voltage of 8-16 VDC through 470; Figure 4: Microphone Gain Adjustment

Microphone Gain Adjustment The microphone gain has been factory-adjusted to the nominal level requiredfor normal radio operation and should normally not require adjustment. Ifneeded, adjustment by a qualified avionics technician is recommended. Toaccess the microphone gain, insert a small phillips h...

Other Telex Models

All Telex Other