Teledex SIP LD4100 - Manual

SIP LD4100/4200 Series User Guide

WHEN USING YOUR TELEPHONE EQUIPMENT, BASIC SAFETY
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK AND INJURY TO PERSONS, INCLUDING
THE FOLLOWING:
1. READ AND UNDERSTAND ALL INSTRUCTIONS.
2. FOLLOW ALL WARNINGS AND INSTRUCTIONS MARKED ON

THE PRODUCT.

3. UNPLUG THE PRODUCT FROM THE WALL OUTLET BEFORE

CLEANING. DO NOT USE LIQUID CLEANER OR

AEROSOLCLEANERS. USE A DAMP CLOTH FOR CLEANING.

4. DO NOT USE THIS PRODUCT NEAR WATER; FOR EXAMPLE NEAR

A BATHTUB, WASH BOWL, KITCHEN SINK OR LAUNDRY TUB, IN

A WET BASEMENT, OR NEAR A SWIMMING POOL.

5. DO NOT PLACE THIS PRODUCT ON AN UNSTABLE CART, STAND

OR TABLE. THE PRODUCT MAY FALL, CAUSING SERIOUS DAMAGE

TO THE PRODUCT.

6. SLOTS AND OPENINGS IN THE CABINET AND THE BOTTOM ARE

PROVIDED FOR VENTILATION, TO PROTECT IT FROM

OVERHEATING. THESE OPENINGS MUST NOT BE BLOCKED OR

COVERED. THE OPENINGS SHOULD NEVER BE BLOCKED BY

PLACING THE PRODUCT ON A BED, SOFA, RUG OR ANY OTHER

SIMILAR SURFACE. THIS PRODUCT SHOULD NEVER BE PLACED

NEAR OR OVER A RADIATOR OR HEAT REGISTER. THIS

PRODUCT SHOULD NOT BE PLACED IN A BUILT-IN INSTALLATION

UNLESS PROPER VENTILATION IS PROVIDED.

7. NEVER PUSH OBJECTS OF ANY KIND INTO THIS PRODUCT

THROUGH CABINET SLOTS AS THEY MAY TOUCH DANGEROUS

VOLTAGE POINTS OR SHORT OUT PARTS THAT COULD RESULT IN

A RISK OF FIRE OR ELECTRIC SHOCK. NEVER SPILL LIQUID OF ANY

KIND ON THE PRODUCT.

8. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT DISASSEMBLE

THIS PRODUCT, BUT TAKE IT TO QUALIFIED SERVICE PERSONNEL

WHEN SOME SERVICE OR REPAIR WORK IS REQUIRED. OPENING

OR REMOVING COVERS MAY EXPOSE YOU TO DANGEROUS

VOLTAGES OR OTHER RISKS. INCORRECT REASSEMBLY CAN CAUSE

ELECTRIC SHOCK WHEN THE APPLIANCE IS SUBSEQUENTLY USED.

9. UNPLUG THIS PRODUCT FROM THE WALL OUTLET AND REFER

SERVICING TO QUALIFIED SERVICE PERSONNEL UNDER THE

FOLLOWING CONDITIONS:

– WHEN THE POWER SUPPLY CORD OR PLUG IS DAMAGED

OR FRAYED.

– IF LIQUID HAS BEEN SPILLED INTO THE PRODUCT.

– IF THE PRODUCT HAS BEEN EXPOSED TO RAIN OR WATER.

– IF THE PRODUCT DOES NOT OPERATE NORMALLY BY

FOLLOWING THE OPERATING INSTRUCTIONS. ADJUST ONLY

THOSE CONTROLS THAT ARE COVERED BY THE OPERATING

INSTRUCTIONS, AS IMPROPER ADJUSTMENT OF OTHER

CONTROLS MAY RESULT IN DAMAGE AND WILL OFTEN

REQUIRE EXTENSIVE WORK BY A QUALIFIED TECHNICIAN

TO RESTORE THE PRODUCT TO NORMAL OPERATION.

– IF THE PRODUCT HAS BEEN DROPPED OR THE CABINET HAS

BEEN DAMAGED.

– IF THE PRODUCT EXHIBITS A DISTINCT CHANGE IN

PERFORMANCE.

10. AVOID USING A TELEPHONE (OTHER THAN A CORDLESS TYPE)

DURING AN ELECTRICAL STORM. THERE MAY BE A RISK OF

ELECTRIC SHOCK FROM LIGHTNING.

NOTICES

REQUIREMENTS OF PART 15 - FCC RULES

NOTE:

This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: a) move
the telephone away from the receiver; b) consult the dealer or an
experienced radio/TV technician for help. Any changes made by the
user not approved by the manufacturer can void the user’s authority
to operate the telephone.

IMPORTANT SAFETY INSTRUCTIONS

For Models

SIP LD4105S, SIP LD4110S
SIP LD4205S, SIP LD4210S