Tektronix 200E - Manual
Tektronix 200E – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Removing the old boards; Remove the top-rear and rear cabinet panels.
- Page 4 – Note; Lift out the engine control board.
- Page 5 – SIMM installation on the new image processor board; Installing the RAM SIMM.; Insert the RAM SIMM in connector J7 (; Installing the Ethernet card.; Insert the Ethernet card in connector J30 (
- Page 6 – New image processor install; Slide the new image processor board into its card cage slot.
- Page 8 – Return the old boards to Tektronix; Write the printer Õs serial number on the shipping return label.
Copyright
©
1995 by Tektronix, Inc.. All rights reserved.
063-1865-AA
Instruction Sheet
Phaser
¨
200e
Phaser
¨
200i
Phaser
¨
220e
Upgrading a Phaser
¨
200e, 200i or 220e printer
to a Phaser
¨
240
This kit contains the components necessary to upgrade a Phaser 200e, 200i or 220e to a Phaser 240 Color
Printer. Generally, this involves replacing the printer Õs old image processor board with a new image
processor board. In the case of the Phaser 200e and 200i, the printer Õs engine control board must also be
replaced with a new engine control board included in this kit. In all cases, the unused or replaced
components must be returned to Tektronix. This upgrade should only be installed by qualiÞed service
personnel.
Kit contents
■
Phaser 240 image processor board
■
print engine controller board
■
8-Mbyte RAM SIMM
■
Ethernet card (Option P1)
Static electricity precautions
■
Plug in the ground adapter (003-1501-00) in an AC outlet. Connect the
anti-static mat (006-7056-00) to the adapter Õs groundplug.
■
Put on your anti-static wrist strap and connect it to the anti-static mat.
■
Leave the printer plugged into its power outlet; this preserves a
ground path for static discharges.
■
Touch the printer's bare metal frame often to discharge static
electricity from your body.
■
Handle the circuit board(s) by their edges only.
■
Do not lay the board(s) on a metal surface.
■
Avoid wearing nylon or polyester clothing; they generate static
electricity.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨ 240 Removing the old boards 1. Power down the printer. Leave the power cord plugged in to provide a ground path for static discharges. Remove the interface cables. 2. Remove the top-rear and rear cabinet panels. 3. Remove the screws secur...
Note In the next step, it is only necessary to remove the old engine control board from a Phaser 200e or Phaser 200i Color Printer. 8. Disconnect the wiring harnesses leading to the engine controlÊboard. 9. Lift out the engine control board. Card cage Disconnectharnesses 31865-02 Lift out engine boa...
5 Upgrading a Phaser¨ 200e, 200i or 220e printer to a Phaser¨ 240 SIMM installation on the new image processor board 1. If installed, remove the font module by spreading the pawls at each end of the font module connector securing the module in place. 2. Installing the RAM SIMM. Insert the RAM SIMM i...
