Page 4 - Contents; iPod; DO NOT MOVE THE UNIT DURING PLAYBACK; Before Use
4 Contents Thank you for choosing TEAC. Read this manualcarefully to get the best performance from thisunit. Important Safety Instructions. . . . . . . . . . . . . . . . . . . 2 Before Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Contents . . . . . . . . . . . . . . . . . . ...
Page 6 - Discs which can be played on this unit:; Discs
6 Discs which can be played on this unit: • Conventional audio CDs bearing the COMPACT DISC DIGITAL AUDIO logo on the label: • Properly finalized CD-R and CD-RW discs• MP3 CDs Note: < Depending on the quality of the disc and/or thecondition of the recording, some CD-R/CD-RWdiscs may not be playab...
Page 8 - Connection 1; Subwoofer
8 CAUTION: < Switch off the power to all equipment before making connection. < Read the instructions of each component you intend to use with this unit. < Be sure to insert each plug securely. To prevent hum and noise, avoid bundling thesignal interconnection cables together with the AC pow...
Page 9 - How to connect speakers:
9 4. Make sure it is fastened firmly by pulling the cable lightly. Subwoofer C o n n e c t a s u b w o o f e r u s i n g a c o m m e r c i a l l y -available RCA cable.Use a subwoofer with built-in amplifier referred toas a “powered subwoofer”. TAPE/AUX1/AUX2 jacks Analog 2-channel audio signal is i...
Page 10 - Connection 2; TV or Monitor
10 S-VIDEOIN VIDEO IN F I J G H Connection 2 TV or Monitor Dock
Page 11 - iPod Dock; To disconnect the Dock:; VIDEO OUT terminal
11 iPod Dock Connect the Dock to the iPod port. < Make sure the label side of the plug is up. < Securely insert the plug until a slight “click” isheard. To disconnect the Dock: Squeeze both sides of the plug and pull. VIDEO OUT terminal This terminal outputs video signal from iPod.Use an RCA (...
Page 12 - AM Indoor Loop Antenna; AM Outdoor Antenna; Connecting Antennas
12 AM Indoor Loop Antenna The high-performance AM loop antenna providedwith this unit is sufficient for good reception inmost areas.To stand the loop antenna on a surface, fix theclaw to the slot in the antenna base. C o n n e c t t h e l o o p a n t e n n a ’ s w i r e s t o t h e A Mantenna termin...
Page 13 - FM Indoor Antenna; FM Outdoor Antenna
13 FM Indoor Antenna Connect the lead-type FM antenna to the FM 75 Ω socket, extend the lead and tune the tuner toyour favorite station (see page 33). Adjust thea n t e n n a i n a s u i t a b l e l o c a t i o n l i k e a w i n d o wframe or wall until the reception is best and thenaffix the antenn...
Page 14 - Identifying the Parts 1; H G
14 Identifying the Parts 1 A E B C D F H G I J K L M N O P
Page 16 - Identifying the Parts 2
16 Note: To simplify explanations, instructions in this manualrefer to the names of the buttons and controls onthe front panel only. Associated controls on theremote control will also operate similarly. < Following buttons don’t work on the CR-H227i. FUNCTION, AUTO TUNE, ENTER, INFO Identifying t...
Page 17 - IMPORTANT; Buttons for CD and iPod
17 To use the numeric buttons in CD mode or inTUNER mode, you have to press the CD button ort h e T U N E R b u t t o n b e f o r e h a n d t o s w i t c h t h efunction of the remote control unit from TUNER toCD (or from CD to TUNER). If the remote control unit doesn’t work, press theCD button or t...
Page 18 - Remote Control Unit; Battery Replacement; Battery Installation
18 Remote Control Unit Battery Replacement If the distance required between the remote controlunit and main unit decreases, the batteries areexhausted. In this case replace the batteries withnew ones. Precautions concerning batteries < Be sure to insert the batteries with correct positive“ + ” an...
Page 19 - Basic Operation 1
19 Basic Operation 1 Press the STANDBY/ON button to turn the uniton. S e l e c t a s o u r c e b y p r e s s i n g t h e S O U R C Ebutton. E a c h t i m e t h e S O U R C E b u t t o n i s p r e s s e d , t h esource changes as follows: < To listen to an external source connected to theAUX IN ja...
Page 20 - Sleep Timer; Muting; CAUTION; Basic Operation 2
20 Sleep Timer T h e p o w e r c a n b e s w i t c h e d o f f a f t e r a s p e c i f i e damount of time.Press the SLEEP button repeatedly until desired timeappears on the display. SLEEP 90 (80, 70 ... 10) The power will be switched off 90 (80, 70 ... 10)minutes later. (normal display) The sleep t...
Page 21 - Available menu item and options
Available menu item and options BASS Adjusts the level of low frequency sound range.The level can be adjusted from –10 to +10. TREBLE Adjusts the level of high frequency sound range.The level can be adjusted from –10 to +10. BALANCE Adjusts the balance of the volume level betweenleft and right speak...
Page 22 - Getting started with iPod; Remove the adapter from the Dock of the CR-; Insert the adapter into the Dock of the CR-; Compatible iPod Software
22 Getting started with iPod The CR-H227i comes mounted with an adapter foriPod with color display (40GB, 60GB), “60GB (color) +Photo 40GB/60GB”. To play your iPod through theC R - H 2 2 7 i , y o u h a v e f i r s t t o c h e c k i f t h e f a c t o r ymounted adapter fits your model of iPod. If it...
Page 23 - Listening to iPod 1; Insert the iPod into the Dock of the CR-H227i.; To start or pause playback
23 Listening to iPod 1 Press the iPod button of the remote controlunit (or repeatedly press the SOURCE button)to select “iPod”. If no iPod is docked, “Unplugged” appears on thedisplay.If an iPod is already docked, playback will start. Insert the iPod into the Dock of the CR-H227i. “The iPod is conne...
Page 24 - Listening to iPod 2; Click Wheel Mode; Search for a part of a track
24 During playback, press the SKIP button ( . or / ) repeatedly until the desired track is found. T h e s e l e c t e d t r a c k w i l l b e p l a y e d f r o m t h ebeginning. < When the . button is pressed during playback, the track being played will be played from theb e g i n n i n g . T o r...
Page 25 - To activate the repeat mode
25 To activate the shuffle mode During playback, press the SHUFFLE button tochange the shuffle mode.E a c h t i m e t h e S H U F F L E b u t t o n i s p r e s s e d , t h eSHUFFLE setting of iPod is changed as follows: Shuffle Songs, Shuffle Albums, (off) < In the Click Wheel mode, if iPod is se...
Page 26 - Press the PLAY button (
26 Press the OPEN/CLOSE button ( L ) to close the tray. When an audio CD is loaded: The total number of the tracks and total play timeof the disc is displayed. When an MP3 or WMA disc is loaded: The total number of files of the disc is displayed. Press the PLAY button ( G ). Playback starts from the...
Page 27 - To stop playback
27 To suspend playback temporarily(pause mode) P r e s s t h e P a u s e b u t t o n ( J ) d u r i n g p l a y b a c k . Playback stops at the current position. To resumeplayback, press the PLAY button ( G ) or the Pause button ( J ). To stop playback Press the STOP button ( H ) to stop playback. IM...
Page 29 - Designate the point at which repeat playback; Repeat Playback
29 Each time the REPEAT 1/ALL button is pressed, themode is changed as follows: When a CD is loaded: When an MP3/WMA disc is loaded. < If one of the following buttons is pressed, repeatmode will be canceled: STOP, SOURCE (AUX, TUNER, TAPE, iPod) , BAND, OPEN/CLOSE, STANDBY/ON Repeat 1 RPT Folder ...
Page 30 - Repeat this step to program more tracks.
30 Select a track using the numeric buttons. 2 Up to 32 tracks can be programmed in the desiredorder. Press the PROGRAM button in the stop mode. 1 When programming has been finished, pressthe PLAY button ( y ) to start programmed playback. 3 Programmed Playback (CD/MP3/WMA) < If the numeric butto...
Page 32 - date
32 elapsed time of the current track remaining time of the current track Time Display (CD) When playing back an audio CD, each time the TIMEbutton is pressed the display changes as follows: Shuffle Playback (CD/MP3/WMA) Press the SHUFFLE button in the stop or playmode. “Random play” appears on the d...
Page 33 - FM MODE Button; Stereo; Listening to the Radio; Select AM or FM by pressing the BAND button.
33 Press the TUNING button to tune in a station. In the Auto tune mode, the unit starts searching fora station. When a station is tuned in, the tuningprocess will stop automatically.Repeat this step until the station you want to listento is found. < If you want to stop the tuning process, press t...
Page 34 - Preset Automatically; Preset Manually; Press the MEMORY button.; Preset Tuning
34 You can store up to 30 FM and 30 AM stations. Preset Automatically Select AM or FM by pressing the BAND button. Press the MEMORY button for more than 3seconds. Up to 30 of the best received stations in your areawill be stored automatically. 2 1 Preset Manually Tune in a station you want to listen...
Page 35 - How to select preset stations; To store more stations, repeat steps
35 How to select preset stations Select AM or FM by pressing the BAND button. Select “Preset tune” using the TUNING MODEbutton. S e l e c t a p r e s e t c h a n n e l u s i n g t h e P R E S E Tbuttons or the numeric buttons. < If the numeric buttons don’t work, first press theTUNER button, and ...
Page 36 - RDS works on the FM waveband in Europe only.; RDS
36 The Radio Data System (RDS) is a broadcasting servicewhich allows stations to send additional informationalong with the regular radio programme signal. RDS works on the FM waveband in Europe only. Tune in an FM RDS station (see page 33). Press the RDS MODE button (or the INFO/RDSbutton of the rem...
Page 37 - Select FM by pressing the BAND button.; Press the ENTER button.; Press the TUNING button.
37 RDS (PTY Search) A station can be searched by this function. Select FM by pressing the BAND button. Press the RDS MODE button for more than 3seconds. “RDS PROGRAM TYPE” appears on the display. Select the desired programme type using theTUNING button. You can select from 31 kinds.The programme typ...
Page 39 - Press the TIME MODE button once.; Press the SKIP buttons to set the current hour.; Setting the Clock
39 Press the ENTER button. The “minute” value blinks. P r e s s t h e S K I P b u t t o n s t o s e t t h e c u r r e n tminute. Press the ENTER button. The clock starts from 00 seconds. 5 4 3 Press the TIME MODE button once. Each time the TIME MODE button is pressed, themode is changed as follows: ...
Page 40 - Press the TIME MODE button twice.; Setting the Timer
40 Setting the Timer < The unit can be programmed to turn on and off ata specified time. < Adjust the clock before setting the timer. < When no action is taken for 1 minute, the timersetting mode will be cancelled. Press the TIME MODE button twice. “On time” appears on the display, and the ...
Page 41 - To turn on the timer; Prepare the source and adjust the volume.; To turn off the timer
41 To turn on the timer A f t e r s e t t i n g t h e t i m e r , p r e s s t h e T I M E Rbutton to turn the timer on. The timer indicator “ ” lights on the display. Prepare the source and adjust the volume. When the source is set to “iPod”, insert an iPod.When the source is set to “CD”, set a disc...
Page 42 - Troubleshooting; General; No power; CD Player; There is no sound even if the PLAY button (; iPod Player; Cannot insert the iPod.; Tuner
42 Troubleshooting If you have problems with your system, look throught h i s c h a r t a n d s e e i f y o u c a n s o l v e t h e p r o b l e myourself before calling your dealer or TEAC servicecenter. General No power e Check the connection to the AC power supply.Check and make sure the AC source...
Page 43 - FM Section; CD Player Section; Specifications; Standard Accessories
43 AMPLIFIER Section Output Power . . . . .25 W/ch (6 ohms, 0.5 %,1 kHz) Input Sensitivity . . . . . . . . . . . . . 400 mV/47 kohmsFrequency Response 20 Hz to 60,000 Hz (+1/–3 dB) TUNER Section FM Section Tuning Range . . . . . . . . 87.50 MHz to 108.00 MHz (50 kHz steps) Signal-to-Noise Ratio . . ...
