TEAC 36XX - Manual
TEAC 36XX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Table of Contents; INSTALLATION MANUAL; REMOTE VEHICLE STARTER
- Page 4 – Recommended Installation Procedures; Under Hood Connections -; BE CAREFUL; Mounting The Control Module -; Never; Installing the External Long Range Antenna -; BLUE; Security
- Page 5 – Wiring Diagram- 35xx Series; Starter Output; Status Led’s
- Page 6 – Module Side View; 0amp relayed output; . To change the output of the wire access the jumpers by sliding; nd Starter; If the jumper is in position #2 the output on the white wire will be; nd Accessory; If the jumper is in position #3 the output on the white wire will be; Second Ignition; Jumpers; Not Available; Note; : If the Temperature Sensor is installed the Cold Start Mode will
- Page 7 – Selectable output for 2nd Ign, acc or starter.; 4 pin connector; Programmable; Pin Power Connector
- Page 8 – 4 Pin Connector - Continued From Previous Page; Black
- Page 9 – - Connect All Of the Following Wires; OFF
- Page 10 – Manual Transmission “M” Models; all
- Page 11 – Auto Tach Learn; Your Basic Install Is Complete!; park lights are flashing a diagnostic code. See diagnostic chart.
- Page 12 – Important Tach Notes; BRAKE; Press and hold the brake pedal.
- Page 13 – Entering Program Mode; Press and release; Program Menus
- Page 14 – System Reset; System is now reset to factory defaults
- Page 15 – Menu 1- User Settings
- Page 16 – Menu 2- Additional Settings
- Page 17 – Menu 3- Starter Settings
- Page 18 – - Continued From Previous Page
- Page 19 – Menu 4- Tach Settings
- Page 20 – ENTERING SERVICE MODE; Ser vice Mode
- Page 21 – Transmitter Programming; All the transmitters; Batter y Replacement
- Page 22 – Negative Type Door Locks 250ma
- Page 23 – DIAGNOSTICS; Wire / Reverse Polarity Type Door Locks; When installing relays always use a fused power source.
- Page 24 – PARK LIGHTS STATUS LED; DIAGNOSTIC MEMORY; LED Flashes; Maximum four events, four honks; Clear Diagnostic Memory.
Covers All 35xx and 36xx Series Remote Starters
-The system must be placed into Service Mode before any service work is started on
the vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done.
The manufacturer accepts no liability or responsibility for accidental starting of the
vehicle.
- CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
REMOTE STARTERS
ü
CAR ALARMS
INSTALL GUIDE
Technical Suppor t 866-698-5872 ext 0
Suppor t@ultrastar ters.com
WWW.ULTRASTARTERS.COM
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Table of Contents INSTALLATION MANUAL REMOTE VEHICLE STARTER Page 2 Table of Contents Page 2 Pre-Installation Page 3 ComponentsFeature ListPre-Installation Installation Procedures Page 4 Wiring Diagrams Page 5-6 Wire Description Page 7-8 6 Pin Connector14 Pin ConnectorAuxiliary ConnectorsJumper Posi...
Recommended Installation Procedures Under Hood Connections - Route the hood pin and tach wire through the firewall into the engine compartment. If possible route the wires through a factory rubbergrommet. If drilling a hole through the firewall, BE CAREFUL . Always check for obstructions on both sid...
REMOTE VEHICLE STARTER INSTALLATION MANUAL Page 5 Wiring Diagram- 35xx Series Temperature Sensor Input (LT Series) Starter Output (+) 30amp Output (+) 30amp Output (+) 30amp Input (+) 30amp Input (+) 30amp Output (-)500ma Output (-)500ma Output (-)500ma Output (-)500ma Output (-)500ma Output Negativ...
