Page 2 - C O N T E N T S
C O N T E N T S NAMES OF PARTS INDOOR UNIT DISPLAY OPERATING INSTRUCTIONS INSTALLATION MANUAL MAINTENANCE TROUBLESHOOTING EMERGENCY FUNCTION & AUTO-RESTART FUNCTION REMOTE CONTROLLER ................................................................................................................4...
Page 3 - SAFETY RULES AND RECOMMENDATIONS FOR THE INSTALLER; he ratings of the fuse installed in the built
SAFETY RULES AND RECOMMENDATIONS FOR THE INSTALLER T he ratings of the fuse installed in the built in control unit are 4A / 250V . O nly use the air conditioner as instructed in this booklet. T he appliance must be installed in accordance with applicable national regulations. B efore accessing the t...
Page 4 - SAFETY RULES AND RECOMMENDATIONS FOR THE USER; leaning and maintenance must be carried out; nhook the automatic switch if you foresee
SAFETY RULES AND RECOMMENDATIONS FOR THE USER C leaning and maintenance must be carried out by specialized technical personnel. In any case disconnect the appliance from the mains electricity supply before carrying out any cleaning or maintenance. I f the appliance gives off smoke or there is a smel...
Page 5 - SAFETY RULES AND PROHIBITIONS; o not obstruct the air inlet or outlet of the
SAFETY RULES AND PROHIBITIONS 3 D o not obstruct the air inlet or outlet of the indoor or the outdoor unit.The obstruction of these openings causes a reduction in the operative efficiency of the conditioner with possible consequent failures or damages. T his appliance is not intended for use by pers...
Page 6 - NAMES OF PARTS; Indoor unit
4 NAMES OF PARTS Air filter Air deflector and flap Emergency button Front panel Air inlet Air outlet Indoor unit Outdoor unit Note: This figure shown may be different from the actual object. Please take the latter as the standard. Mounting plate Air outlet Air inlet Drainage pipe Wiring cover Connec...
Page 7 - INDOOR UNIT DISPLAY; Led; SLEEP mode
INDOOR UNIT DISPLAY 5 The shape and position of switches and indicators may be different according to the model, but their function is the same. 2 No. Led Function 1 2 3 Temperature display (if present)/Error code (1) Lights up during Timer operation when the air conditioner is operational (2)Displa...
Page 8 - EMERGENCY FUNCTION & AUTO-RESTART FUNCTION; front panel
EMERGENCY FUNCTION & AUTO-RESTART FUNCTION 6 The shape and position of the emergency button may be different according to the model, but their function is the same. Emergency button The emergency button is located on E-box coverof the unit under the front panel. front panel Open and lift the fro...
Page 9 - REMOTE CONTROLLER; For inverter models
7 REMOTE CONTROLLER For ON/OFF models For inverter models
Page 10 - MODE; TURBO; FAN; Remote controller buttons
8 REMOTE CONTROLLER The shape and position of buttons and indicators may vary according to the model, but their function is the same. The display and some functions of the remote control may vary according to the model. The unit confirms the correct reception of each button with a beep. To turn on/o...
Page 11 - Meaning; MUTE indicator; GENERATOR MODE indicator
9 REMOTE CONTROLLER Remote controller DISPLAY, meaning of symbols on the liquid crystal display 1 2 3 4 5 6 7 8 9 10 11 12 13 14 AUTO MODE indicator COOLING MODE indicator DRY MODE indicator FAN MODE indicator HEATING MODE indicator TIMER indicator AUTO FAN indicator FAN SPEED indicator SLEEP MODE i...
Page 12 - Replacement of Batteries
10 Replacement of Batteries Remove the battery cover plate from the rear of the remote controller, by sliding it in the direction of the arrow.I nstall the batteries according the direction (+and -)shown on the Remote Controller.Reinstall the battery cover by sliding it into place. Use 2 LRO 3 AAA (...
Page 13 - OPERATING INSTRUCTIONS; Turn ON / Turn OFF the air conditioner
OPERATING INSTRUCTIONS Filter Heat Fan Exchanger 11 The direction of the air outlet is motorized up and down by flaps, and manually moved right and left by the vertical deflectors, for some models, the vertical deflectors could becontrolled by motor as well. The air sucked by the fan enters from the...
Page 14 - HEATING MODE; AUTO MODE
OPERATING INSTRUCTIONS HEATING MODE DRY MODE The heating function allows the air conditi-oner to heat the room. To activate the heating function ( HEAT ) , press the MODE button until the symbol appears on the display. With the button or set a temperature higher than that of the room. In HEATING ope...
Page 15 - Horizontal Flaps; AIR FLOW CONTROL; Flaps; Change the fan speed; Flashing
13 OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Horizontal Flaps flapmovement Vertical Deflectors AIR FLOW CONTROL Flaps manually, the delicate mech-anism might seriously damaged! Never poke fingers, sticks or other objects in the air inlet or outlet vents. Such accidental contact with liveparts mi...
Page 16 - I FEEL function; I FEEL; Turbo function; Press again to cancel this function.
14 OPERATING INSTRUCTIONS GENTLE WIND (Optinal) In this mode the appliance will close its vertical louvers, the air flow through the holesof louvers, the room is cool but no winds. Press the GENTLE WIND button shortly, the appears on the display, and the appliance will run in GENTLE WIND mode.Press ...
Page 17 - SLEEP MODE; Pre-setting automatic operating program.; ECO MODE
OPERATING INSTRUCTIONS 15 SLEEP MODE Pre-setting automatic operating program. After 10 hours running in sleep mode, the air conditioner will change to the previous setting mode. Press SLEEP button and hold for 2s to activate the sleep mode, and appears on the display. Press and hold for 2s again to ...
Page 18 - LED display light ON/OFF; We suggest operate this function once every 3 months.
OPERATING INSTRUCTIONS 1 6 LED display light ON/OFF Press DISPLAY button and hold for 2s to turn on/off the indoor LED display light. HEALTH function (Optional) Press HEALTH button to active / exit the health functions such as ion generator/ plasma etc Note: Health function is not available when the...
Page 19 - TIMER; use the
OPERATING INSTRUCTIONS 17 TIMER MODE----SET TIMER OFF TIMER To set the air conditioner switching-off automatically. With the AC off, press the Timer button and use the and buttons to set the desired amount of time before the AC turns on. Press the timer button again to start the countdown. When the ...
Page 20 - I S E T f u n c t i o n ( O p t i o n a l ); , i t w i l l r e t u r n
OPERATING INSTRUCTIONS In each mode of COOLING/HEATING/FAN/DRY, adjust the temperature(COOLING/HEATING), fan speed (COOLING/HEATING/FAN)and swing as your favourite, then keep pressing "I SET" button over 3 seconds until "AU" appears on the display and the background of display change...
Page 21 - Operating Temperature; action, you need to wait for about; For T1 Climate
1 9 The air conditioner is programmed for comfortable and suitable living conditions as belowif used outside the conditions, certain safety protection features might come into effect., OPERATING INSTRUCTIONS Operating Temperature Fix air conditioner: MODE Temperature Room temperature Outdoortemperat...
Page 22 - Important Considerations; I n s t a l l a t i o n m a n u a l
2 0 INSTALLATION MANUAL---Important considerations for R32/R290 Important Considerations T h e a i r c o n d i t i o n e r y o u b u y m u s t b e i n s t a l l e d b y p r o f e s s i o n a l p e r s o n n e l a n d t h e I n s t a l l a t i o n m a n u a l i s u s e d o n l y f o r t h e p r o f e...
Page 23 - The maximum charge and the required minimum floor area; F o r t h e a p p l i a n c e s w i t h a c h a r g e a m o u n t; L F L; L F L; Category
INSTALLATION MANUAL---Important considerations for R32/R290 2 1 The maximum charge and the required minimum floor area 3 3 3 m = (4 m ) x L F L , m = ( 2 6 m )) x L F L , m = ( 1 3 0 m ) x L F L 1 2 3 3 3 3 W h e r e L F L i s t h e l o w e r f l a m m a b l e l i m i t i n k g / m R 2 9 0 L F L i s...
Page 24 - Installation Safety Principles; Open Flames Prohibited; Installation Safety; Refrigerant Leak Detector
2 2 INSTALLATION MANUAL---Important considerations for R32/R290 Installation Safety Principles 1. Site Safety 2. Operation Safety Open Flames Prohibited Ventilation Necessary Open Flames Prohibited Mind Static Electricity Must wear protective clothing and anti-static gloves Don`t use mobile phone 3....
Page 25 - Special Tools; Tool Name
INSTALLATION MANUAL---Important considerations for R32/R290 2 3 Special Tools Tool Name Requirement(s) for Use Mini Vacuum Pump Filling Device Leak Detector Concentration Detector Pressure Gauge Fire Extinguisher I t s h o u l d b e a n e x p l o s i o n - p r o o f v a c u u m p u m p ; c a n e n s...
Page 26 - cm; Installation Diagram; INDOOR UNIT; Select a site where the condensed water can be easily drained; re
INSTALLATION MANUAL---Selecting the Installation Place Condensed water drain pipe 15cm 15cm 1 5 cm Sleeve insulating covering electrical cable Mounting plate Do not install the outdoor unit near sources of heat, steam or flammable gas. Do not install the unit in too windy or dusty places. Do not ins...
Page 27 - Installation of the mounting plate; 5) in the wall at a slight
INSTALLATION MANUAL---Installation of the Indoor unit 5mm Note : Keep the drain pipe down towards the directionof the wall hole, otherwise leakage may occur. Before starting installation, decide on the position of the indoor and outdoor units, taking into account the minim-um space reserved around t...
Page 28 - Indoor unit condensed water drainage
INSTALLATION MANUAL---Installation of the Indoor unit 3 2 1 The piping can be run in the 3 directions indicated bynumbers in the picture . When the piping is run in direction 1or 3, cut a notch along the groove on the side of the indoor unit with a cutter.Run the piping in the direction of the wall ...
Page 29 - INSTALLATION OF THE INDOOR UNIT; Covered by vinyl tape; S t e p 4 t o 7; . R e p l a c e t h e b r a c k e t o f m o u n t i n g p l a t e .
INSTALLATION MANUAL---Installation of the Indoor unit INSTALLATION OF THE INDOOR UNIT refrigerant pipe refrigerant pipe insulation sleeve connection cable 1(for heat-pump) connection cable Probe cable(for heat-pump) Condensed waterdrain pipe Covered by vinyl tape After having connected the pipe acco...
Page 30 - The outdoor unit should be installed on a solid wall and
INSTALLATION MANUAL---Installation of the outdoor unit The outdoor unit should be installed on a solid wall and fastened securely. The following procedure must be observed before co- nnecting the pipes and connecting cables : decide which is the best position on the wall and leave enough space to be...
Page 31 - The appliance must be fitted with means for disconnection
INSTALLATION MANUAL---Installation of the outdoor unit Screw the flare nuts to the outdoor unit coupling with the same tightening procedures described for the indoor unit. connection pipes flare nuts liquid tap gas tap indoor unit protection caps liquid valve gas valve service port nut To avoid leak...
Page 32 - vacuum pump
A i r Va c u u m i z i n g R e f r i g e r a n t P r e s s u r e I n s p e c t i o n A i r - r e t u r n i n g L o w - p r e s s u r e R a n g e o f R e f r i g e r a n t R 2 9 0 : 0 . 4 - 0 . 6 M p a ; A i r - e x h a u s t i n g H i g h - p r e s s u r e R a n g e : 1 . 5 - 2 . 0 M p a ;A i r - r ...
Page 33 - Indoor unit test; BLEEDING
INSTALLATION MANUAL---Installation of the outdoor unit The air and humidity left inside the refrigerant circulat-ion can cause compressor malfunction. After having co-nnected the indoor and outdoor units, bleed the air and humidity from the refrigerant circulation using a va-cuum pump. Refrigerant f...
Page 34 - Pipe length and Additional refrigerant; Maximum Operating Current; Dedicated Distribution Device and Wire for Air Conditioner
INSTALLATION MANUAL---Information for the installer 32 Pipe length and Additional refrigerant Inverter Models capacity (Btu/h) 9k-12k 18k-36K Lenght of pipe with standard charge Maximum distance between indoor and outdoor unit Additional refrigerant charge Max. diff. in level between indoor and outd...
Page 36 - CABLE WIRES SPECIFICATION
INSTALLATION MANUAL---Information for the installer CABLE WIRES SPECIFICATION 34 9k 12k 18k 24k Power supply cable Connection supply cable N (L) 1 N L sectional area 2 1.5mm 2 2.5mm 2 1.5mm 2 1.5mm INVERTER TYPEMODEL capacity (Btu/h) 2 0.75mm 2 0.75mm 2 0.75mm 2 1.5mm 2 2.5mm 2 1.5mm 2 1.5mm 2 1.5mm...
Page 37 - MAINTENANCE
MAINTENANCE 35 L o u v e r B o t t o m p l a t e D e f l e c t o r a s s e m b l y C l e a n t h e f i l t e r s c r e e n Opposite to the direction of takingout the filter screen T a k e o u t t h e f i l t e rs c r e e n fr o m t h e u n i t C l e a n t he f i l t e r s c r e e n wi t hs o a p y w...
Page 38 - TROUBLESHOOTING; MALFUNCTION; I n d o o r t e m p e r a t u r e s e n s o r f a u l t
TROUBLESHOOTING 36 MALFUNCTION Strange odor The appliance does not operate Noise of running water A fine mist comes from the air outlet Insufficient airflow, eitherhot or cold The appliance does not respond to commands The display is off Switch off the air condi- tioner immediately and cut off the p...
