Page 2 - Complete this page for quick reference when service is required:; Date of Installation:; Information found on the data label:; Voltage; 003 Carrier Commercial Refrigeration, Inc.; Taylor Company; a division of Carrier Commercial Refrigeration, Inc.
Complete this page for quick reference when service is required: Taylor Distributor: Address: Phone: Service: Parts: Date of Installation: Information found on the data label: Model Number: Serial Number: Electrical Specs: Voltage Cycle Phase Maximum Fuse Size: A Minimum Wire Ampacity: A E 2003 Carr...
Page 3 - Table of Contents
Table of Contents Model C707 Table of Contents Section 1 To the Installer 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 2 To the Operator 4 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Section 3 Safety 5 . ....
Page 4 - Table of Contents - Page 2; During Cleaning and Sanitizing; civil and criminal penalties.
Model C707 Table of Contents Table of Contents - Page 2 Section 7 Important: Operator Checklist 23 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . During Cleaning and Sanitizing 23 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Troubleshooting Bacterial...
Page 5 - Installer Safety
1 Model C707 To the Installer 131122 Section 1 To the Installer The following information has been included in the manual as safety and regulatory guidelines. For complete installation instructions, please see the Installation Checklist. Installer Safety In all areas of the world, equipment should b...
Page 7 - To the Installer; Beater Rotation; Note: The following procedures should be; Refrigerant
3 Model C707 To the Installer 131021 Appliances that are permanently connected to fixed wiring and for which leakage currents may exceed 10 mA, particularly when disconnected or not used for long periods, or during initial installation, shall have protective devices such as a GFI, to protect against...
Page 8 - To the Operator; Section 2; Compressor Warranty Disclaimer; only the refrigerant specified on the affixed data
4 Model C707 To the Operator 131122 Section 2 To the Operator The Model C707 has been carefully engineered and manufactured to give you dependable operation. This unit, when properly operated and cared for, will produce a consistent quality product. Like all mechanical products, it will require clea...
Page 11 - Operator Parts Identification; Section 4
7 Model C707 Operator Parts Identification 140618 Section 4 Operator Parts Identification Model C707 ITEM DESCRIPTION PART NO. 1 KIT A.- COVER- HOPPER X65368 2 PAN- DRIP 11- 5/8 LONG 027503 3 PIN- RETAINING- HOPPER CVR 043934 4 PANEL- SIDE- LEFT 066722- SP3 5 STUD- NOSE CONE 055987 6 SHIELD- SPLASH ...
Page 12 - Model C707 Single Spout Door and Beater Assembly
8 Model C707 Operator Parts Identification 140618 Model C707 Single Spout Door and Beater Assembly ITEM DESCRIPTION PART NO. 1 DOOR A.- W/BAFFLE X56071- SER 1a BAFFLE A.- LONG 4 IN X50882 2 HANDLE A.- DRAW- WELDED X56246 3 SCREW- ADJUSTMENT 056332 4 O- RING- 1/4 OD X .070W 50 DUROMETER (25 TO BAG) 0...
Page 13 - Brushes
9 Model C707 Operator Parts Identification 110915 Brushes ITEM DESCRIPTION PART NO. 1 BLACK BRISTLE BRUSH 013071 2 DOUBLE END BRUSH 013072 3 WHITE BRISTLE BRUSH (1” x 2”) 013073 4 WHITE BRISTLE BRUSH (3” x 7”) 023316 ITEM DESCRIPTION PART NO. 5 BRUSH- END- DOOR SPOUT SS 039719 6 BRUSH- SET LVB 05010...
Page 14 - Important: To the Operator; Section 5
10 Model C707 Important: To the Operator 140618 Section 5 Important: To the Operator ITEM DESCRIPTION 1 MIX LOW INDICATOR LIGHT 2 MIX OUT INDICATOR LIGHT 3 MIX REFRIGERATION KEY 4 STANDBY KEY 5 WASH KEY ITEM DESCRIPTION 6 AUTO KEY 7 RESET BUTTON - BEATER MOTOR 8 POWER SWITCH (TOGGLE) 9 HOPPER TEMPER...
Page 15 - Symbol Definitions; end without the hole
11 Model C707 Important: To the Operator 130709 Symbol Definitions To better communicate in the International arena, symbols have replaced words on many of our operator switches, function, and fault indicators. Your Taylor equipment is designed with these International symbols. The following chart i...
Page 16 - WASH Key; Do not use metal objects to press the reset; Adjustable Draw Handle
12 Model C707 Important: To the Operator 130709 When the STANDBY key is pressed, the light comes on, indicating the CTR (Cylinder Temperature Retention System) has been activated. In the STANDBY mode, the WASH and AUTO functions are automatically cancelled. The MIX REF function is automatically lock...
Page 17 - Feed Tube Assembly; Long “No Sale” Periods
13 Model C707 Important: To the Operator 130709 Feed Tube Assembly The feed tube assembly serves two purposes. One end of the tube has a hole and the other end does not. Figure 4 ITEM DESCRIPTION PART NO. 1 ORIFICE 022465- 100 2 O- RING- 3/8 OD X .070 W 016137 3 TUBE A.- FEED- SS 5/32 HOLE X29429- 2...
Page 18 - Operating Procedures; Section 6; Assembly; MAKE SURE POWER SWITCH IS IN THE
14 Model C707 Operating Procedures Section 6 Operating Procedures The C707 unit stores mix in a hopper. It has a 3.4 quart (3.2 liter) capacity freezing cylinder and a 20 quart (18.9 liter) mix hopper. This unit uses a feed tube to allow mix to flow into the freezing cylinder. We begin our instructi...
Page 22 - Sanitizing; Note: You have just sanitized the mix hopper and
18 Model C707 Operating Procedures 080715 Sanitizing Step 1 Prepare an approved 100 PPM sanitizing solution (examples: 2- 1/2 gal. [9.5 liters] of Kay- 5 R or 2 gal. [7.6 liters] of Stera- Sheen R ). USE WARM WA- TER AND FOLLOW THE MANUFACTURER’S SPECIFICATIONS. Step 2 Pour the sanitizing solution o...
Page 24 - Priming; fresh; Closing Procedure
20 Model C707 Operating Procedures 140618 Priming Step 1 Place an empty pail beneath the door spout and lower the draw handle. Be sure the prime plug is still in the UP position. Pour two gallons (7.6 liters) of fresh mix into the hopper and allow it to flow into the freezing cylinder. This will for...
Page 25 - Draining Product From the; If local health codes permit the use of rerun; Rinsing; cool; Cleaning
21 Model C707 Operating Procedures 140717 Draining Product From the Freezing Cylinder Step 1 Press the AUTO key, cancelling compressor and beater motor operation. Press the MIX REF key, cancelling the mix hopper refrigeration system. Step 2 Remove the hopper cover and take it to the sink for cleanin...
Page 26 - Disassembly; Be sure the power switch is in the OFF position.; Brush Cleaning
22 Model C707 Operating Procedures 110915 Disassembly Step 1 Be sure the power switch is in the OFF position. Make sure no lights are lit on the control panel. Step 2 Remove the handscrews, freezer door, beater, beater, scraper blades, and drive shaft from the freezing cylinder. Take these parts to ...
Page 27 - Troubleshooting Bacterial Count
23 Model C707 Important: Operator Checklist 080401 Section 7 Important: Operator Checklist During Cleaning and Sanitizing ALWAYS FOLLOW LOCAL HEALTH CODES. Cleaning and sanitizing schedules are governed by federal, state, or local regulatory agencies, and must be followed accordingly. If the unit ha...
Page 28 - Winter Storage
24 Model C707 Important: Operator Checklist 080401 j 6. If your machine is air cooled, check the condensers for accumulation of dirt and lint. Dirty condensers will reduce the efficiency and capacity of the machine. Condensers should be cleaned monthly with a soft brush. Never use screwdrivers or ot...
Page 29 - Troubleshooting Guide; Section 8; PROBLEM
25 Model C707 Troubleshooting Guide Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAGE REF. 1. No product is being dispensed with draw valve open and the machine in the AUTO mode. a. Freeze- up in mix inlet hole. a. Call service technician to adjust the mix hopper temperature. - - - ...
Page 31 - Parts Replacement Schedule; Section 9
27 Model C707 Parts Replacement Schedule 110915 Section 9 Parts Replacement Schedule PART DESCRIPTION EVERY 3 MONTHS EVERY 6 MONTHS ANNUALLY Drive Shaft Seal X Scraper Blade X Freezer Door Gasket X Front Bearing X Draw Valve O- Ring X Prime Plug O- Ring X Feed Tube O- Ring X Air Orifice O- Ring X Wh...
Page 32 - Limited Warranty on Equipment
28 Model C707 Limited Warranty on Equipment 131122 Section 10 Limited Warranty on Equipment TAYLOR COMPANY LIMITED WARRANTY ON FREEZERS Taylor Company, a division of Carrier Commercial Refrigeration, Inc. (“Taylor”) is pleased to provide this limited warranty on new Taylor-branded freezer equipment ...
Page 34 - Limited Warranty on Parts; TAYLOR COMPANY LIMITED WARRANTY ON TAYLOR GENUINE PARTS; No warranty; LIMITED WARRANTY CONDITIONS; location in the unit of original installation.
30 Model C707 Limited Warranty on Parts 131122 Section 11 Limited Warranty on Parts TAYLOR COMPANY LIMITED WARRANTY ON TAYLOR GENUINE PARTS Taylor Company, a division of Carrier Commercial Refrigeration, Inc. (“Taylor”) is pleased to provide this limited warranty on new Taylor genuine replacement co...
Page 36 - The owner; must
32 Model C707 Limited Warranty on Parts LIMITATION OF WARRANTY THIS LIMITED WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ALL OTHER WARRANTIES, CONDITIONS AND/OR REMEDIES UNDER THE LAW, INCLUDING ANY IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THE ORIGINAL OWNE...
Page 37 - Parts List
Section 12 Parts List 33 + Available Separately Model C707 Parts List 140630 DE S CRI P T IO N PART NUM BE R C707 QTY . W ARR. CL AS S RE M ARKS ACCUMULA TOR -C OPPER 2” DI A 10” 047062 1 103 RECEI VER REFRI G ERANT BEARI N G -FRONT 050216 1 000 BEARI N G -REAR SHELL *NI CK. P LA TE 031324 1 000 +GU...
