Page 2 - Complete this page for quick reference when service is required:; Date of Installation:; Information found on the data label:; Voltage; Taylor Company
Complete this page for quick reference when service is required: Taylor Distributor: Address: Phone: Service: Parts: Date of Installation: Information found on the data label: Model Number: Serial Number: Electrical Specs: Voltage Cycle Phase Maximum Fuse Size: A Minimum Wire Ampacity: A E 1999 Carr...
Page 3 - Table of Contents
Model 220 Table of Contents Table of Contents Section 1 To the Installer 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installer Safety 1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Site P...
Page 4 - Table of Contents - Page 2; During Cleaning and Sanitizing
Model 220 Table of Contents Table of Contents - Page 2 Section 7 Important: Operator Checklist 22 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . During Cleaning and Sanitizing 22 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Troubleshooting Bacterial ...
Page 5 - To the Installer; Section 1; Installer Safety; Note: All repairs must be performed by an; Site Preparation; NOT
1 Model 220 To the Installer 131122 Section 1 To the Installer The following information has been included in the manual as safety and regulatory guidelines. For complete installation instructions, please see the Installation Checklist. Installer Safety In all areas of the world, equipment should be...
Page 7 - Beater Rotation; procedures; Refrigerant
3 Model 220 To the Installer 130821 S Stationary appliances which are not equipped with a power cord and a plug or another device to disconnect the appliance from the power source must have an all-pole disconnecting device with a contact gap of at least 3mm installed in the external installation. S ...
Page 8 - Compressor Warranty Disclaimer
4 Model 220 To the Operator 131122 Section 2 To the Operator The freezer you have purchased has been carefully engineered and manufactured to give you dependable operation. Your Taylor freezer, when properly operated and cared for, will produce a consistent quality product. Like all mechanical produ...
Page 11 - Operator Parts Identification; Section 4
7 Model 220 Operator Parts Identification Section 4 Operator Parts Identification ITEM DESCRIPTION PART NO. 1 PAN-DRIP 027503 2 COVER A.-HOPPER-110-220 X24778 3 GASKET-HOPPER COVER 011412 4 PANEL-REAR 031749 5 FUNNEL A.-MIX X35636 6 LOUVER-SIDE L & R 019566 7 PANEL-UPPER SIDE R. 033125 8 PANEL A...
Page 12 - Beater Door Assembly
8 Model 220 Operator Parts Identification Beater Door Assembly ITEM DESCRIPTION PART NO. 1 ROD A.-DRAW X30079 2 HOLDER A.-BEARING X30078 3 O-RING-2-1/8 OD X .139W-#225 020051 4 PISTON-VALVE 030083 5 PIN-HINGE X04329 6 PIN A.-PIVOT X34737 7 DOOR A.-PARTIAL SPOUT X32938 8 CAP A.-COVER X29667 ITEM DESC...
Page 13 - Accessories
9 Model 220 Operator Parts Identification 140717 Accessories ITEM DESCRIPTION PART NO. 1 PAIL- 10 QT. 013163 2 LUBRICANT- TAYLOR 047518 3 BRUSH- MIX TANK BODY 3 X 7 023316 4 FUNNEL- PLASTIC DOOR 029670 ITEM DESCRIPTION PART NO. 5 BRUSH- REAR BRG 1 X 2 X 14 013071 6 BRUSH- DRAW VALVE 1- 1/2 X 3 01475...
Page 14 - Symbol Definitions
10 Model 220 Important: To the Operator Section 5 Important: To the Operator Figure 1 ITEM DESCRIPTION 1 Control Switch (Switch- Rocker) 2 Dial Light (Light- Orange- Round) 3 Temperature Control (Control- Temp.) Symbol Definitions To better communicate in the International arena, the words on many o...
Page 15 - Assembly
11 Model 220 Operating Procedures Section 6 Operating Procedures The Model 220 freezer can produce all flavors of ice cream, including those with fruits and nuts. The freezer is designed for filling pints, quarts or gallons to be placed in a hardening cabinet. The unit has a 10 quart (9.5 liter) mix...
Page 17 - Operating Procedures
13 Model 220 Operating Procedures Slide the o- ring into the groove on the bearing holder, and lubricate. Figure 9 Lightly lubricate the draw rod, and slide the bearing holder onto the rod, locking stem first. Figure 10 Thread the valve piston on the end of the draw rod until tight. Figure 11 Lightl...
Page 19 - Sanitizing
15 Model 220 Operating Procedures 080911 Step 7 Install the shelf. Choose the level desired and align the grooves in the back of the shelf with the holding collars. Slide the shelf down over the holding collars of the same height on the left and right sides. Figure 20 Sanitizing Step 1 Prepare a pai...
Page 21 - Priming; not
17 Model 220 Operating Procedures 060425 Priming Step 1 Place the funnel in the mix inlet hole at the rear of the hopper. Turn the funnel to the right or left so that the opening in the funnel does not align with the opening in the mix inlet hole. Figure 29 Step 2 Pour 10 quarts (9.5 liters) of FRES...
Page 23 - Overrun; Drawing Product; “EJECT”
19 Model 220 Operating Procedures Overrun With the control switch in the “EJECT” position, take a sample of the product to determine overrun. If the overrun is not at the desired level, leave the control switch in the “EJECT” position to agitate the product and blend more air into the mixture. Conti...
Page 25 - Disassembly; MAKE SURE THE CONTROL SWITCH IS; Brush Cleaning
21 Model 220 Operating Procedures Disassembly MAKE SURE THE CONTROL SWITCH IS IN THE “OFF” POSITION. Failure to follow this instruction may result in severe personal injury from hazardous moving parts. Step 1 Remove the cross bar screw assembly, the hinges, pins, the cross bar, the freezer door, the...
Page 26 - Important: Operator Checklist; Section 7; We recommend that after the necessary; Troubleshooting Bacterial Count; monthly
22 Model 220 Important: Operator Checklist 051101 Section 7 Important: Operator Checklist During Cleaning and Sanitizing Cleaning and sanitizing schedules are governed by your State or local regulatory agencies and must be followed accordingly. The following check points should be stressed during th...
Page 27 - Winter Storage; This is
23 Model 220 Important: Operator Checklist 080221 Winter Storage If the place of business is to be closed during the winter months, it is important to protect the freezer by following certain precautions, particularly if the building is subject to freezing conditions.Disconnect the freezer from the ...
Page 28 - PROBLEM
24 Model 220 Troubleshooting Guide Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAGE REF. 1. Unit will not run in the “AUTO” position. a. Unit is unplugged. a. Plug in wall receptacle. - - b. Circuit breaker is off. b. Turn the breaker on. - - c. Unit is off on reset. c. Place contr...
Page 29 - Troubleshooting Guide
25 Model 220 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAGE REF. 7. Overrun is too low. a. The temperature control is set too cold. a. Adjust it accordingly. 10 b. Not enough air is blended into the product. b. Place the control switch in the “EJECT” position to blend in more air. Continue...
Page 30 - Parts Replacement Schedule; Section 9
26 Model 220 Parts Replacement Schedule Section 9 Parts Replacement Schedule PART DESCRIPTION EVERY 3 MONTHS EVERY 4 MONTHS EVERY 6 MONTHS ANNUALLY QTY. Front Bearing X 1 Scraper Blades X 3 Drive Shaft Seal X 1 Funnel O- Ring X 1 Freezer Door O- Ring X 1 Bearing Holder and Valve Piston O- Ring X 2 B...
Page 31 - Limited Warranty on Equipment
27 Model 220 Limited Warranty on Equipment 131122 Section 10 Limited Warranty on Equipment TAYLOR COMPANY LIMITED WARRANTY ON FREEZERS Taylor Company, a division of Carrier Commercial Refrigeration, Inc. (“Taylor”) is pleased to provide this limited warranty on new Taylor-branded freezer equipment a...
Page 33 - Limited Warranty on Parts; TAYLOR COMPANY LIMITED WARRANTY ON TAYLOR GENUINE PARTS; LIMITED WARRANTY CONDITIONS
29 Model 220 Limited Warranty on Parts 131122 Section 11 Limited Warranty on Parts TAYLOR COMPANY LIMITED WARRANTY ON TAYLOR GENUINE PARTS Taylor Company, a division of Carrier Commercial Refrigeration, Inc. (“Taylor”) is pleased to provide this limited warranty on new Taylor genuine replacement com...
Page 35 - must
31 Model 220 Limited Warranty on Parts LIMITATION OF WARRANTY THIS LIMITED WARRANTY IS EXCLUSIVE AND IS IN LIEU OF ALL OTHER WARRANTIES, CONDITIONS AND/OR REMEDIES UNDER THE LAW, INCLUDING ANY IMPLIED WARRANTIES OR CONDITIONS OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. THE ORIGINAL OWNER...
