Tascam US-428 - Manual
Tascam US-428 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Setting Up OMS to Work with the US -428
§
First, run the OMS installer. If you do not have the current version of OMS, it may be
freely downloaded at
www.opcode.com
.
§
Locate the “US -428 Drivers” folder, which was placed on your desktop when you ran the
US-428 installer. In this folder, locate the US -428 OMS driver. Drag the US -428 OMS
driver into the OMS folder
inside your System folder.
Do
not
drag this file into the
Opcode folder on your hard drive – it will not work correctly.
§
Restart your computer. Then turn on the US -428 and start the OMS Setup application
(located in the Opcode folder on your hard drive).
§
Select “New Studio Setup” from the File menu. When prompted to select a serial
(modem or printer) port, leave both selections unchecked. Click yes and continue. OMS
will assess all the MIDI ports attached to your computer and build OMS instruments for
the ones it recognizes.
§
When the setup is complete you should see a list of all your connected MIDI ports. At the
least you should see four icons pertaining to the US -428 specifically: the US -428 icon,
US-428 MIDI ports 1 and 2, and US -428 Control port.
(Ports 1 and 2 correspond to the US -428’s physical MIDI ports. US -428 Control is the “virtual”
MIDI port with which the US -428 and its control surface communicate with your host application.)
Once OMS setup is successfully completed, you can proceed with setting up the US -428 with
your chosen application. Please refer to the specific documentation for your application for
specific details.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
