Superior SDVST-N-B - Manual

Superior SDVST-N-B

Superior SDVST-N-B – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
Page: / 40

Table of Contents:

  • Page 2 – TABLE OF CONTENTS; Please read and understand these; WARNING; GENERAL INFORMATION
  • Page 3 – Table 1
  • Page 4 – Figure 1; Tables 2 and 3; Table; Table 4; REQUIREMENTS FOR THE COMMON-; Manifold Pressure Tap; Flame Height; Main Gas Control Knob; SIT Millivolt Gas Valve
  • Page 5 – Installation; Figure 2; Typical Locations; LOCATION; Do not insulate the space between the ap-
  • Page 6 – VENT TERMINATION CLEARANCES; These instructions should be used as a; Vertical Vent Termination Clearances; Figure 3A; Minimum; Figure 3A - Multiple Terminations; Termination Heights For Vents; Horizontal Vent Termination Clearances; Side Elevation View; Figure 4
  • Page 7 – Figure 5; EXTERIOR HORIZONTAL VENT TERMINATION CLEARANCE REQUIREMENTS
  • Page 8 – MINIMUM CLEARANCES TO COMBUSTIBLES; inclined vent component.; Table 5; When the; Figure 8
  • Page 9 – See; Figure 9
  • Page 10 – FLUE
  • Page 11 – Model
  • Page 12 – Table 6
  • Page 13 – The VENT SEAL CAP must remain securely installed; Note: The restrictor is included within the firebox.; Step 3. INSTALL THE VENT SYSTEM; Approved Vent; on; Figure 14 and
  • Page 14 – VENT SECTION LENGTH CHART; Effective Vent Length; Table 7; Figure 22 on Page; Secure VentTM pipe applications are shown in; Figure 3B on
  • Page 17 – Page 6, Figures 3A and
  • Page 18 – Ratio V to H ratio is 1:2; VERTICAL VENT FIGURES/TABLES; rate sections of concentric flexible
  • Page 19 – Ceiling; ) horizontal run up to a; Top Vent - THREE ELBOWS
  • Page 20 – refer to Figure
  • Page 21 – Termination Guard
  • Page 22 – Under no circumstances, may separate sections of; HORIZONTAL VENT FIGURES/TABLES; Square termination; Termination Kit and 6 In. Vent; Table 8
  • Page 25 – Figure; SECuRE FLEX
  • Page 26 – Step 4. FIELD WIRING; Blower Wiring Diagram; If any of the original wire as supplied must be replaced,; Wiring Diagram; Factory Wired; Verify proper operation after servicing.; CAUTION; Valve Access Side
  • Page 27 – Connect the black supply wire to the top; CAUTIONS; Connect the ground supply wire to the outlet
  • Page 28 – Step 6. CONNECTING GAS LINE; Figures; Gas; CONTROL COMPARTMENT ACCESS/LOUVER; Lower Control
  • Page 29 – A. Light the appliance (refer to the lighting; TION; Millivolt Appliance Checkout; TEST ALL CONNECTIONS FOR GAS LEAKS; STONE AND GLOWING EMBERS
  • Page 30 – Note: If the burners have been removed for; Bag of Glowing; REFERENCE; Volcanic Stone
  • Page 31 – Page 28, Reinstalling Control; Note: When installing the glass door, ensure the
  • Page 32 – Figure 57 - Burner Flame Appearance; Locate adjustment rod and adjust air shutter; Light appliance (follow lighting procedure; Combustible Wall Framing; Step 11. HOOD INSTALLATION; All of these appliances must have hoods; FINISHING REQUIREMENTS; See Page 5 for Cold Climate Insula-; WARNINGS; Burner Air Shutter Adjustment Procedure; - Burner Air Shutter Adjustment
  • Page 33 – Figure A
  • Page 34 – INSTALLATION ACCESSORIES
  • Page 35 – Item; Horizontal Square Termination (without flex); All compressed flex vents can be expanded up to two times.
  • Page 37 – this installation assumes responsibility for this conversion.; AVERTISSEMENT; assume les responsabilités liées à la conversion.; Removing Glass Enclo-
  • Page 38 – Test All Connections For Gas Leaks; VERIFY THE PROPER ORIFICE SIZES; Table 9
  • Page 39 – NOTES
Loading the manual

OTL Report No. 116-F-32-5

US

Portland

MODELS

INSTALLATION INSTRUC

TIONS

SDVST Direct-Vent

Gas Fireplaces

SDVST-N-B

SDVPF-N-B

MILLIVOLT:

P/N 700037M Rev. F 01/2011

This manual is one of a set of two supporting this product.

Refer to P/N 725035M for Care and Operation Instructions.

Ce manuel est disponible en francais, simplement

en faire la demande. Numéro de la pièce 700037CF.

AVERTISSEMENT : Assurez-vous de bien suivre les

instructions données dans cette notice pour réduire au

minimum le risque d’incindie ou d’explosion ou pour

éviter tout dommage matériel, toute blessure ou la mort.

- Ne pas entreposer ni utilizer d’essence ni d’autres vapeurs

ou liquides inflammables dans le voisinage de cet appareil

ou de tout autre appareil.

- QUE FAIRE SI VOUS SENTEZ UNE ODEUR DE GAZ :

• Ne pas tenter d’allumer d’appareil.
• Ne touchez à aucan interrupteur. Ne pas vous servir des

téléphones se trouvant dans le bâtiment où vous trouvez.

• Appelez immédiatement votre fournisseur de gaz depuis

un voisin. Suivez les instructions du fournisseur.

• Si vous ne pouvez rejoindre le fournisseur de gaz,

appelez le service des incindies.

- L’installation et l’entretien doivent être assurés par un

installateur ou un service d’entretien qualifié ou par le

fournisseur de gaz.

WARNING: If the information in these instructions

is not followed exactly, a fire or explosion may

result, causing property damage, personal injury,

or death.

-

vapors and liquids in the vicinity of this or any other

appliance.

- WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

• Do not touch any electrical switch; do not use any

phone in your building.

• Immediately call your gas supplier from a

neighbor’s phone. Follow the gas supplier’s

instructions.

•

department.

- Installation and service must be performed by a

WARNING / AVERTISSEMENT / AVISO

• HOT GLASS WILL CAUSE

BURNS.

• DO NOT TOUCH GLASS

UNTIL COOLED.

• NEVER ALLOW CHILDREN

TO TOUCH GLASS.

• UNE SURFACE VITRÉE CHAUDE

PEUT CAUSER DES BRÛLURES.

• LAISSER REFROIDIR LA SURFACE

VITRÉE AVANT D'Y TOUCHER.

• NE PERMETTEZ JAMAIS À UN ENFANT

DE TOUCHER LA SURFACE VITRÉE.

• EL VIDRIO CALIENTE

CAUSARÁ QUEMADURAS.

• USTED DEBE NUNCA

TOCAR EL VIDRIO CALIENTE.

• LOS NIÑOS DEBEN NUNCA

TOCAR EL VIDRIO.

INSTALLER: Leave this manual with the appliance.

CONSUMER: Retain this manual for future reference.
INSTALLATEUR : Laissez cette notice avec l'appareil.

CONSOMMATEUR : Conservez cette notice pour

consultation ultérieure.

This appliance may be installed as an OEM installation in a manufactured home (USA only) and must be

installed in accordance with the manufacturer’s instructions and the Manufactured Home Construction and

Safety Standard, Title 24 CFR, Part 3280, in the United States or the Standard for Installation in Manufactured

Homes, CAN/CSA Z240 MH, in Canada. This appliance is only for use with the type of gas indicated on the

rating plate. This appliance is not convertible for use with other gases, unless a certified kit is used.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - TABLE OF CONTENTS; Please read and understand these; WARNING; GENERAL INFORMATION

2 TABLE OF CONTENTS Packaging .........................................Page 2Introduction ......................................Page 2General Information ..........................Page 2Requirements for the Commonwealth of Massachusetts .Page 4New York City Approval ..................... Page 4Cold ...

Page 3 - Table 1

3 The appliance, when installed, must be electri- cally grounded and wired in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 - latest edition , or the Canadian Electrical Code, CSA C22.1 - latest edition . Provide adequate clearances ar...

Page 4 - Figure 1; Tables 2 and 3; Table; Table 4; REQUIREMENTS FOR THE COMMON-; Manifold Pressure Tap; Flame Height; Main Gas Control Knob; SIT Millivolt Gas Valve

4 NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE. Inlet Gas Supply Pressure (all models) Fuel # Minimum Maximum Natural Gas 5.0" WC (1.24 kPa) 10.5" WC (2.61 kPa) Propane 11.0" WC (2.74 kPa) 13.0" WC (3.23 kPa) Table 2 Manifold Gas Supply Pressure (all models) Fuel # Low High Na...

Other Superior Models

All Superior Other