Stiga PRO 16 - Manual - manualsarea.com

Page 7 - ENGLISH; GENERAL; CONTROLS; A pedal that activates the variable transmission.

ENGLISH GB GENERAL This symbol indicates WARNING. Per-sonal injury and/or damage to property may result if the instructions are not followed carefully. You must read these instructions for use and the accompanying pamphlet "SAFETY INSTRUCTIONS" careful-ly before starting up the machine. SYMB...

Page 9 - Grass clipping and leaf collection

ENGLISH GB 2. Drive position (without symbol). 3. Start position - the electric starter motor is activated when the key is turned to the spring-loaded start position. Once the en-gine has started, allow the key to return to the drive position. A spare key is enclosed in the plastic bag that also inc...

Page 10 - Grass and leaf transport

ENGLISH GB 5. Grass and leaf transport Using dump cart 13-1979 (Standard) or13-1988 (Maxi). 6. Fertiliser spreading Using fertiliser spreader 13-1987. Can also beused for spreading grass seed. 7. Sand spreading Using sand spreader 13-1975. Can also be usedfor spreading salt. Snow chains 13-1956 andw...

Page 11 - STARTING ENGINE; Turn the starter key and start the engine.; STOPPING; Machines with catalytic converters:; - do not cover the machine until the catalytic con-; OPERATING

ENGLISH GB lever (only US and Canada) In order to start the machine the following are nec-essary:- gear lever in neutral (only Classic)- brake pedal depressed- driver sitting on seat- power take-off engagement lever at lowest setting (i.e. power take-off disengaged) Always check the operation of the...

Page 12 - CLEANING; NOTE! When washing the machine with water un-; CHANGING ENGINE OIL; Remove the dipstick and fill up with new oil.; Use oil without any additives.

ENGLISH GB “FULL”). Be careful when driving on slopes. No sudden starting or stopping when mov-ing up or down a slope. Never drive across a slope. Move from the top and down, and from down to the top. The machine, equipped with original accessories, must not be driven on slopes greater than 10° in a...

Page 13 - LUBRICATION

ENGLISH GB Check the oil every time when topping up. The level should come up to the “FULL” mark. CHANGING THE TRANSMISSION OIL (President - Pro16 - Pro18) Change the oil the first time after 50 hours of oper-ation, and then after every 250 hours or operation or once a season. Use a good grade of SA...

Page 14 - BATTERY; Check the acid level regularly.; AIR FILTER; The engine manufacturer recommends:; CARBURETTOR

ENGLISH GB 25 hours running (fig 17 - 18). All plastic bearings should be lubricated twice each season. Apply universal grease to the steering chain a cou-ple of times each season. If the steering chain is re-ally dirty, dismantle it, wash it, and then grease it once more. Apply a coating of engine ...

Page 15 - REPLACING THE V - BELTS; PEDAL STOP; Screw the pedal stop up until it touches the low-

ENGLISH GB ADJUSTING POWER TAKE - OFF CABLE (not Pro18) If the v-belt between the engine belt pulley and centre belt pulley slips when the power take-off is engaged, the power take-off cable can be tensioned by means of the two cable adjusters K (fig 23). REPLACING THE V - BELTS You can replace the ...

Page 16 - Put the machine in the straight ahead position.; ADJUSTING THE BRAKE

ENGLISH GB er side. 5. Tighten the pedal stop locking nut. The forward movement of the drive pedal must not be restricted by the end position of the transmission, otherwise serious damage may arise. 6. Then adjust the pedal stop under the rear part of the drive pedal. The backward movement of the dr...

Page 18 - WA

Park Classic Park President Park Pro 16 Park Pro 18 3400 min -1 9.3 kW 3400 min -1 9.3 kW 3400 min -1 11.8 kW 3400 min -1 13.2 kW 4.5 m/s 2 4.5 m/s 2 < 2.5 m/s 2 < 2.5 m/s 2 < 0.5 m/s 2 < 0.5 m/s 2 < 0.5 m/s 2 < 0.5 m/s 2 < 10° < 10° < 10° < 10° < 10° < 10° < 1...

Page 19 - M O W I N G A H E A D

M O W I N G A H E A D B o x 1 0 0 6 · S E - 5 7 3 2 8 T R A N Å S w w w . s t i g a . c o m