Stiga DIESEL 4WD - Manual

62 ENGLISH EN 2.4.9 Ignition lock (4,5:I) Ignition lock used for starting/stopping the engine. There are 3 positions: 1. Stop position – the engine is short-cir-cuited. The key can be removed. 2. Operating position 3. Start position – the electric start motor is activated when the key is turned to t...

63 ENGLISH EN 2.4.18 Seat (1:T) The seat can be folded and adjusted front-rear. The seat can be adjusted as follows:1. Move the control lever (1:S) upwards.2. Set the seat to the desired position.3. Release the control lever (1:S) to lock the seat. The seat is equipped with a safety switch that is c...

64 ENGLISH EN 4 STARTING AND OPERATION The machine may not be operated un-less the engine casing is closed and locked. Risk of burns and crushing in-juries. 4.1 Refuelling Only use diesel which satisfies the minimum re-quirements of the following specifications: EN 590BS 2869 A1 / A2ASTM D 975 - 1D ...

65 ENGLISH EN 4.5.1 General safety check 4.5.2 Electrical safety check The operation of the safety system should always be checked every time before use. 4.6 Start 1. Do not keep your foot on the drive pedal. 2. Put the throttle control at full throttle. 3. Depress the brake pedal fully.4. Turn the ...

66 ENGLISH EN 4.10 Cleaning To reduce the risk of fire, keep the en-gine, silencer, battery and fuel tank free from grass, leaves and oil.To reduce the risk of fire, regularly check the machine for oil and/or fuel leakage. Clean the machine after each use. The following instructions apply for cleani...

67 ENGLISH EN 5.4.1 Oil filter The oil filter must be cleaned after 1000 hours of operation and when changing the oil. First drain the engine oil and install the oil drain plug as above. Then clean the oil filter as follows:1. Clean the area around the filter (13:A)2. Slacken off the screw (13:B) 5 ...

68 ENGLISH EN The oil plug will be damaged if it is tightened more to than 5 Nm. 9. Check that the gasket on the oil plug of the rear axle is intact. See fig. 18:V. Reinstall in the rear axle. Tighten the oil plug to 5 Nm. 10.Draw out the oil from the deeper section of the reservoir using an oil ext...

69 ENGLISH EN 5.11.2 Charging using battery charger When charging using a battery charger, a battery charger with constant voltage must be used.Contact your dealer to purchase a battery charger with constant voltage. The battery can be damaged if a standard type battery charger is used. 5.11.3 Remov...

70 ENGLISH EN 5.15 Fuses If any of the faults listed below occurs, replace the relevant fuse. See fig. 29/30. 6 PATENT - DESIGN REGISTRA- TION This machine or parts thereof is covered by the fol-lowing patent and design registration:SE9901091-0, SE9901730-3, SE9401745-6, US595 7497, FR772384, DE6952...