Stiga 8211-0276-02 - Manual

Page 2 - PARK

Page 7 - SYMBOLS; CONTROLS AND; Use this to increase/decrease the lift help.

8 ENGLISH GB GENERAL This symbol indicates WARNING. Per-sonal injury and/or damage to propertymay result if the instructions are notfollowed carefully. You must read these instructions for useand the accompanying pamphlet“SAFETY INSTRUCTIONS” careful-ly, before starting up the machine. SYMBOLS The f...

Page 8 - ENGLISH; A pedal that activates the variable transmission.; NOTE! If the key is turned from the stop posi-

9 ENGLISH GB tem. There are 3 positions: 1. Pedal released – service brakenot activated. 2. Pedal depressed halfway –forward drive disengaged. Serv-ice brake not activated. 3. Pedal fully depressed – for-ward drive disengaged. Servicebrake fully activated. 4. PARKING BRAKE An inhibitor that can lock...

Page 9 - The machine has been designed for electrical ad-

10 ENGLISH GB tion to operating position 2, the spotlight is acti-vated. This uses up battery power. Do not leavethe machine with the key in position 2 (appliesto Pro16-Pro18-Pro20). 10. GEAR LEVER (Senator) A lever for selecting one of the five forward gearsin the gearbox (1-2-3-4-5), neutral (N) o...

Page 10 - Grass clipping and leaf collection

11 ENGLISH GB justment of a rear rake (available as an accessory). The switch is used to raise and lower therear rake. Connection cables for the rake are located to therear of the machine, to the left on the top of thebumper (Pro16 and Pro18 are prepared for a rearrake). 18. SAND SPREADER (Pro20) Th...

Page 11 - ENGINE CASING; - press the drive pedal so that the machine starts

12 ENGLISH GB START AND OPERATING ENGINE CASING To inspect and maintain the engine and battery, re-move the engine casing as follows: 1. Unscrew the fuel cap/fuel gauge. 2. Carefully lift off the engine casing (fig. 10). Assembly: 1. Make sure that the front part of the casing fitsinto the track in ...

Page 12 - STARTING ENGINE

13 ENGLISH GB to move, release the drive pedal – the machinemust stop (applies to President, Royal, Pro16,Pro18, Pro20). - press the drive pedal so that the machine starts to move, engage the cruise control, lift yourweight off the seat – the machine must stop (ap-plies to Royal, Pro16, Pro18, Pro20...

Page 13 - OPERATING; SERVICE AND MAINTENANCE; SERVICE PROGRAM

14 ENGLISH GB wheel when the machine stands completely stilland the accessory is in the lowered working po-sition. The steering is adapted in order to produce betterresults at a normal working speed. Even when the engine is not running, the steeringworks. However, it is harder to turn in this case, ...

Page 14 - Remove the dipstick and fill up with new oil.; Use oil without any additives.; Replace the filter and snap the lock into place.; SPARKING PLUG; Only use a Briggs & Stratton sparking tester to

15 ENGLISH GB The engine oil may be very warm if it isdrained off directly after the engine isshut off. Therefore, allow the engine tocool a few minutes before draining theoil. 1. Oil drain pipe (metal):Unscrew the oil drain plug at the end of the pipe. Let the oil run out into a collection vessel. ...

Page 15 - The engine manufacturer recommends:; COOLING AIR INTAKE - ENGINE; Check the acid level regularly.; LUBRICATION - CHASSIS; Put the machine in the straight-ahead position.

16 ENGLISH GB check the spark of the sparking plug(s) (fig. 23). Clean the sparking plug after every 100 hours ofoperation or once a season. For replacing a spark-ing plug, a sparking plug sleeve A and a torsion pinB are provided in the accessories bag. The engine manufacturer recommends: Senator-Pr...

Page 16 - PATENT –

17 ENGLISH GB STEERING CHAINS (Pro16 - Pro18 -Pro20) Adjust the steering chains after every 50 hours ofoperation. Put the machine in the straight-ahead position. Tension the steering chains by tightening up thenuts that are located on the underside of the articu-lated steering joint (fig. 27). Tensi...

Stiga 8211-0276-02 - Manual

Table of Contents:

Summary

Other Stiga Models