Stiga 8211-0202-11 - Manual

Page 5 - ENGLISH; GENERAL; INSTALLATION; ACCESSORIES BAG; Designation; STEERING WHEEL

ENGLISH GB GENERAL This symbol indicates WARNING. Per-sonal injury and/or damage to propertymay result if the instructions are notfollowed carefully. SYMBOLS The following symbols can be found on the ma-chine to remind you of the care and attention thatare required during use: The symbols mean: Warn...

Page 6 - TYRE PRESSURE; CONTROLS; HEIGHT SETTING LEVER

ENGLISH GB Do not short circuit the battery’s termi-nals. Sparks occur which can result infire. Do not wear metal jewellery whichcan come into contact with the batteryterminals. In the event of damage to the batterycasing, cover, terminals or interferenceto the strip covering the valves, the bat-ter...

Page 7 - AREAS OF USE; With the cutting deck mounted originally.; Grass clipping and leaf collection; BEFORE STARTING

ENGLISH GB 1. Pedal released – forwarddrive engaged. The machinewill move if a gear is engaged.Service brake not activated. 2. Pedal depressed halfway –forward drive disengaged, gearshifting can be performed.Service brake not activated. 3. Pedal fully depressed – for-ward drive disengaged. Servicebr...

Page 8 - controls the system; FILL UP THE PETROL TANK; Turn the starter key and start the engine.; STOPPING; Shut off the petrol cock.

ENGLISH GB - a switch on the gearbox- a switch in the seat mount- a switch at the blade engaging lever- a replaceable, electronic safety module which controls the system In order to start the machine, the following are nec-essary:- the gear lever in neutral- driver sitting on seat- the blade engagin...

Page 9 - CUTTING TIPS; MAINTENANCE; MAINTENANCE TIPS; Remove the dipstick and fill up with new oil.

ENGLISH GB CUTTING TIPS Before mowing the lawn, take care to remove anyloose stones, toys and other hard objects. Locate any fixed objects before mowing a lawnyou are unfamiliar with. Loose and/or fixed ob-jects can seriously damage the cutting deck. Do not cut wet grass (during or immediately after...

Page 10 - Use oil without any additives.; Also clean around the silencer to avoid fire.

ENGLISH GB Oil type, winter: SAE 5W-30(if this oil is not available, use SAE 10W-30). Use oil without any additives. Do not fill with too much oil. This can cause theengine to overheat. Check the oil level each time after filling. The lev-el should be at “FULL“. LUBRICATION The front axle has four l...

Page 11 - Install a new genuine belt in reverse order.; ADJUSTING BLADE BRAKE; Replace the brake lining when it is worn.; BLADE; SPARE PARTS

ENGLISH GB If the machine is to stand on its end, thepetrol and engine oil must have beendrained out first. 3. Set the lowest cutting height and remove thelocking pin Q (fig. 14). 4. Remove the two rear locking pins R and the ca-bles for the switch contact on the deck (fig. 15). 5. Force the belt of...

Page 12 - M O W I N G A H E A D

M O W I N G A H E A D B o x 1 0 0 6 · S E - 5 7 3 2 8 T R A N Å S w w w . s t i g a . c o m