StarTech.com LCD2180UX - Manual

English English-3 Contents Your new NEC MultiSync LCD monitor box* should contain the following: • MultiSync LCD2180UX monitor with tilt/swivel/pivot/height adjust stand • Power Cord • Video Signal Cable (15-pin mini D-SUB male to DVI-A) • Video Signal Cable (DVI-D to DVI-D cable) • User’s Manual • ...

English-4 Quick Start To attach the MultiSync LCD monitor to your system, follow these instructions: 1. Turn off the power to your computer. 2. For the PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system ( Figure A.1 ). Tighten all scre...

English English-5 Figure C.1 Figure C.2 Figure D.1 Figure RL.1 INPUT2 INPUT1 Vacation Switch Power Button NEC optional product attachment.Do not use this connector unless specified. INPUT2 INPUT1 Raise and Lower Monitor Screen The monitor may be raised or lowered in either Portrait or Landscape mode...

English English-7 Controls OSM (On-Screen Manager) control buttons on the front of the monitorfunction as follows: To access OSM menu, press any of the control buttons (EXIT, , , –, +). To change signal input, press the SELECT button. NOTE: OSM must be closed in order to change signal input. NOTE: W...

English-8 FINE (Analog input only) Improves focus, clarity and image stability by increasing or decreasing this setting. If the “Auto Adjust function” and the “H.Size” function do not give you a satisfactory picture setting, a finetuning can be performed using the “Fine” function. It improves focus,...

English English-9 Note: Depending on the PC and Video card used, or when another Video signal cable is attached, this function may not operate. OFF TIMER: Monitor will automatically power-down when the end user has selected a pre-determined amount of time. Tools 2 LANGUAGE: OSM control menus are ava...

English-10 Recommended use Safety Precautions and Maintenance FOR OPTIMUM PERFORMANCE, PLEASE NOTE THE FOLLOWING WHEN SETTING UP AND USING THE MULTISYNC LCD COLOUR MONITOR: • DO NOT OPEN THE MONITOR. There are no user serviceable par ts inside and opening or removing covers may expose you to dangero...

English-12 Specifications Monitor Specifications MultiSync LCD2180UX Monitor Notes LCD Module Diagonal: 54 cm/21.3 inches Active matrix; thin film transistor (TFT) liquid Viewable Image Size: 54 cm/21.3 inches crystal display (LCD); 0.270 mm dot pitch; Native Resolution (Pixel Count): 1600 x 1200 25...

English English-13 Features ambix Technology: Dual input technology allowing both analog and digital inputs off of one connector (DVI-I) as well as additional legacy analog suppor t off of a traditional 15-pin VGA connector. Provides traditional MultiSync technology compatibility for analog aswell a...

English-14 Troubleshooting No picture • The signal cable should be completely connected to the display card/computer. • The display card should be completely seated in its slot. • Check the Vacation Switch should be in the ON position. • Front Power Switch and computer power switch should be in the ...

English English-15 Appendix If you need detailed information about the controls, please use the advanced menu. <How to use the advanced menu> • Turn off your monitor. • Turn on your monitor by pushing the “POWER” and “SELECT” button at the same time for at least one secondsimultaneously. • You...

English English-21 Disposing of your old NEC product Within the European Union EU-wide legislation, as implemented in each Member State, requires that waste electrical andelectronic products carrying the mark (left) must be disposed of separately from normal householdwaste. This includes monitors an...