Stanton SK SIX - Manual
Stanton SK SIX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
SK SIX
Professional performance mixer
STANTON MAGNETICS, LLC
2821 Evans St. Hollywood, FL 33020
(954) 929-8999 - Fax: (954) 929-0333
[email protected]
OWNER’S M A N U A L
F A D E R C L E A N I N G
The SK SIX faders may need lubrication from time to time. This will extend the
fader life and eliminate any potential damage due to extended heavy usage.
R E P L A C E M E N T P A R T S
To replace the cross or channel faders, follow steps 1 and 2 of the cleaning
instructions. The following replacement parts are available from Stanton or your
local Stanton dealer.
ROTATING AND REPLACING THE INPUT TOGGLE SWITCHES
C lea ning Instructio ns
1
. Remove the 3 fader knobs and 4 screws
located in the corners of the PROTEKT™
(see “
” inside) panel
and take the panel off the mixer.
2
. Remove the fader to be cleaned by
unscrewing the 2 outer screws (removing
the 2 inner screws will detach the fader
from the fader plate) and disconnect the
cable coming from the mixer.
3
. Spray a small amount of cleaner or
lubricant into both ends of the fader and
slide the fader back and forth a few times
to spread the fluid evenly throughout the
fader.
4
. Shake and wipe off excess fluid before
re-assembling the fader.
PL-SK6
Two way input toggle switch
3PL-SK6
Three way input toggle
switch with F LASH™
LF-SK6
Channel input fader
CF-SK6
Crossfader
PP-SK6
PROTEKT™ panel
PS-18US
US Power Supply (110v)
PS-18EU
European Power Supply (220v)
PS-18UK
UK only Power Supply (240v)
ROTATING I NST RU C TI O NS
1 . Remove the PROTEKT™ panel
2. Remove the 2 outer screws from the
round plate (removing the 2 inner screws
will detach the switch from the plate)
3. Rotate the plate to the desired position
and tighten the screws back in the top and
bottom holes
R E PLAC I N G I NST RU C TI O NS
1. Remove the PROTEKT™ panel
2. Remove the 2 outer screws from the
round plate (removing the 2 inner screws
will detach the switch from the plate)
3. Remove the switch assembly and dis-
connect the cable coming from the mixer.
4. Set the replacement switch assembly in
the desired position and place the screws
back in the top and bottom holes.
©
1999
, Stanton Magnetics, LLC
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
