Stanton RM-22 - Manual
Stanton RM-22 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – No Sound
- Page 4 – Channel
- Page 5 – Making Connections; Input Selector switches:; Description of Function; SUPERIOR SOUND TECHNOLOGY
- Page 6 – Crossfader Source selectors:
RM-22
Professional DJ Mixer
STANTON MAGNETICS, LLC
OWNER’S M A N U A L
Sound is distorted
Phono Input
Only plug turntables into this input, do not plug in
CD players or other Line Level sources. Turn down
the INPUT GAIN CONTROL
I hear hum.
Make sure you are using good shielded audio
cables. Some less expensive audio cables can be
susceptible to hum and interference. Keep your
audio cables away from AC power cables and AC
transformers. Make sure the mixer is not mounted
too close to high power amplifiers or lighting
equipment power supplies or ballasts. Make sure
your turntables are properly
grounded.
I hear
feedback
If you are using a microphone, make sure that
you are not too close to the speakers or
headphones. If you hear feedback on the phono
input, then the turntable may be mounted to close
to the speakers. Also, make sure the turntable
base is placed on a surface that does not vibrate
or resonate easily when the speakers are turned
up loudly.
Problem / Symptom
Possible Cause/ Solution
Troubleshooting
This unit has been designed and manufactured using quality components.
Therefore, it is warranted to be free from defects in materials (limited as specified
below), and workmanship for a period of twelve (12) months from the original
purchase date. During this period, all service and parts
necessary to repair a defect will be free of charge. This limited warranty applies to
mechanical parts which are subject to wear and tear as specified:
• Faders, specified durability: 15,000 cycles
• Rotary potentiometers, specified durability: 10,000 cycles
• Switches, specified durability: 10,000 cycles
Consequently, the parts listed above are warranted to be free from defects in materi-
als and workmanship for a period of thirty days (30) days from the original purchase
date.
FOR THE WARRANTY TO BE VALID, PLEASE COMPLETE THE ONLINE
WARRANTY REGISTRATION FORM FOUND AT
WWW.STANTONMAGNETICS.COM
Warranty
© 2003, Stanton Magnetics, LLC
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Troubleshooting Please read carefully before use of this product failure to follow the instructions printed below may void warranty • Follow all security advice printed on your mixer • When removing the unit's AC plug from the power source, grasp and pull the plug, NEVER the cord itself! • Avoid pla...
This is a typical setup you’ll find in many nightclubs: 2 turntables, 2CD players, plus a microphone for the DJ. Here’s how you would setup your equipment with the RM-22: 1. Be sure all equipment is powered “OFF” and all of the RM-22’s Channel faders and Level knobs are at minimum volume. 2. Connect...
Outputs Use the REC output to connect a stand-alone CD recorder, DATrecorder, or tape deck. Use the BOOTH output to connect directly topowered monitors or your monitor amp. The ZONE output can beused if you need separate level control for a particular area of yourclub, such as lounge vs. dance floor...
