SPX HP7000 - Manual
SPX HP7000 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Fan Components; Figure 1—Typical Fan Assembly; actual component appearance may vary
- Page 3 – Fan Hub Installation; The key is a tight fit across the width and must never be altered.; Figure 2
- Page 4 – . When installing or replacing blades; Figure 3–Blade Nameplate
- Page 5 – Figure 5. Large nylon cable ties can be used to hold blade clamps; Figure 5
- Page 6 – The trial pitch is the calculated setting for design conditions; Figure 6; STRAIGHT; BLADE; Section
- Page 7 – • Torque all hardware to specifications referenced in this manual.; Service
- Page 8 – assembly identification number (see; Figure 1) is required to identify; a replacement hub assembly or repair components. Please provide; Motor Load; The corrected horsepower should be close to but not exceed the; Note; Cooling Technologies
>ViÊ
N
Ê>ÊÀÞÊ}Ê
N
Ê>ÀiÞ
}Ê/iV }iÃ
/
Marley
HP7000 Fan
Clamped Blade Shank – 192" thru 240"
/
User Manual 01-1139A
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Order No. ___________________________________Trial Pitch Angle ______________________________Final Pitch Angle _____________________________Speed-rpm __________________________________Contract hp _________________________________ Fan Components 300 101 120 ft·lbƒ (163 N·m) SEE FIG 6 FOR DETAILS 15 f...
3 Fan Hub Installation The following instructions detail the process for installing a Marley HP7000 Fan on a Marley Geareducer ® with a tapered fan (output) shaft and bolted fan hub retention. Installation on other gear reduc- tion units may be different. Contact your Marley sales representative for...
4 Fan Blade Installation Note Figure 4 Marley HP7000 fan blades are manufactured to equal moment weight and blade clamps to equal static weight. The blades and clamps can be installed in any position without affecting fan balance. At the end of the blade shank on a nameplate is inscribed a let-ter c...
