Sprint 2.4 GHz Digital Spread Spectrum Dual Keypad Cordless Phone with Caller ID/Call Waiting - Manual

8 Installation ˆ Installation MOUNTING THE PHONE You can place the phone on a desk or table,or mount it on a standard wall plate or direct-ly on a wall. Select a location that is: • near an AC outlet • near a telephone line jack • out of the way of normal activities • away from electrical machinery,...

9 Installation On a Wall Plate or Wall 1. Insert the bracket’s tabs into the base’s lower tab slots, then press down on thebracket’s clips and insert them into theclip slots. 2. Plug one end of the supplied short mod- ular cord into the TEL LINE jack on the back of the base. 3. Insert the supplied A...

11 Installation Important: The EPA certifiedRBRC ® Battery Recycling Seal on the nickel-cadmium (Ni-Cd)battery indicates RadioShackis voluntarily participating in anindustry program to collect and recycle thesebatteries at the end of their useful life, whentaken out of service in the United States o...

13 Telephone Operation 2. Press 2 or VOL/CID 9 9 9 9 to select CIDCW (Caller ID/Call Waiting). 3. Press SELECT/CHANNEL to change the Caller ID/Call Waiting setting. On or Off appears. 4. Return the handset to the base to store the new setting. STORING YOUR AREA CODE You can store your local area cod...

14 Telephone Operation SELECTING THE CHANNEL The phone has 30 channels. If the callseems to disconnect for no reason during acall, press SELECT/CHANNEL on the handset to select a different channel. Scanning ap- pears while your phone searches for a clearchannel. ADJUSTING THE HANDSET VOLUME To adjus...

15 Telephone Operation • On the handset, press RDL/PAUSE after pressing TALK to dial the last number dialed. • The redial memory holds up to 32 digits, so you can redial long-distance as wellas local numbers. • The redial memory also holds pause entries. See “Entering a Pause” onPage 17. USING FLASH...

16 Telephone Operation When the person at the base answers, press TALK . The call is released from hold and transferred to the base. To transfer a call from the base to the hand-set, press INTCM/PAGE . The call is put on hold, and Paging and Hold appear. When the person with the handset answers, pre...

17 Telephone Operation To replace a stored number, store a new onein its place. Editing or Deleting a Number in the Handset’s Memory Follow these steps to edit or delete a memo-ry number. 1. Lift the handset. 2. Hold down MEM until Memory Store and a list of memory location numbersappear. 3. Choose ...

18 Telephone Operation Reviewing the Handset's Memory Numbers To review your handset's memory numbers,press MEM . The list of memory location num- bers ( 01 – 20 ) appears with the name stored with each number (or <Memory nn> if you did not store a name). To see the stored phone numbers, selec...

19 Caller ID Operation • You can use a handset holder (available from your local RadioShack store) tohang the handset on your belt forgreater convenience. With a headset connected, you can make oranswer calls as usual using the speaker-phone or keys on the handset. When you finish using the headset,...

21 Caller ID Operation 3. Press SELECT/CHANNEL or INTCM/DEL . The phone beeps once. Follow these steps to delete all Caller IDrecords. 1. Press CID so the record totals appear. 2. Press INTCM/DEL . Delete All? and Yes/No appear with the cursor pointing to No . 3. Press VOL/CID 8 8 8 8 to move the cu...

22 Troubleshooting 4. Press TALK . The selected service num- ber appears and is dialed. Note: You can display the programmed ser-vice number of each calling feature. At Step2 above, press 7 7 7 7 to view the number and 6 6 6 6 to return to the name display. Editing Advanced Service Names and Numbers...

23 Troubleshooting If you still have problems, disconnect the phone. If other phones on the same line work proper-ly, the fault is in this phone or its installation. If you cannot find the problem, take the phone toyour local RadioShack store for assistance. CARE To enjoy your Sprint 2.4GHz Digital ...

43-5522 UCZZ01695BZ 09A00 Printed in China RadioShack CorporationFort Worth, Texas 76102 • Handle the phone gently and carefully. Do not drop it. • Keep the phone away from dust and dirt. • Wipe the phone with a damp cloth occasionally to keep it looking new. Modifying or tampering with the phone’s ...