Page 3 - WARNING; Read all instructions before using unit.
WARNING WARNING Risk of fire. Highly flammable material. W881 Read all instructions before using unit. WARNING FOR YOUR SAFETY, the information in this manualmust be followed to minimize the risk of fire or ex-plosion or to prevent property damage, personal in-jury or death. W033 WARNING • Do not st...
Page 5 - Table of Contents; Dimensions
Table of Contents Dimensions ............................................................................................. 6 Installation ............................................................................................. 9 Before You Start ....................................................
Page 6 - Electric Dryers; Figure 1
Dimensions Electric Dryers DRY2598N_SVG L K J I H G F E D C B A M Figure 1 A 597 mm [23.5 in.] B 213 mm [8.375 in.] C 711 mm [28 in.] D 11 mm [.4 in.] E 203 mm [8 in.] F 1184 mm [46.62 in.] G *1986 mm [78.17 in.] H *102 mm [4 in.] I *114 mm [4.5 in.] J 683 mm [26.875 in.] K 391 mm [15.4 in.] L *392 ...
Page 7 - Gas Dryers; Figure 2
Gas Dryers DRY2599N_SVG P O N M L K J I H G F E D C B A 1 1. 3/8 in. N.P.T. Gas Connection Figure 2 A 597 mm [23.5 in.] B 213 mm [8.375 in.] C 711 mm [28 in.] D 11 mm [0.4 in.] E 203 mm [8 in.] F 1184 mm [46.62 in.] G *1986 mm [78.17 in.] H *102 mm [4 in.] I *114 mm [4.5 in.] J 683 mm [26.875 in.] K...
Page 9 - Before You Start; Supplies; Figure 3; Position and Level the Dryer; Figure 5
Installation Before You Start Supplies For most installations, the basic supplies you will need are: DRY2586N_SVG 8 7 6 5 4 3 2 1 1. Wrench 2. 1/4 inch Driver 3. Screwdrivers 4. Level 5. Gloves 6. Teflon Tape 7. Duct Tape 8. Safety Glasses Figure 3 NOTE: This appliance is suitable for use in countri...
Page 10 - Outer Wall of Enclosure; Area; Dryer sides
Front View DRY2667N_SVG A A Side View DRY2668N_SVG B E E D C 1 1. Outer Wall of Enclosure Figure 5 Area Description Free Standing/Alcove Installation A Dryer sides 0 mm [0 in.] B Dryer top (rear 610 mm [24 in.]) 305 mm [12 in.] Table 1 continues... Installation © Copyright, Alliance Laundry Systems...
Page 11 - Dryer rear; Connect Dryer Exhaust System
Area Description Free Standing/Alcove Installation C* Dryer rear 102 mm [4 in.] D Dryer Top (front 201 mm [4 in.]) 13 mm [0.5 in.] E Exhaust duct clearance to combustible ma-terial 51 mm [2 in.] * Rear clearance is minimum. 152 mm [6 inches] is recommended when venting throughrear of unit. Table 1 N...
Page 12 - Figure 6; Exhaust Direction; Table 2
IMPORTANT: Installing in-line filters or lint collectorswill cause increased static pressure. Failure to main-tain the secondary lint system will decrease dryer effi-ciency and will void machine warranty. DRY2540N_SVG 2 1 1. Correct 2. Incorrect Figure 6 • DO NOT use plastic, thin foil or type B duc...
Page 13 - Gas Dryers - Connect Gas Supply Pipe
Number of 90° Elbows Weather Hood Type Recommended Use Only for Short Run Installations D673I_SVG 1 1 1. 102 mm [4 in.] D802I_SVG 1 1. 64 mm [2.5 in.] Maximum length of 102 mm [4 in.] diameter rigid metal duct. 0 19.8 m [65 feet] 16.8 m [55 feet] 1 16.8 m [55 feet] 14.3 m [47 feet] 2 14.3 m [47 feet...
Page 14 - Natural Gas Altitude Adjustments; Table 3
1. Make certain your dryer is equipped for use with the type of gas in your laundry room. Dryer is equipped at the factory forNatural Gas with a 3/8 inch NPT gas connection. NOTE: The gas service to a gas dryer must conformwith the local codes and ordinances, or in the ab-sence of local codes and or...
Page 15 - Altitude; Table 4; Electric Dryer Only - Connect Electrical; Earth/Ground Information; Wire Length; Table 5; Connecting Power Cord with Three-Wire Plug
L.P. (Liquefied Petroleum) Gas, 93.1 MJ/m 3 [2500 Btu/ft. 3 ], serv- ice must be supplied at 10 ± 1.5 inch water column pressure. For proper operation at altitudes above 915 m [3000 feet] the L.P.gas valve spud orifice size must be reduced to ensure completecombustion. Refer to Table 4 . L.P. Altitu...
Page 16 - Figure 8
NOTE: Use COPPER WIRE only. Shorter than 15 ft. (4.5 m) – use 10 AWGLonger than 15 ft. (4.5 m) – use 8 AWG D816I_SVG L1 L2 L1 L2 15 16 5 2 2 3 4 8 9 1213 10 11 7 6 1 14 1. A typical 30-Amp Three-Wire Receptacle NEMA Type 10-30R 2. 120 ± 12 V.A.C. 3. 240 ± 12 V.A.C. 4. Intermediate Fuse Box (may be o...
Page 17 - Figure 9; Connecting Power Cord with Four-Wire Plug
D695I_SVG Figure 9 3. Use a strain relief and insert end of power cord through power supply hole. D696I_SVG Figure 10 4. Use the three screws from the accessories bag to attach the power cord wires to the terminal block. Refer to Figure 11 . 3-Wire Connection DRY2508N_SVG 4 3 2 1 1. "L1" Ter...
Page 18 - Reverse Door, if Desired; NOTE: Doors with windows cannot be reversed.
3. Remove earth/ground screw from earth/ground to neutral wire and save for use in Step 5. Earth/ground to neutral wire willbe attached to the neutral terminal in Step 6. DRY2468N_SVG 1 1. Earth/Ground Screw Figure 14 4. Use a strain relief and insert end of power cord through power supply hole. DRY...
Page 20 - Wipe Out Inside of Dryer; Electric Dryer; Connect the dryer to an electrical power source. Refer to
8. Using screwdriver, remove two door plugs, and reinstall on opposite side of door opening. D317S_SVG Figure 24 9. Reinstall four hinge attaching screws, removed in Step 1. D606I_SVG Figure 25 Wipe Out Inside of Dryer Before using dryer for the first time, use an all-purpose clean-er, or a detergen...
Page 21 - Connect to 30 Amp circuit.; Gas Dryer; Plug Cord Into Separately Fused 15 Amp Circuit
Connect to 30 Amp circuit. D275I_SVG 3 2 1 4 Figure 27 Gas Dryer Dryer requires 120 Volt, 60 Hertz electrical supply and comesequipped with a 3-prong earth/ground plug. Refer to serial platefor specific electrical requirements. NOTE: The wiring diagram is located behind the con-trol panel, inside th...
Page 22 - Recheck Steps
WARNING This unit is equipped with a three-prong (earth/ground) plug for your protection against shock haz-ard and should be plugged directly into a protectiveearth/ ground three-prong receptacle. Do not cut orremove the earth/ground prong from this plug. W823 WARNING Improper connection of the equi...
Page 23 - Shut-off Valve Only Applicable on Certain Models; Air Shutter Lockscrew
Shut-off Valve Only Applicable on Certain Models DRY2753N_SVG 3 1 6 5 4 2 1. Air Shutter Lockscrew 2. Air Shutter 3. 3.1 mm [1/8 in.] Pipe Plug (For checking manifold pressure) 4. Shut-off Valve Open Position 5. Shut-off Valve Closed Position 6. Shut-off Valve Handle Figure 29 Installation © Copyrig...
Page 24 - Fast Track for Installing the Dryer
Installer Checklist Fast Track for Installing the Dryer 1 Position and Level theDryer. DRY2634N_SVG 5 Wipe Out Inside ofDryer. DRY2601N_SVG1 CHECK CHECK 2 Connect Dryer ExhaustSystem. DRY2540N_SVG1 6 Plug In the Dryer. Electric D275I_SVG1 Gas D254I_SVG CHECK CHECK 3 GAS ONLY• Connect Gas Sup- ply Pi...