Speed Queen ASEE8AGW173TW01 - Installation Manual

Page 3 - WARNING; Read all instructions before using unit.

WARNING WARNING Risk of fire. Highly flammable material. W881 Read all instructions before using unit. WARNING FOR YOUR SAFETY, the information in this manualmust be followed to minimize the risk of fire or ex-plosion or to prevent property damage, personal in-jury or death. W033 WARNING • Do not st...

Page 5 - Table of Contents; Dimensions

Table of Contents Dimensions ............................................................................................. 6 Installation ............................................................................................. 9 Before You Start ....................................................

Page 6 - Electric Dryers; Figure 1

Dimensions Electric Dryers DRY2598N_SVG L K J I H G F E D C B A M Figure 1 A 23.5 in. [597 mm] B 8.375 in. [213 mm] C 28 in. [711 mm] D .4 in. [11 mm] E 8 in. [203 mm] F 46.62 in. [1184 mm] G *78.17 in. [1986 mm] H *4 in. [102 mm] I *4.5 in. [114 mm] J 26.875 in. [683 mm] K 15.4 in. [391 mm] L *15.4...

Page 7 - Gas Dryers; Figure 2

Gas Dryers DRY2599N_SVG P O N M L K J I H G F E D C B A 1 1. 3/8 in. N.P.T. Gas Connection Figure 2 A 23.5 in. [597 mm] B 8.375 in. [213 mm] C 28 in. [711 mm] D 0.4 in. [11 mm] E 8 in. [203 mm] F 46.62 in. [1184 mm] G *78.17 in. [1986 mm] H *4 in. [102 mm] I *4.5 in. [114 mm] J 26.875 in. [683 mm] K...

Page 9 - Before You Start; Supplies; Figure 3; Parts Included; Electric Dryer; Order of Installation Steps; Position and Level the Dryer; Figure 5

Installation Before You Start Supplies For most installations, the basic supplies you will need are: DRY2586N_SVG 8 7 6 5 4 3 2 1 1. Wrench 2. 1/4 inch Driver 3. Screwdrivers 4. Level 5. Gloves 6. Teflon Tape 7. Duct Tape 8. Safety Glasses Figure 3 NOTE: This appliance is suitable for use in countri...

Page 11 - Outer Wall of Enclosure; Area; Dryer sides

Front View DRY2667N_SVG A A Side View DRY2668N_SVG B E E D C 1 1. Outer Wall of Enclosure Figure 5 Area Description Free Standing/Alcove Installation A Dryer sides 0 in. [0 mm] B Dryer top (rear 24 in. [610 mm]) 12 in. [305 mm] Table 1 continues... Installation © Copyright, Alliance Laundry Systems...

Page 12 - Dryer rear; Connect Dryer Exhaust System

Area Description Free Standing/Alcove Installation C* Dryer rear 4 in. [102 mm] D Dryer Top (front 4 in. [201 mm]) 0.5 in. [13 mm] E Exhaust duct clearance to combustible ma-terial 2 in. [51 mm] * Rear clearance is minimum. 6 inches [152 mm] is recommended when venting throughrear of unit. Table 1 N...

Page 13 - Figure 6; Exhaust Direction; Table 2

DRY2540N_SVG 2 1 1. Correct 2. Incorrect Figure 6 • DO NOT use plastic, thin foil or type B ducting. Rigid metal duct is recommended. • Locate dryer so exhaust duct is as short as possible.• Be certain old exhaust ducts are cleaned before installing your new dryer. • Use 4 inch [102 mm] diameter rig...

Page 14 - Gas Dryers - Connect Gas Supply Pipe

Number of 90° Elbows Weather Hood Type Recommended Use Only for Short Run Installations D673I_SVG 1 1 1. 4 in. [102 mm] D802I_SVG 1 1. 2.5 in. [64 mm] Maximum length of 4 in. [102 mm] diameter rigid metal duct. 0 65 feet [19.8 m] 55 feet [16.8 m] 1 55 feet [16.8 m] 47 feet [14.3 m] 2 47 feet [14.3 m...

Page 15 - Natural Gas Altitude Adjustments; Table 3

1. Make certain your dryer is equipped for use with the type of gas in your laundry room. Dryer is equipped at the factory forNatural Gas with a 3/8 inch NPT gas connection. NOTE: The gas service to a gas dryer must conformwith the local codes and ordinances, or in the ab-sence of local codes and or...

Page 16 - Altitude; Table 4; Electric Dryer Only - Connect Electrical; Earth/Ground Information; Wire Length; Table 5; Connecting Power Cord with Three-Wire Plug

For proper operation at altitudes above 3000 feet [915 m] the L.P.gas valve spud orifice size must be reduced to ensure completecombustion. Refer to Table 4 . L.P. Altitude Adjustments Altitude Orifice Size Part No. feet [m] No. inches [mm] 3000 [915] 55 0.0520 [1.32] 58755 8000 [2440] 56 0.0465 [1....

Page 17 - Figure 8

NOTE: Use COPPER WIRE only. Shorter than 15 ft. (4.5 m) – use 10 AWGLonger than 15 ft. (4.5 m) – use 8 AWG D816I_SVG L1 L2 L1 L2 15 16 5 2 2 3 4 8 9 1213 10 11 7 6 1 14 1. A typical 30-Amp Three-Wire Receptacle NEMA Type 10-30R 2. 120 ± 12 V.A.C. 3. 240 ± 12 V.A.C. 4. Intermediate Fuse Box (may be o...

Page 18 - Figure 9; Connecting Power Cord with Four-Wire Plug

D695I_SVG Figure 9 3. Use a strain relief and insert end of power cord through power supply hole. D696I_SVG Figure 10 4. Use the three screws from the accessories bag to attach the power cord wires to the terminal block. Refer to Figure 11 . 3-Wire Connection DRY2508N_SVG 4 3 2 1 1. "L1" Ter...

Page 19 - Wipe Out Inside of Dryer

3. Remove earth/ground screw from earth/ground to neutral wire and save for use in Step 5. Earth/ground to neutral wire willbe attached to the neutral terminal in Step 6. DRY2468N_SVG 1 1. Earth/Ground Screw Figure 14 4. Use a strain relief and insert end of power cord through power supply hole. DRY...

Page 20 - Plug In the Dryer; Connect the dryer to an electrical power source. Refer to; Connect to 30 Amp circuit.; Gas Dryer; When plugging in the dryer:

DRY2601N_SVG Figure 17 Plug In the Dryer This appliance is to be supplied through a residual current device(RCD) having a rated residual operating current not exceeding 30mA. Electric Dryer Connect the dryer to an electrical power source. Refer to Electric Dryer Only - Connect Electrical Plug for in...

Page 21 - Plug Cord Into Separately Fused 15 Amp Circuit; Recheck Steps

Plug Cord Into Separately Fused 15 Amp Circuit DRY2022N_SVG 7 6 8 5 4 3 2 1 1. L1 2. Earth/Ground 3. Neutral 4. Round Earth/Ground Plug 5. Neutral Side 6. 0 V.A.C. 7. 120 ± 12 V.A.C. 8. 120 ± 12 V.A.C. Figure 19 Earth/Ground Information This appliance must be properly connected to protective earth/g...

Page 22 - Shut-off Valve Only Applicable on Certain Models

2. Close the loading door and start the dryer in a heat setting (re- fer to the operation instructions). The dryer will start, the ig-niter will glow red and the main burner will ignite. IMPORTANT: If all air is not purged out of gas line,gas igniter may go off before gas is ignited. If thishappens,...

Page 23 - Fast Track for Installing the Dryer

Installer Checklist Fast Track for Installing the Dryer 1 Position and Level theDryer. DRY2634N_SVG 5 Wipe Out Inside ofDryer. DRY2601N_SVG1 CHECK CHECK 2 Connect Dryer ExhaustSystem. DRY2540N_SVG1 6 Plug In the Dryer. Electric D275I_SVG1 Gas D254I_SVG CHECK CHECK 3 GAS ONLY• Connect Gas Sup- ply Pi...

Speed Queen ASEE8AGW173TW01 - Installation Manual

Table of Contents:

Other Manuals for Speed Queen ASEE8AGW173TW01

Summary

Other Speed Queen Models