Speed Queen ADEE9BGS173TW01 - Installation Manual

Page 3 - WARNING; Read all instructions before using unit.

WARNING WARNING Risk of fire. Highly flammable material. W881 Read all instructions before using unit. WARNING FOR YOUR SAFETY, the information in this manualmust be followed to minimize the risk of fire or ex-plosion or to prevent property damage, personal in-jury or death. W033 WARNING • Do not st...

Page 5 - Table of Contents; Dimensions

Table of Contents Dimensions ............................................................................................. 6 Installation ............................................................................................. 8 Before You Start ....................................................

Page 6 - Electric Models

Dimensions Electric Models DRY2638N_SVG J K I H G F E D C B A A * 40.42 in. [1027 mm] B * 39.61 in. [1006 mm] C * 15.44 in. [392 mm] D * 4 in. [102 mm] E 15.4 in. [391 mm] F 26.875 in. [683 mm] G * 4.5 in. [114 mm] H 0.4 in. [10 mm] I 8 in. [203 mm] J 28 in. [711 mm] K 23.5 in. [597 mm] NOTE: Exhaus...

Page 7 - Gas Models

Gas Models DRY2639N_SVG F E D C B A J K M L I H G 1 1. 3/8 in. NPT Gas Connection A *40.42 in. [1027 mm] B *39.61 in. [1006 mm] C *15.44 in. [392 mm] D *2.8 in. [70 mm] E 2.3 in. [60 mm] F 15.4 in. [391 mm] G 26.875 in. [683 mm] H 4 in. [102 mm] I *4.5 in. [114 mm] J 0.4 in. [10 mm] K 8 in. [203 mm]...

Page 8 - Before You Start; Supplies; Figure 1; Parts Included; Electric Dryer; Order of Installation Steps; Position and Level the Dryer; Figure 3

Installation Before You Start Supplies For most installations, the basic supplies you will need are: DRY2586N_SVG 8 7 6 5 4 3 2 1 1. Wrench 2. 1/4 inch Driver 3. Screwdrivers 4. Level 5. Gloves 6. Teflon Tape 7. Duct Tape 8. Safety Glasses Figure 1 NOTE: This appliance is suitable for use in countri...

Page 11 - Table 1; Connect Dryer Exhaust System

Area Description Free Standing/Alcove In- stallation Closet Installation A* Dryer sides and rear clearance 0 in. [0 mm] 0 in. [0 mm] B Dryer top clearance 12 in. [305 mm] 12 in. [305 mm] C Dryer front clearance Not Applicable 2 in. [51 mm] D Exhaust duct clearance to com-bustible material 2 in. [51 ...

Page 12 - Figure 4; Exhaust Direction; Table 2

WARNING To reduce the risk of fire, DO NOT use plastic or thinfoil ducting to exhaust the dryer. W354 WARNING To reduce the risk of fire, the exhaust duct andweather hood MUST be fabricated of a material thatwill not support combustion. Rigid or flexible metalpipe is recommended for a clothes dryer....

Page 13 - Gas Dryers - Connect Gas Supply Pipe

Number of 90° Elbows Weather Hood Type Recommended Use Only for Short Run Installations D673I_SVG 1 1 1. 4 in. [102 mm] D802I_SVG 1 1. 2.5 in. [64 mm] Maximum length of 4 in. [102 mm] diameter rigid metal duct. 0 65 feet [19.8 m] 55 feet [16.8 m] 1 55 feet [16.8 m] 47 feet [14.3 m] 2 47 feet [14.3 m...

Page 14 - Natural Gas Altitude Adjustments; Table 3

1. Make certain your dryer is equipped for use with the type of gas in your laundry room. Dryer is equipped at the factory forNatural Gas with a 3/8 inch NPT gas connection. NOTE: The gas service to a gas dryer must conformwith the local codes and ordinances, or in the ab-sence of local codes and or...

Page 15 - Altitude; Table 4; Electric Dryer Only - Connect Electrical; Earth/Ground Information; Wire Length; Table 5; Connecting Power Cord with Three-Wire Plug

L.P. (Liquefied Petroleum) Gas, 2500 Btu/ft. 3 [93.1 MJ/m 3 ], serv- ice must be supplied at 10 ± 1.5 inch water column pressure. For proper operation at altitudes above 3000 feet [915 m] the L.P.gas valve spud orifice size must be reduced to ensure completecombustion. Refer to Table 4 . L.P. Altitu...

Page 16 - Figure 6

NOTE: Use COPPER WIRE only. Shorter than 15 ft. (4.5 m) – use 10 AWGLonger than 15 ft. (4.5 m) – use 8 AWG D816I_SVG L1 L2 L1 L2 15 16 5 2 2 3 4 8 9 1213 10 11 7 6 1 14 1. A typical 30-Amp Three-Wire Receptacle NEMA Type 10-30R 2. 120 ± 12 V.A.C. 3. 240 ± 12 V.A.C. 4. Intermediate Fuse Box (may be o...

Page 17 - Connecting Power Cord with Four-Wire Plug

D695I_SVG Figure 7 3. Use a strain relief and insert end of power cord through power supply hole. D696I_SVG Figure 8 4. Use the three screws from the accessories bag to attach the power cord wires to the terminal block. Refer to Figure 9 . 3-Wire Connection DRY2508N_SVG 4 3 2 1 1. "L1" Termi...

Page 18 - Reverse Door, if Desired; NOTE: Doors with windows cannot be reversed.

3. Remove earth/ground screw from earth/ground to neutral wire and save for use in Step 5. Earth/ground to neutral wire willbe attached to the neutral terminal in Step 6. DRY2468N_SVG 1 1. Earth/Ground Screw Figure 12 4. Use a strain relief and insert end of power cord through power supply hole. DRY...

Page 20 - Wipe Out Inside of Dryer; Connect to 30 Amp Circuit; Gas Dryer; When plugging in the dryer:

8. Using screwdriver, remove two door plugs, and reinstall on opposite side of door opening. DRY2503N_SVG Figure 22 9. Reinstall four hinge attaching screws, removed in Step 1. D606I_SVG Figure 23 Wipe Out Inside of Dryer Before using dryer for the first time, use an all-purpose clean-er, or a deter...

Page 21 - Plug Cord Into Separately Fused 15 Amp Circuit; Recheck Steps; Electric Dryers

The dryer is designed to be operated on a separate branch, polar-ized, three-wire, effective earth/ground, 120 Volt, 60 Hertz, AC(alternating current) circuit protected by a 15 Ampere fuse,equivalent fusetron or circuit breaker. The three-prong earth/ground plug on the power cord should beplugged di...

Page 22 - Shut-off Valve Only Applicable on Certain Models

IMPORTANT: This operation is to be conducted byqualified personnel only. 1. To view the burner flame, remove the lower front panel of the dryer. 2. Close the loading door and start the dryer in a heat setting (re- fer to the operation instructions). The dryer will start, the ig-niter will glow red a...

Page 23 - Fast Track for Installing the Dryer

Installer Checklist Fast Track for Installing the Dryer 1 Position and Levelthe Dryer. DRY2634N_SVG 5 Reverse Door, if De-sired. DRY2052N_SVG1 CHECK CHECK 2 Connect Dryer ExhaustSystem. DRY2501N_SVG1 6 Wipe Out Inside ofDryer. DRY2504N_SVG1 CHECK CHECK 3 GAS ONLY• Connect Gas Sup- ply Pipe. • Check ...

Speed Queen ADEE9BGS173TW01 - Installation Manual

Table of Contents:

Other Manuals for Speed Queen ADEE9BGS173TW01

Summary

Other Speed Queen Models