Page 2 - Table of Content
Table of Content SAFETY INFORMATION...................................................................... 1 INTRODUCTION................................................................................... 1 Configuration with a Single Computer ............................................................
Page 3 - Safety Information; Use only the power adapter provided; Introduction; A cable modem Internet service from a cable television company; Configuration with a Single Computer
SOYO G668 Ethernet IP Phone User Guide 1 Safety Information The SOYO IP Phone has been tested and approved by the highest standards of safety regulations. However safety is your responsibility too. Use only the power adapter provided Do not disassemble this product without guidance, no serviceab...
Page 4 - Note; Configuration within a Home or Office Network
SOYO G668 Ethernet IP Phone User Guide 2 Note : Some Internet Service Providers provide only one public IP address. Therefore the computer and the IP phone can not be online at the same time. Please refer to the following configuration. Configuration within a Home or Office Network You can connect G...
Page 5 - Package Contents; One SOYO G668 IP phone
SOYO G668 Ethernet IP Phone User Guide 3 User Manual Power Adapter Ethernet RJ-45 Cable SOYO G668 IP phone Package Contents Make sure the following contents are included in the G668 IP phone package: One SOYO G668 IP phone One DC 7.5V 0.45A Power Adapter User Manual One Ethernet RJ-45 Cable
Page 6 - Front Panel of SOYO G668 IP phone
SOYO G668 Ethernet IP Phone User Guide 4 Front Panel of SOYO G668 IP phone
Page 8 - Rear Side of SOYO G668 IP phone
SOYO G668 Ethernet IP Phone User Guide 6 Rear Side of SOYO G668 IP phone
Page 9 - Installation; Installation with a Single Computer; Connect one end of the Ethernet RJ-45 cable to the broadband modem,
SOYO G668 Ethernet IP Phone User Guide 7 Installation Depending on your network environment, you will need to perform one of the following installations: Installation with a Single Computer Installation with a Home or Office Network Installation with a Single Computer Note : Some Internet Service Pr...
Page 10 - If “Ready for Calls” appears on the LCD screen as shown above, your IP
SOYO G668 Ethernet IP Phone User Guide 8 Booting … È DHCP Connecting … È Ready For Calls SOYO_Group 5. If “Ready for Calls” appears on the LCD screen as shown above, your IP phone is ready to use. Now you can pick up the hand set and start making phone calls. Important: It may take about 20 seconds ...
Page 11 - Installation within a Home or Office Network; Connect one end of the Ethernet RJ-45 cable to an open Ethernet LAN
SOYO G668 Ethernet IP Phone User Guide 9 Installation within a Home or Office Network 1. Connect one end of the Ethernet RJ-45 cable to an open Ethernet LAN port on your router, and connect the other end of the cable to the WAN port at the rear of the G668 IP phone. 2. Using another RJ-45 cable, you...
Page 12 - to use. Now you can pick up the hand set and start making phone calls.
SOYO G668 Ethernet IP Phone User Guide 10 5. If “Ready for Calls” appears on the LCD as above, your IP phone is ready to use. Now you can pick up the hand set and start making phone calls. 6. If you still have problems logging on, please refer to “Troubleshooting” on page 20. If problem persist then...
Page 13 - Configuration via IP Phone Keypad; Entering Configuration Mode; This is a list of functions corresponding to the “keys”.
SOYO G668 Ethernet IP Phone User Guide 11 Configuration via IP Phone Keypad Configuration for DHCP (default) The SOYO-G668’s default setting is set on DHCP enabled. If you have a router with DHCP support, or if you connect the IP phone directly to the cable modem with dynamic IP address from the ISP...
Page 14 - Configuration for PPPoE; LCD SCREEN INSTRUCTION; Configuration for Static IP
SOYO G668 Ethernet IP Phone User Guide 12 Configuration for PPPoE This setting is for users using DSL modem without a router. You will need the username and password from you ISP to setup your IP phone. Please make sure you have entered the “networking settings” before proceeding. LCD SCREEN INSTRUC...
Page 15 - Warning
SOYO G668 Ethernet IP Phone User Guide 13 LCD SCREEN INSTRUCTION network settings Press Speaker ip type 1 [DHCP] Press Local IP , then 0 , then Speaker ip type 2 [PPPoE] Press Volume+ , until you see “ip” ip Press Local IP , input your static IP and press Speaker , then press Volume+ until you see “...
Page 16 - Configuration via Web Browser; Network Settings; iptype
SOYO G668 Ethernet IP Phone User Guide 14 Configuration via Web Browser First find out the IP address of the phone by pressing the Local IP button on the keypad of the phone. Then on a PC connected to the IP phone or at the same n e tw o r k segment of the IP phone, o pen the IE browser. Input the I...
Page 17 - Protocol Settings
SOYO G668 Ethernet IP Phone User Guide 15 dhcp : Select this item to enable DHCP mode. With this system, your LAN or router automatically assigns all the required network parameters to any device connected to it when the device log on. So, if your LAN or router is configured to use DHCP addressing, ...
Page 18 - Phone Settings
SOYO G668 Ethernet IP Phone User Guide 16 nat addr: The NAT IP address required by certain type of traversal method. phone number: Virtual IP phone number, the caller ID that will show up on the recipient’s IP phone. account: H.323 ID of the IP phone. rtp port: RTP port is the port transferring and ...
Page 19 - Other Settings
SOYO G668 Ethernet IP Phone User Guide 17 Note: Some VoIP providers do not provide call forwarding function. Other Settings password: Set the password of the phone setting. (Default password is 1234). upgrade addr: Enter IP address or domain name of the FTP server supplying the update programs. Chec...
Page 20 - button at the bottom of the screen. Make sure click the
SOYO G668 Ethernet IP Phone User Guide 18 In this page, you can set and save the speed dial number by typing the name into the Name field and then entering the corresponding number following the name. For example, input “ Tom” in Name field following 001, and then input the number, 14081234567 into ...
Page 21 - Software Upgrading; The upgrading process may not start if you already have the latest
SOYO G668 Ethernet IP Phone User Guide 19 Software Upgrading Users can upgrade SOYO G668 IP phone to the latest software version by the following procedure: make sure the upgrade address has been entered into the setting page correctly, then from keypad dial “Hand-free Speaker”, input “12348” and th...
Page 22 - Troubleshooting; ISSUE
SOYO G668 Ethernet IP Phone User Guide 20 Troubleshooting ISSUE SOLUTION LCD reads: “wait logon…” or “logon failed” Press Local IP button to find the IP address of your IP phone. If it shows 0.0.0.0, it means the Internet connection is down, please check the LAN cable and modem. If you are connectin...
Page 24 - Appendix: Port Forwarding; and your IP phone do not function correctly.
SOYO G668 Ethernet IP Phone User Guide 22 Appendix: Port Forwarding Note: Try port forwarding only when you have router or firewall in your network and your IP phone do not function correctly. Applications running on TCP/IP open connections to other computers or Internet devices using something call...
