Sonance MR1 - Manual
Sonance MR1 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
+ 1 2 V D C
GND
STATUS
SIGNAL
EMITTERS
PWR
IR
RCVR
CB1
ONE ZONE
CONNECTING BLOCK
MR1
IR Receiver
Red (or white)
Stripe
120 V AC
(Unswitched)
CB1
Connecting Block
PS1
Power Supply
E1
Emitter
E1
Emitter
E1
Emitter
REMOTE ROOM
MAIN ROOM
Hand Held
Remote
3-Terminal Block (supplied)
7/16"
2-1/8"
3-Conductor
Inter-room Cable
(unshielded OK)
OUT
+12V
GND
7 Foot Ribbon Cable
Satellite Receiver
AV
Receiver
DVD
I R P h o t o d i o d e
T a l k b a c k L E D
The MR1 IR receiver has been designed for mounting in very small spaces. It may be mounted
under shelf edges, cabinet ledges, etc. – anywhere an inconspicuous appearance is desired.
The high sensitivity of these receivers allows reception of IR commands up to 25 feet away.
FEATURES
• Very small package.
• Works in a standard 3-wire system.
• System talk-back LED.
• Includes 3-Terminal Block for easy extension of 18" ribbon cable.
• 12 units may be powered by one
PS1
power supply.
• Has a 7 Foot, three-conductor ribbon cable with stripped and tinned ends.
• Circuitry contained in a shielded chassis.
SPECIFICATIONS
• Infrared carrier frequency bandwidth: 30 - 100 kHz.
• Reception range: up to 25 feet.
• Nominal reception angle: + 55 degrees off axis.
• Cable requirements: 3-conductor, 24 to 18 gauge (unshielded OK).
• Maximum transmission length: One mile using 18 gauge wire.
• Maximum current output: 100 mA.
• Maximum number of directly driven IR Emitters: 4 (8 if 4 E2 emitters are used).
• Dimensions: 7/16" x 5/16" x 2-1/8" (11.2mm x 8.5mm x 55mm).
• Power requirements: 12 volts DC @ 10 mA.
INSTALLATION
MR1
. These units are intended to be wired to the input terminals of Sonance Connecting
Blocks or other devices, using the supplied 3-terminal block in the remote room location. A 3-
conductor cable (24 gauge up to 200', 22 gauge up to 600', 20 gauge up to 2000', 18 gauge up
to 5000') is run to the main room. Connections are then made to a Sonance connecting block,
power supply, and emitters as shown in the following illustration of a typical basic system:
INSTALLATION INSTRUCTIONS
MR1
MICRO IR RECEIVER
Pg 1
MR1insMan.qxd 12/20/02 5:16 PM Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
