Sonance 93354 - User Manual

11.29.18

Installing the Driver after Drywall

and Paint

1. Remove the four screws that attach the cover plate to

the enclosure (see Figure 1).

2. Connect the internal speaker wire to the woofer driver.

Connect the RED wire to the positive terminal and the

BLACK wire to the negative terminal. If using multiple

subwoofers it is critical that the polarity of all the

woofers is the same (see Figure 2).

Box Contents

(1) Quickstart Guide
(1) Reference NC driver (R10SUB or R12SUB)
(1) Grille mounting frame
(1) Grille
(12) M3.5 * 25mm Flat Head Phillips Wood Screws

for mounting the frame

(12) M3.5 * 45mm Flat Head Phillips Wood

Screws for mounting the frame
(12) M5 * 18mm Phillips Machine Screws for

mounting the driver

NOTE: R10SUB AND R12SUB REQUIRE USE OF SONANCE

R10SUB ENC AND R12SUB ENC, RESPECTIVELY.

Figure 2: Connecting the Wire

3. Install the grille on to the grille mounting frame.

The powerful Neodymium magnets will attract the

grille very quickly. Care should be taken to align the

grille correctly before placing it close to the grille

mounting frame (see Figure 5).

3. Attach the woofer driver to the enclosure using the

twelve Phillips head screws.

Figure 4: Attaching the Grille Mounting Frame

Figure 3: Tighten All 12 Screws

Figure 1: Removing the Cover Plate

Installing the Grille and Frame

1. Attach the grille mounting frame to the enclosure

using the twelve Phillips head screws (see Figure 4).

2. Tighten all the screws evenly so the grille mounting

frame is flush with the wall at all points around

the perimeter.

Figure 5: Grille Installation

33-7913

4. Tighten all twelve screws evenly to minimize any air

leakage that could occur (see Figure 3).

NOTE: SHORTER SCREWS ARE FOR SINGLE DRYWALL, LONGER SCREWS

ARE FOR DOUBLE DRYWALL

Sonance warrants to the first end-user purchaser that this Sonance-brand product, when purchased from an authorized Sonance Dealer/Distributor, will be free from defective workmanship and

materials for Five (5) Years from the date on the original sales receipt or invoice or other satisfactory proof of purchase. Sonance will at its option and expense during the warranty period, either

repair the defect or replace the Product with a new or remanufactured Product or a reasonable equivalent.

©2017 Sonance. All rights reserved. Sonance is a registered trademark of Dana Innovations. Due to continuous product improvement, all features and specifications are subject to change

without notice. For the latest Sonance product specification information visit our website: www.sonance.com

SONANCE • 991 Calle Amanecer • San Clemente, CA 92673 USA(949) 492-7777 • FAX: (949) 361-5151 • Technical Support: (949) 492-7777

R10SUB | R12SUB QUICKSTART GUIDE

REFERENCE IN-WALL SUBWOOFERS