SoleusAir SG-PAC-12E1HP- User Manual

Page 3 - SPECIFICATIONS; Air Conditioner mode operates up to an ambient temperature of 95; PACKAGE CONTENTS; Model; Refrigerant Type

3 SPECIFICATIONS • The cooling capacity is measured at an ambient temperature of DB 86 °F, WB 78 °F. • Noise level is measured at a distance of 3.28 ft away from the front of the unit, when the unit is in cooling mode. • Power consumption is measured when the fan runs at the highest speed setting. •...

Page 4 - LCDI POWER CORD AND PLUG; The TEST and RESET buttons should not be used as; RESET

LCDI POWER CORD AND PLUG This air conditioner is equipped with an LCDI (Leakage Current Detection and Interruption) power cord and plug as required by US National Electric Code 440.65. This cord consists of a length of shielded flexible cord with no termination on the load side and a LCDI attachment...

Page 5 - PRODUCT DIAGRAM

PRODUCT DIAGRAM Control Panel 5 Carry Handle Air Outlet & Louvers Power Cord Upper Air Intake Lower Air Intake Air Exhaust Vent Filter Location

Page 6 - PARTS & WINDOW KIT ASSEMBLY; PARTS; Extend both ends of the exhaust hose approximately 6 inches.

PARTS & WINDOW KIT ASSEMBLY PARTS EXHAUST HOSE & ADAPTERS ASSEMBLY & INSTALLATION INSTALLATION When the unit is operating as an air conditioner or dehumidifier, the window kit and exhaust hose must be installed. When the unit is operating in fan mode, the window kit and exhaust hose do n...

Page 7 - SINGLE HOSE WINDOW KIT INSTALLATION; This installation is OK

7 SINGLE HOSE WINDOW KIT INSTALLATION When installing the exhaust hose, try and keep it as flat as possible. The less angles and bends in the hose, the better the unit will perform. If bending or an angle is necessary, use single 90 ° angles like the pictures above. Multiple bends will decrease perf...

Page 8 - CONTROL PANEL

CONTROL PANEL SG-PAC-12E1 SG-PAC-12E1HP MODE BUTTON TEMP SELECT BUTTONS POWER BUTTON 8 BUCKET FULL LIGHT COOL MODE LIGHT DRY MODE LIGHT FAN MODE LIGHT LED DISPLAY MODE BUTTON TEMP SELECT BUTTONS POWER BUTTON COOL MODE LIGHT HEAT MODE LIGHT FAN MODE LIGHT LED DISPLAY DRY MODE LIGHT

Page 9 - CONTROL PANEL FUNCTIONS; CONTROL PANEL OPERATING INSTRUCTIONS

CONTROL PANEL FUNCTIONS 9 CONTROL PANEL OPERATING INSTRUCTIONS 1) Power On and Off - Press the POWER button once to manually turn the unit on. Press the POWER button once more to turn the unit off. 2) Mode Selection - Press the MODE Button repeatedly to cycle between the different modes: Air Conditi...

Page 10 - REMOTE CONTROL OPERATING INSTRUCTIONS; NOTE

10 REMOTE CONTROL OPERATING INSTRUCTIONS Press the ON/OFF (POWER) button once to manually turn the unit on. Press the Power button once more to turn the unit off. NOTE : Heat Mode is only available on SG-PAC-12E1HP Press the MODE Button repeatedly to cycle between the different modes. When the unit ...

Page 11 - TURBO BUTTON; TIMER BUTTON; TEMP BUTTON

11 REMOTE CONTROL OPERATING INSTRUCTIONS The Health Function is not available on this unit. Press the TEMP button to display the current set tem-perature or the actual room temperature. With each press of the TEMP button the display will cycle back and forth. Auto-on Timer: When the air conditioner ...

Page 12 - ture will increase another 2; SLEEP BUTTON

LIGHT 12 REMOTE CONTROL OPERATING INSTRUCTIONS In Cooling or Dehumidifier (DRY) modes: When sleep mode is selected the set temperature will automatically increase 2 ° F after 1 hour. After 2 hours, the set tempera- ture will increase another 2 ° F for a total increase of 4 ° F. Press the LIGHT butto...

Page 13 - MAINTENANCE; Clean or replace filter; recommended to clean the filter once every two weeks, or as needed.; Clean the unit Housing; ) Clean the surface with a damp cloth and dry it with a soft towel.; DISCLAIMER

MAINTENANCE Note: Make sure power is off and the power cord is not plugged into an electrical outlet prior to performing any maintenance on the unit. Clean or replace filter - If the air filter is blocked with a dust, the airflow volume may decrease. It is recommended to clean the filter once every ...

Page 14 - TROUBLESHOOTING; The Remote Control is not working

PROBLEM The Air Conditioner will not start POSSIBLE CAUSES The air conditioner is unplugged or not connected well. The fuse is blown/circuit breaker is tripped. Power Failure The current interrupter device is tripped. SOLUTIONS • Make sure the air conditioner plug is pushed completely into the out-l...

Page 15 - The LCD Display is showing “H8”; Drain the water tank

PROBLEM The LCD Display is showing “E5” POSSIBLE CAUSES Low Voltage Protection SOLUTIONS • Unplug for 10 minutes and then turn on the unit. If “E5” is still dis-played, contact customer service. TROUBLESHOOTING (CONT.) The LCD Display is showing “H8” The backup water tank is full • Drain the water t...

Page 16 - WARRANTY; THIS WARRANTY DOES NOT COVER:; Freight and Insurance cost for the warranty service.; For Technical Support & Warranty Service

WARRANTY One Year Limited Warranty Soleus International Inc. warrants the accompanying Soleus Air Powered by Gree Portable Air Conditioner to be free of defects in material and workmanship for the applications specified in its operation instruction for a period of ONE (1) year from the date of origi...

SoleusAir SG-PAC-12E1HP- User Manual

Table of Contents:

Other Manuals for SoleusAir SG-PAC-12E1HP

Summary

Other SoleusAir Models